| Commit message (Collapse) | Author | Age | Files | Lines |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
ecdsa_set_pub_key() makes an u64 pointer at 1 byte offset of the key.
This results in an unaligned u64 pointer. This pointer is passed to
ecc_swap_digits() which assumes natural alignment.
This causes a kernel crash on an armv7 platform:
[ 0.409022] Unhandled fault: alignment exception (0x001) at 0xc2a0a6a9
...
[ 0.416982] PC is at ecdsa_set_pub_key+0xdc/0x120
...
[ 0.491492] Backtrace:
[ 0.492059] [<c07c266c>] (ecdsa_set_pub_key) from [<c07c75d4>] (test_akcipher_one+0xf4/0x6c0)
Handle unaligned input buffer in ecc_swap_digits() by replacing
be64_to_cpu() to get_unaligned_be64(). Change type of in pointer to
void to reflect it doesn’t necessarily need to be aligned.
Fixes: 4e6602916bc6 ("crypto: ecdsa - Add support for ECDSA signature verification")
Reported-by: Guillaume Gardet <guillaume.gardet@arm.com>
Suggested-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Mian Yousaf Kaukab <ykaukab@suse.de>
Tested-by: Stefan Berger <stefanb@linux.ibm.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
|
|
|
|
|
|
|
| |
This function declaration has been added in 'ecc_curve.h',
delete it in 'crypto/ecc.h'.
Fixes: 4e6602916bc6(crypto: ecdsa - Add support for ECDSA ...)
Signed-off-by: Meng Yu <yumeng18@huawei.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|\
| |
| |
| | |
This pulls in the NIST P384/256/192 x509 changes.
|
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| | |
Add the math needed for NIST P384 and adapt certain functions'
parameters so that the ecc_curve is passed to vli_mmod_fast. This
allows to identify the curve by its name prefix and the appropriate
function for fast mmod calculation can be used.
Summary of changes:
* crypto/ecc.c
- add vli_mmod_fast_384
- change some routines to pass ecc_curve forward until vli_mmod_fast
* crypto/ecc.h
- add ECC_CURVE_NIST_P384_DIGITS
- change ECC_MAX_DIGITS to P384 size
Signed-off-by: Saulo Alessandre <saulo.alessandre@tse.jus.br>
Tested-by: Stefan Berger <stefanb@linux.ibm.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| |
| | |
Add support for parsing the parameters of a NIST P256 or NIST P192 key.
Enable signature verification using these keys. The new module is
enabled with CONFIG_ECDSA:
Elliptic Curve Digital Signature Algorithm (NIST P192, P256 etc.)
is A NIST cryptographic standard algorithm. Only signature verification
is implemented.
Cc: Herbert Xu <herbert@gondor.apana.org.au>
Cc: "David S. Miller" <davem@davemloft.net>
Cc: linux-crypto@vger.kernel.org
Signed-off-by: Stefan Berger <stefanb@linux.ibm.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|/
|
|
|
|
|
|
|
| |
Move 'ecc_get_curve' to 'include/crypto/ecc_curve.h', so everyone
in kernel tree can easily get ecc curve params;
Signed-off-by: Meng Yu <yumeng18@huawei.com>
Reviewed-by: Zaibo Xu <xuzaibo@huawei.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
After the generation of a local public key, SP800-56A rev 3 section
5.6.2.1.3 mandates a validation of that key with a full validation
compliant to section 5.6.2.3.3.
Only if the full validation passes, the key is allowed to be used.
The patch adds the full key validation compliant to 5.6.2.3.3 and
performs the required check on the generated public key.
Signed-off-by: Stephan Mueller <smueller@chronox.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Add Elliptic Curve Russian Digital Signature Algorithm (GOST R
34.10-2012, RFC 7091, ISO/IEC 14888-3) is one of the Russian (and since
2018 the CIS countries) cryptographic standard algorithms (called GOST
algorithms). Only signature verification is supported, with intent to be
used in the IMA.
Summary of the changes:
* crypto/Kconfig:
- EC-RDSA is added into Public-key cryptography section.
* crypto/Makefile:
- ecrdsa objects are added.
* crypto/asymmetric_keys/x509_cert_parser.c:
- Recognize EC-RDSA and Streebog OIDs.
* include/linux/oid_registry.h:
- EC-RDSA OIDs are added to the enum. Also, a two currently not
implemented curve OIDs are added for possible extension later (to
not change numbering and grouping).
* crypto/ecc.c:
- Kenneth MacKay copyright date is updated to 2014, because
vli_mmod_slow, ecc_point_add, ecc_point_mult_shamir are based on his
code from micro-ecc.
