Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6: (1429 commits)
  net: Allow dependancies of FDDI & Tokenring to be modular.
  igb: Fix build warning when DCA is disabled.
  net: Fix warning fallout from recent NAPI interface changes.
  gro: Fix potential use after free
  sfc: If AN is enabled, always read speed/duplex from the AN advertising bits
  sfc: When disabling the NIC, close the device rather than unregistering it
  sfc: SFT9001: Add cable diagnostics
  sfc: Add support for multiple PHY self-tests
  sfc: Merge top-level functions for self-tests
  sfc: Clean up PHY mode management in loopback self-test
  sfc: Fix unreliable link detection in some loopback modes
  sfc: Generate unique names for per-NIC workqueues
  802.3ad: use standard ethhdr instead of ad_header
  802.3ad: generalize out mac address initializer
  802.3ad: initialize ports LACPDU from const initializer
  802.3ad: remove typedef around ad_system
  802.3ad: turn ports is_individual into a bool
  802.3ad: turn ports is_enabled into a bool
  802.3ad: make ntt bool
  ixgbe: Fix set_ringparam in ixgbe to use the same memory pools.
  ...

Fixed trivial IPv4/6 address printing conflicts in fs/cifs/connect.c due
to the conversion to %pI (in this networking merge) and the addition of
doing IPv6 addresses (from the earlier merge of CIFS).

1 files changed, 21 insertions, 2 deletions

diff --git a/drivers/net/phy/Kconfig b/drivers/net/phy/Kconfig
index d55932acd887..de9cf5136fdc 100644
--- a/drivers/net/phy/Kconfig
+++ b/drivers/net/phy/Kconfig
@@ -66,6 +66,22 @@ config REALTEK_PHY
 	---help---
 	  Supports the Realtek 821x PHY.
 
+config NATIONAL_PHY
+	tristate "Drivers for National Semiconductor PHYs"
+	---help---
+	  Currently supports the DP83865 PHY.
+
+config STE10XP
+	depends on PHYLIB
+	tristate "Driver for STMicroelectronics STe10Xp PHYs"
+	---help---
+	  This is the driver for the STe100p and STe101p PHYs.
+
+config LSI_ET1011C_PHY
+	tristate "Driver for LSI ET1011C PHY"
+	---help---
+	  Supports the LSI ET1011C PHY.
+
 config FIXED_PHY
 	bool "Driver for MDIO Bus/PHY emulation with fixed speed/link PHYs"
 	depends on PHYLIB=y
@@ -84,10 +100,13 @@ config MDIO_BITBANG
 
 	  If in doubt, say N.
 
-config MDIO_OF_GPIO
+config MDIO_GPIO
 	tristate "Support for GPIO lib-based bitbanged MDIO buses"
-	depends on MDIO_BITBANG && OF_GPIO
+	depends on MDIO_BITBANG && GENERIC_GPIO
 	---help---
 	  Supports GPIO lib-based MDIO busses.
 
+	  To compile this driver as a module, choose M here: the module
+	  will be called mdio-gpio.
+
 endif # PHYLIB