/* SPDX-License-Identifier: GPL-2.0-only */ #include #include #include #include #include #include __weak void mtk_wdt_clr_status(void) { /* do nothing */ } __weak void mtk_wdt_set_req(void) { /* do nothing */ } static inline void mtk_wdt_swreset(void) { /* * We trigger a secondary reset by triggering WDT hardware to send the * signal to EC. * We do not use do_board_reset() to send the signal to EC which is * controlled by software driver. * Before triggering the secondary reset, clean the data cache so the * logs in cbmem console (either in SRAM or DRAM) can be flushed. */ printk(BIOS_INFO, "%s() called!\n", __func__); dcache_clean_all(); setbits32(&mtk_wdt->wdt_mode, MTK_WDT_MODE_EXTEN | MTK_WDT_MODE_KEY); write32(&mtk_wdt->wdt_swrst, MTK_WDT_SWRST_KEY); halt(); } int mtk_wdt_init(void) { uint32_t wdt_sta; mtk_wdt_set_req(); /* Writing mode register will clear status register */ wdt_sta = read32(&mtk_wdt->wdt_status); mtk_wdt_clr_status(); printk(BIOS_INFO, "WDT: Status = %#x\n", wdt_sta); printk(BIOS_INFO, "WDT: Last reset was "); if (!wdt_sta) { printk(BIOS_INFO, "cold boot\n"); } else { if (wdt_sta & MTK_WDT_STA_HW_RST) printk(BIOS_INFO, "hardware watchdog\n"); else if (wdt_sta & MTK_WDT_STA_SW_RST) printk(BIOS_INFO, "normal software reboot\n"); else if (wdt_sta & MTK_WDT_STA_SPM_RST) printk(BIOS_INFO, "SPM reboot\n"); else printk(BIOS_INFO, "other reset type: %#.8x\n", wdt_sta); mark_watchdog_tombstone(); mtk_wdt_swreset(); } /* Config watchdog reboot mode: * Clearing bits: * DUAL_MODE & IRQ: trigger reset instead of irq then reset. * EXT_POL: select watchdog output signal as active low. * ENABLE: disable watchdog on initialization. * Setting bit EXTEN to enable watchdog output. */ clrsetbits32(&mtk_wdt->wdt_mode, MTK_WDT_MODE_DUAL_MODE | MTK_WDT_MODE_IRQ | MTK_WDT_MODE_EXT_POL | MTK_WDT_MODE_ENABLE, MTK_WDT_MODE_EXTEN | MTK_WDT_MODE_KEY); return wdt_sta; }