- Functions needed for ecrdsa are EXPORT_SYMBOL'ed.
- New functions:
vli_is_negative - helper to determine sign of vli;
vli_from_be64 - unpack big-endian array into vli (used for
a signature);
vli_from_le64 - unpack little-endian array into vli (used for
a public key);
vli_uadd, vli_usub - add/sub u64 value to/from vli (used for
increment/decrement);
mul_64_64 - optimized to use __int128 where appropriate, this speeds
up point multiplication (and as a consequence signature
verification) by the factor of 1.5-2;
vli_umult - multiply vli by a small value (speeds up point
multiplication by another factor of 1.5-2, depending on vli sizes);
vli_mmod_special - module reduction for some form of Pseudo-Mersenne
primes (used for the curves A);
vli_mmod_special2 - module reduction for another form of
Pseudo-Mersenne primes (used for the curves B);
vli_mmod_barrett - module reduction using pre-computed value (used
for the curve C);
vli_mmod_slow - more general module reduction which is much slower
(used when the modulus is subgroup order);
vli_mod_mult_slow - modular multiplication;
ecc_point_add - add two points;
ecc_point_mult_shamir - add two points multiplied by scalars in one
combined multiplication (this gives speed up by another factor 2 in
compare to two separate multiplications).
ecc_is_pubkey_valid_partial - additional samity check is added.
- Updated vli_mmod_fast with non-strict heuristic to call optimal
module reduction function depending on the prime value;
- All computations for the previously defined (two NIST) curves should
not unaffected.
* crypto/ecc.h:
- Newly exported functions are documented.
* crypto/ecrdsa_defs.h
- Five curves are defined.
* crypto/ecrdsa.c:
- Signature verification is implemented.
* crypto/ecrdsa_params.asn1, crypto/ecrdsa_pub_key.asn1:
- Templates for BER decoder for EC-RDSA parameters and public key.
Cc: linux-integrity@vger.kernel.org
Signed-off-by: Vitaly Chikunov <vt@altlinux.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
|
|
|
|
|
|
|
|
|
|
| |
ecc.c have algorithms that could be used togeter by ecdh and ecrdsa.
Make it separate module. Add CRYPTO_ECC into Kconfig. EXPORT_SYMBOL and
document to what seems appropriate. Move structs ecc_point and ecc_curve
from ecc_curve_defs.h into ecc.h.
No code changes.
Signed-off-by: Vitaly Chikunov <vt@altlinux.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
On the quest to remove all VLAs from the kernel[1], this avoids VLAs
by just using the maximum allocation size (4 bytes) for stack arrays.
All the VLAs in ecc were either 3 or 4 bytes (or a multiple), so just
make it 4 bytes all the time. Initialization routines are adjusted to
check that ndigits does not end up larger than the arrays.
This includes a removal of the earlier attempt at this fix from
commit a963834b4742 ("crypto/ecc: Remove stack VLA usage")
[1] https://lkml.org/lkml/2018/3/7/621
Signed-off-by: Kees Cook <keescook@chromium.org>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
Add support for generating ecc private keys.
Generation of ecc private keys is helpful in a user-space to kernel
ecdh offload because the keys are not revealed to user-space. Private
key generation is also helpful to implement forward secrecy.
If the user provides a NULL ecc private key, the kernel will generate it
and further use it for ecdh.
Move ecdh's object files below drbg's. drbg must be present in the kernel
at the time of calling.
Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com>
Reviewed-by: Stephan Müller <smueller@chronox.de>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
|
|
|
|
|
|
|
| |
Rename ecdh_make_pub_key() to ecc_make_pub_key().
ecdh_make_pub_key() is not dh specific and the reference
to dh is wrong.
Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
|
|
|
|
|
|
|
| |
ecc software implementation works with chunks of u64 data. There were some
unnecessary casts to u8 and then back to u64 for the ecc keys. This patch
removes the unnecessary casts.
Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
|
|
|
| |
Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
|
|
|
|
|
| |
While here, add missing argument description (ndigits).
Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
|
|
|
|
|
|
| |
There is another ecdh_shared_secret in net/bluetooth/ecc.c
Fixes: 3c4b23901a0c ("crypto: ecdh - Add ECDH software support")
Signed-off-by: Stephen Rothwell <sfr@canb.auug.org.au>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|
|
* Implement ECDH under kpp API
* Provide ECC software support for curve P-192 and
P-256.
* Add kpp test for ECDH with data generated by OpenSSL
Signed-off-by: Salvatore Benedetto <salvatore.benedetto@intel.com>
Signed-off-by: Herbert Xu <herbert@gondor.apana.org.au>
|