config BOARD_PURISM_BASEBOARD_LIBREM_JSL
	def_bool n
	select BOARD_ROMSIZE_KB_16384
	select DRIVERS_GENERIC_CBFS_SERIAL
	select DRIVERS_USB_ACPI
	select DRIVERS_I2C_GENERIC
	select DRIVERS_I2C_HID
	select EC_ACPI
	select HAVE_ACPI_RESUME
	select HAVE_ACPI_TABLES
	select HAVE_SPD_IN_CBFS
	select INTEL_GMA_HAVE_VBT
	select NO_UART_ON_SUPERIO
	select SOC_INTEL_COMMON_BLOCK_HDA_VERB
	select SOC_INTEL_JASPERLAKE
	select SYSTEM_TYPE_DETACHABLE
	select USE_LEGACY_8254_TIMER

config BOARD_PURISM_LIBREM_11
	select BOARD_PURISM_BASEBOARD_LIBREM_JSL

if BOARD_PURISM_BASEBOARD_LIBREM_JSL

config MAINBOARD_DIR
	default "purism/librem_jsl"

config MAINBOARD_FAMILY
	string
	default "Librem 11" if BOARD_PURISM_BASEBOARD_LIBREM_JSL

config MAINBOARD_PART_NUMBER
	default "Librem 11" if BOARD_PURISM_BASEBOARD_LIBREM_JSL

config MAX_CPUS
	int
	default 4

config CBFS_SIZE
	default 0x700000 if BOARD_PURISM_BASEBOARD_LIBREM_JSL

config DIMM_MAX
	default 2

config DIMM_SPD_SIZE
	default 512

config VGA_BIOS_ID
	string
	default "8086,4e61" if BOARD_PURISM_BASEBOARD_LIBREM_JSL

config NO_POST
	default y

config INTEL_GMA_VBT_FILE
	default "src/mainboard/purism/librem_jsl/data.vbt"

config ENABLE_UART2
	bool "Enable UART2 debug output"
	default n
	select INTEL_LPSS_UART_FOR_CONSOLE
	help
	  Enable UART2 for debug output.

	  This UART can be used for boot logging by coreboot and payloads.

	  For Linux, boot with `console=uart,mmio32,0xfe032000,115200n8`.
	  (0xfe032000 is CONSOLE_UART_BASE_ADDRESS for Jasper Lake.)  Blacklist
	  intel_lpss_pci so it does not reconfigure the UART.

	  Soldering is required to access these signals.  On the reverse side of
	  the board, there are two test points directly underneath the SoC (the
	  only two test points between the heatsink screw holes).  The pad
	  nearest the M.2 socket is TX, the other is RX.  The signals are 3.3V
	  (do NOT connect directly to an RS-232 serial port).

config UART_FOR_CONSOLE
	default 2 if ENABLE_UART2

config FSP_TEMP_RAM_SIZE
	default 0x28000

endif