From c06fad9d28c95b024ea10455cf1397432b12848d Mon Sep 17 00:00:00 2001 From: "Philip, Avinash" Date: Thu, 23 Aug 2012 12:29:46 +0530 Subject: pwm: pwm-tiecap: Disable APWM mode after configure APWM mode is enabled while configuring PWM device. This was done to handle shadow & immediate mode update of period and compare registers. However, leaving it enabled after configuring will cause APWM output on PWM pin even before enabling PWM device. Fix the same by disabling APWM mode after configuring if PWM device is not running. Signed-off-by: Philip, Avinash Signed-off-by: Thierry Reding --- drivers/pwm/pwm-tiecap.c | 7 +++++++ 1 file changed, 7 insertions(+) diff --git a/drivers/pwm/pwm-tiecap.c b/drivers/pwm/pwm-tiecap.c index 0b66d0f25922..4b6688909fee 100644 --- a/drivers/pwm/pwm-tiecap.c +++ b/drivers/pwm/pwm-tiecap.c @@ -100,6 +100,13 @@ static int ecap_pwm_config(struct pwm_chip *chip, struct pwm_device *pwm, writel(period_cycles, pc->mmio_base + CAP3); } + if (!test_bit(PWMF_ENABLED, &pwm->flags)) { + reg_val = readw(pc->mmio_base + ECCTL2); + /* Disable APWM mode to put APWM output Low */ + reg_val &= ~ECCTL2_APWM_MODE; + writew(reg_val, pc->mmio_base + ECCTL2); + } + pm_runtime_put_sync(pc->chip.dev); return 0; } -- cgit v1.2.3