/* SPDX-License-Identifier: GPL-2.0-only */ #include #include #include #include #include #include #include #include #include #include "ec.h" #include #include "onboard.h" void fill_lb_gpios(struct lb_gpios *gpios) { struct lb_gpio chromeos_gpios[] = { /* Lid Switch: Virtual switch */ {-1, ACTIVE_HIGH, get_lid_switch(), "lid"}, /* Power Button: Virtual switch */ /* Hard-code value to de-asserted */ {-1, ACTIVE_HIGH, 0, "power"}, /* Was VGA Option ROM loaded? */ /* -1 indicates that this is a pseudo GPIO */ {-1, ACTIVE_HIGH, gfx_get_init_done(), "oprom"}, /* EC is in RW mode when it isn't in recovery mode. */ {-1, ACTIVE_HIGH, !get_recovery_mode_switch(), "ec_in_rw"} }; lb_add_gpios(gpios, chromeos_gpios, ARRAY_SIZE(chromeos_gpios)); } int get_write_protect_state(void) { return !get_gpio(GPIO_SPI_WP); } int get_lid_switch(void) { /* hard-code to open */ return 1; } /* * The recovery-switch is virtual on Stout and is handled via the EC. * Stout recovery mode is only valid if RTC_PWR_STS is set and the EC * indicated the recovery keys were pressed. We use a global flag for * rec_mode to be used after RTC_POWER_STS has been cleared. * Note, rec_mode is the only time the EC is in RO mode, otherwise, RW. */ int get_recovery_mode_switch(void) { static int ec_in_rec_mode; static int ec_rec_flag_good; if (ec_rec_flag_good) return ec_in_rec_mode; const pci_devfn_t dev = PCI_DEV(0, 0x1f, 0); u8 reg8 = pci_s_read_config8(dev, GEN_PMCON_3); u8 ec_status = ec_read(EC_STATUS_REG); printk(BIOS_SPEW,"%s: EC status:%#x RTC_BAT: %x\n", __func__, ec_status, reg8 & RTC_BATTERY_DEAD); ec_in_rec_mode = (((reg8 & RTC_BATTERY_DEAD) != 0) && ((ec_status & 0x3) == EC_IN_RECOVERY_MODE)); ec_rec_flag_good = 1; return ec_in_rec_mode; } static const struct cros_gpio cros_gpios[] = { CROS_GPIO_REC_AH(CROS_GPIO_VIRTUAL, CROS_GPIO_DEVICE_NAME), CROS_GPIO_WP_AL(GPIO_SPI_WP, CROS_GPIO_DEVICE_NAME), }; DECLARE_CROS_GPIOS(cros_gpios);