1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
|
#include <stdint.h>
#include <string.h>
#include <device/pci_def.h>
#include <device/pci_ids.h>
#include <arch/io.h>
#include <device/pnp_def.h>
#include <pc80/mc146818rtc.h>
#include <console/console.h>
#include <cpu/amd/model_fxx_rev.h>
#include "southbridge/amd/amd8111/early_smbus.c"
#include <reset.h>
#include "northbridge/amd/amdk8/raminit.h"
#include "northbridge/amd/amdk8/reset_test.c"
#include "cpu/x86/bist.h"
#include "lib/delay.c"
#include "northbridge/amd/amdk8/debug.c"
#include <cpu/amd/mtrr.h>
#include <superio/winbond/common/winbond.h>
#include <superio/winbond/w83627hf/w83627hf.h>
#include "northbridge/amd/amdk8/setup_resource_map.c"
#include "southbridge/amd/amd8111/early_ctrl.c"
#define SERIAL_DEV PNP_DEV(0x2e, W83627HF_SP1)
static void memreset_setup(void)
{
//GPIO on amd8111 to enable MEMRST ????
outb((1<<2)|(1<<0), SMBUS_IO_BASE + 0xc0 + 16); //REVC_MEMRST_EN=1
outb((1<<2)|(0<<0), SMBUS_IO_BASE + 0xc0 + 17);
}
static void memreset(int controllers, const struct mem_controller *ctrl) { }
static inline void activate_spd_rom(const struct mem_controller *ctrl)
{
#define SMBUS_HUB 0x18
int ret,i;
unsigned device=(ctrl->channel0[0])>>8;
/* the very first write always get COL_STS=1 and ABRT_STS=1, so try another time*/
i=2;
do {
ret = smbus_write_byte(SMBUS_HUB, 0x01, device);
} while ((ret!=0) && (i-->0));
smbus_write_byte(SMBUS_HUB, 0x03, 0);
}
static inline int spd_read_byte(unsigned device, unsigned address)
{
return smbus_read_byte(device, address);
}
#include "northbridge/amd/amdk8/amdk8.h"
#include "northbridge/amd/amdk8/incoherent_ht.c"
#include "northbridge/amd/amdk8/coherent_ht.c"
#include "northbridge/amd/amdk8/raminit_f.c"
#include "lib/generic_sdram.c"
#include "resourcemap.c"
#include "cpu/amd/dualcore/dualcore.c"
#include <spd.h>
#include "cpu/amd/model_fxx/init_cpus.c"
#include "cpu/amd/model_fxx/fidvid.c"
#define RC0 ((1<<0)<<8)
#define RC1 ((1<<1)<<8)
#define RC2 ((1<<2)<<8)
#define RC3 ((1<<3)<<8)
void cache_as_ram_main(unsigned long bist, unsigned long cpu_init_detectedx)
{
static const uint16_t spd_addr[] = {
//first node
RC0|DIMM0, RC0|DIMM2, 0, 0,
RC0|DIMM1, RC0|DIMM3, 0, 0,
#if CONFIG_MAX_PHYSICAL_CPUS > 1
//second node
RC1|DIMM0, RC1|DIMM2, RC1|DIMM4, RC1|DIMM6,
RC1|DIMM1, RC1|DIMM3, RC1|DIMM5, RC1|DIMM7,
#endif
#if CONFIG_MAX_PHYSICAL_CPUS > 2
// third node
RC2|DIMM0, RC2|DIMM2, 0, 0,
RC2|DIMM1, RC2|DIMM3, 0, 0,
// four node
RC3|DIMM0, RC3|DIMM2, RC3|DIMM4, RC3|DIMM6,
RC3|DIMM1, RC3|DIMM3, RC3|DIMM5, RC3|DIMM7,
#endif
};
struct sys_info *sysinfo = &sysinfo_car;
int needs_reset;
unsigned bsp_apicid = 0;
#if CONFIG_SET_FIDVID
struct cpuid_result cpuid1;
#endif
if (bist == 0)
bsp_apicid = init_cpus(cpu_init_detectedx, sysinfo);
winbond_enable_serial(SERIAL_DEV, CONFIG_TTYS0_BASE);
console_init();
// dump_mem(CONFIG_DCACHE_RAM_BASE+CONFIG_DCACHE_RAM_SIZE-0x200, CONFIG_DCACHE_RAM_BASE+CONFIG_DCACHE_RAM_SIZE);
