usb: Kconfig: move ulpi bus support out of host

The ULPI bus is not only for host, but for device mode too, so move
it out from host's Kconfig.

Signed-off-by: Peter Chen <peter.chen@nxp.com>
Acked-by: Heikki Krogerus <heikki.krogerus@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

1 files changed, 20 insertions, 0 deletions

diff --git a/drivers/usb/Kconfig b/drivers/usb/Kconfig
index 8689dcba5201..6dfa10af7185 100644
--- a/drivers/usb/Kconfig
+++ b/drivers/usb/Kconfig
@@ -160,4 +160,24 @@ config USB_LED_TRIG
 	  LEDs and you want to use them as activity indicators for USB host or
 	  gadget.
 
+config USB_ULPI_BUS
+	tristate "USB ULPI PHY interface support"
+	help
+	  UTMI+ Low Pin Interface (ULPI) is specification for a commonly used
+	  USB 2.0 PHY interface. The ULPI specification defines a standard set
+	  of registers that can be used to detect the vendor and product which
+	  allows ULPI to be handled as a bus. This module is the driver for that
+	  bus.
+
+	  The ULPI interfaces (the buses) are registered by the drivers for USB
+	  controllers which support ULPI register access and have ULPI PHY
+	  attached to them. The ULPI PHY drivers themselves are normal PHY
+	  drivers.
+
+	  ULPI PHYs provide often functions such as ADP sensing/probing (OTG
+	  protocol) and USB charger detection.
+
+	  To compile this driver as a module, choose M here: the module will
+	  be called ulpi.
+
 endif # USB_SUPPORT