mmc: Fixes for Dual Data Rate (DDR) support

The DDR support patch needs the following fixes:

- The block driver does not need to know about DDR, any more
  than it needs to know about bus width.
- Not only the card must be switched to DDR mode.  The host
  controller must also be configured, which is done through
  the 'set_ios()' function.
- Do not set the DDR mode state until after the switch command
  is successful.
- Setting block length is not supported in DDR mode.  Make that
  a core function and change the other place it is used (mmc_test)
  also.

Signed-off-by: Adrian Hunter <adrian.hunter@nokia.com>
Signed-off-by: Chris Ball <cjb@laptop.org>

1 files changed, 1 insertions, 11 deletions

diff --git a/drivers/mmc/card/mmc_test.c b/drivers/mmc/card/mmc_test.c
index c38a3a84a455..21adc27f4132 100644
--- a/drivers/mmc/card/mmc_test.c
+++ b/drivers/mmc/card/mmc_test.c
@@ -155,17 +155,7 @@ struct mmc_test_card {
  */
 static int mmc_test_set_blksize(struct mmc_test_card *test, unsigned size)
 {
-	struct mmc_command cmd;
-	int ret;
-
-	cmd.opcode = MMC_SET_BLOCKLEN;
-	cmd.arg = size;
-	cmd.flags = MMC_RSP_R1 | MMC_CMD_AC;
-	ret = mmc_wait_for_cmd(test->card->host, &cmd, 0);
-	if (ret)
-		return ret;
-
-	return 0;
+	return mmc_set_blocklen(test->card, size);
 }
 
 /*