flashchips: port S25FS(128S) chip from chromiumos

This may seem too big just to support yet another flash chip, but in
reality it brings support for whole new family of S25FS
Spansion/Cypress flash chips. These chips require handling of some
special status registers for erasing or writing, with very specific
timing checks in place.

For example, WIP status bit will remain being set to 1 if erase or
programming errors occur, and in that case chip 'software reset' has
to be performed otherwise the chip will remain unresponsive to all
further commands. Also, special CR3NV register (Configuration Register
3 Nonvolatile) status bits needs to be read and set by using RDAR
(ReaD Any Register) and WRAR (WRite Any Register) OP commands, and
these states are needed to determine which type of reset feature is
enabled at the time (legacy or S25FS type) in the first place,
determine whether Uniform or Hybrid sector architecture is used
at the time, or set programming buffer address wrap point (256 or 512
bytes). Furthermore, S25FS chip status register has to be restored to
its original state (hence that ugly CHIP_RESTORE_CALLBACK) following
erasing or writing, failing to do so may result in host being unable
to access data on the chip at all.

Finally, although this brings support for the whole family of chips,
I only have one such chip to do the actual testing, S25FS128S (Small
Sectors), which I had fully tested on ch341a and FT4232H programmers,
with confirmed working probe, read, erase and write.

Full summary of changes are here:

flashchips:
  add new flashchip sctructure property:
    .reset
  add chip definitions:
    S25FS128S Large Sectors
    S25FS128S Small Sectors

flash:
  add macro (chip_restore_func_data call-back):
    CHIP_RESTORE_CALLBACK

flashrom:
  add struct:
    chip_restore_func_data
  add call-back function:
    register_chip_restore

spi:
  add OP codes:
    CMD_RDAR, CMD_WRAR, CMD_WRAR_LEN, CMD_RSTEN, CMD_RST
  add register bit function definitions:
    CR3NV_ADDR, CR3NV_20H_NV
  add timers:
    T_W, T_RPH, T_SE

spi25:
  refactor (based on chromiumos implementation) function:
    spi_poll_wip
  port these functions from chromiumos:
    probe_spi_big_spansion
    s25fs_software_reset
    s25f_legacy_software_reset
    s25fs_block_erase_d8

spi25_statusreg:
  port these functions from chromiumos:
    spi_restore_status
    s25fs_read_cr
    s25fs_write_cr
    s25fs_restore_cr3nv

Most of the ported functions are originally from s25f.c found at
https://chromium.googlesource.com/chromiumos/third_party/flashrom
with exception of spi_restore_status which is defined in
spi25_statusreg.c. The rest of macros and OP codes are defined in
same files as in this commit.

Change-Id: If659290874a4b9db6e71256bdef382d31b288e72
Signed-off-by: Samir Ibradzic <sibradzic@gmail.com>
Reviewed-on: https://review.coreboot.org/c/flashrom/+/39822
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Edward O'Callaghan <quasisec@chromium.org>

1 files changed, 3 insertions, 0 deletions

diff --git a/flash.h b/flash.h
index 1a9bd9f07..1ee0f0fe3 100644
--- a/flash.h
+++ b/flash.h
@@ -54,6 +54,8 @@ typedef uintptr_t chipaddr;
 #define PRIxPTR_WIDTH ((int)(sizeof(uintptr_t)*2))
 
 int register_shutdown(int (*function) (void *data), void *data);
+#define CHIP_RESTORE_CALLBACK	int (*func) (struct flashrom_flashctx *flash, uint8_t status)
+int register_chip_restore(CHIP_RESTORE_CALLBACK, struct flashrom_flashctx *flash, uint8_t status);
 int shutdown_free(void *data);
 void *programmer_map_flash_region(const char *descr, uintptr_t phys_addr, size_t len);
 void programmer_unmap_flash_region(void *virt_addr, size_t len);
@@ -207,6 +209,7 @@ struct flashchip {
 		SPI_EDI = 1,
 	} spi_cmd_set;
 
+	int (*reset) (struct flashctx *flash);
 	int (*probe) (struct flashctx *flash);
 
 	/* Delay after "enter/exit ID mode" commands in microseconds.