diff options
Diffstat (limited to 'Documentation/serprog-protocol.txt')
| -rw-r--r-- | Documentation/serprog-protocol.txt | 4 |
1 files changed, 2 insertions, 2 deletions
diff --git a/Documentation/serprog-protocol.txt b/Documentation/serprog-protocol.txt index d58b8e98e..3d4aa1a9c 100644 --- a/Documentation/serprog-protocol.txt +++ b/Documentation/serprog-protocol.txt @@ -84,7 +84,7 @@ Additional information of the above commands: lower than the one requested. If there is no lower frequency available the lowest possible should be used. The value chosen is sent back in the reply with an ACK. - 0x15 (S_CMD_S_PIN_STATE): + 0x15 (S_PIN_STATE): Sets the state of the pin drivers connected to the flash chip. Disabling them allows other devices (e.g. a mainboard's chipset) to access the chip. This way the serprog controller can remain attached to the flash chip even when the board is running. The user is responsible to @@ -103,4 +103,4 @@ Additional information of the above commands: In addition, support for these commands is recommended: S_CMD_Q_PGMNAME, S_CMD_Q_BUSTYPE, S_CMD_Q_CHIPSIZE (if parallel). -See also serprog.h. +See also serprog.c |