/* Halt if there was a built in self test failure */
report_bist_failure(bist);
printk(BIOS_DEBUG, "*sysinfo range: [%p,%p]\n",sysinfo,sysinfo+1);
setup_mb_resource_map();
#if 0
dump_pci_device(PCI_DEV(0, 0x18, 0));
dump_pci_device(PCI_DEV(0, 0x19, 0));
#endif
print_debug("bsp_apicid="); print_debug_hex8(bsp_apicid); print_debug("\n");
set_sysinfo_in_ram(0); // in BSP so could hold all ap until sysinfo is in ram
setup_coherent_ht_domain(); // routing table and start other core0
wait_all_core0_started();
#if CONFIG_LOGICAL_CPUS
// It is said that we should start core1 after all core0 launched
/* becase optimize_link_coherent_ht is moved out from setup_coherent_ht_domain,
* So here need to make sure last core0 is started, esp for two way system,
* (there may be apic id conflicts in that case)
*/
start_other_cores();
wait_all_other_cores_started(bsp_apicid);
#endif
/* it will set up chains and store link pair for optimization later */
ht_setup_chains_x(sysinfo); // it will init sblnk and sbbusn, nodes, sbdn
#if 0
//it your CPU min fid is 1G, you can change HT to 1G and FID to max one time.
needs_reset = optimize_link_coherent_ht();
needs_reset |= optimize_link_incoherent_ht(sysinfo);
#endif
#if CONFIG_SET_FIDVID
/* Check to see if processor is capable of changing FIDVID */
/* otherwise it will throw a GP# when reading FIDVID_STATUS */
cpuid1 = cpuid(0x80000007);
if ((cpuid1.edx & 0x6) == 0x6) {
{
/* Read FIDVID_STATUS */
msr_t msr;
msr=rdmsr(0xc0010042);
print_debug("begin msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\n");
}
enable_fid_change();
enable_fid_change_on_sb(sysinfo->sbbusn, sysinfo->sbdn);
init_fidvid_bsp(bsp_apicid);
// show final fid and vid
{
msr_t msr;
msr=rdmsr(0xc0010042);
print_debug("end msr fid, vid "); print_debug_hex32( msr.hi ); print_debug_hex32(msr.lo); print_debug("\n");
}
} else {
print_debug("Changing FIDVID not supported\n");
}
#endif
#if 1
needs_reset = optimize_link_coherent_ht();
needs_reset |= optimize_link_incoherent_ht(sysinfo);
// fidvid change will issue one LDTSTOP and the HT change will be effective too
if (needs_reset) {
print_info("ht reset -\n");
soft_reset_x(sysinfo->sbbusn, sysinfo->sbdn);
}
#endif
allow_all_aps_stop(bsp_apicid);
//It's the time to set ctrl in sysinfo now;
fill_mem_ctrl(sysinfo->nodes, sysinfo->ctrl, spd_addr);
enable_smbus();
#if 0
int i;
for(i=0;i<4;i++) {
activate_spd_rom(&cpu[i]);
dump_smbus_registers();
}
#endif
memreset_setup();
//do we need apci timer, tsc...., only debug need it for better output
/* all ap stopped? */
// init_timer(); // Need to use TMICT to synconize FID/VID
sdram_initialize(sysinfo->nodes, sysinfo->ctrl, sysinfo);
#if 0
print_pci_devices();
#endif
#if 0
// dump_pci_devices();
dump_pci_device_index_wait(PCI_DEV(0, 0x18, 2), 0x98);
dump_pci_device_index_wait(PCI_DEV(0, 0x19, 2), 0x98);
#endif
post_cache_as_ram(); // bsp swtich stack to ram and copy sysinfo ram now
}
|
