[NET]: move config options out to individual protocols

Move the protocol specific config options out to the specific protocols.
With this change net/Kconfig now starts to become readable and serve as a
good basis for further re-structuring.

The menu structure is left almost intact, except that indention is
fixed in most cases. Most visible are the INET changes where several
"depends on INET" are replaced with a single ifdef INET / endif pair.

Several new files were created to accomplish this change - they are
small but serve the purpose that config options are now distributed
out where they belongs.

Signed-off-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 36 insertions, 0 deletions

diff --git a/net/x25/Kconfig b/net/x25/Kconfig
new file mode 100644
index 000000000000..e6759c9660bb
--- /dev/null
+++ b/net/x25/Kconfig
@@ -0,0 +1,36 @@
+#
+# CCITT X.25 Packet Layer
+#
+
+config X25
+	tristate "CCITT X.25 Packet Layer (EXPERIMENTAL)"
+	depends on EXPERIMENTAL
+	---help---
+	  X.25 is a set of standardized network protocols, similar in scope to
+	  frame relay; the one physical line from your box to the X.25 network
+	  entry point can carry several logical point-to-point connections
+	  (called "virtual circuits") to other computers connected to the X.25
+	  network. Governments, banks, and other organizations tend to use it
+	  to connect to each other or to form Wide Area Networks (WANs). Many
+	  countries have public X.25 networks. X.25 consists of two
+	  protocols: the higher level Packet Layer Protocol (PLP) (say Y here
+	  if you want that) and the lower level data link layer protocol LAPB
+	  (say Y to "LAPB Data Link Driver" below if you want that).
+
+	  You can read more about X.25 at <http://www.sangoma.com/x25.htm> and
+	  <http://www.cisco.com/univercd/cc/td/doc/product/software/ios11/cbook/cx25.htm>.
+	  Information about X.25 for Linux is contained in the files
+	  <file:Documentation/networking/x25.txt> and
+	  <file:Documentation/networking/x25-iface.txt>.
+
+	  One connects to an X.25 network either with a dedicated network card
+	  using the X.21 protocol (not yet supported by Linux) or one can do
+	  X.25 over a standard telephone line using an ordinary modem (say Y
+	  to "X.25 async driver" below) or over Ethernet using an ordinary
+	  Ethernet card and the LAPB over Ethernet (say Y to "LAPB Data Link
+	  Driver" and "LAPB over Ethernet driver" below).
+
+	  To compile this driver as a module, choose M here: the module
+	  will be called x25. If unsure, say N.
+
+