diff options
Diffstat (limited to 'drivers/gpu/drm/i915/intel_bios.h')
| -rw-r--r-- | drivers/gpu/drm/i915/intel_bios.h | 174 |
1 files changed, 145 insertions, 29 deletions
diff --git a/drivers/gpu/drm/i915/intel_bios.h b/drivers/gpu/drm/i915/intel_bios.h index 282de5e9f39d..83b7629e4367 100644 --- a/drivers/gpu/drm/i915/intel_bios.h +++ b/drivers/gpu/drm/i915/intel_bios.h @@ -104,7 +104,8 @@ struct vbios_data { #define BDB_LVDS_LFP_DATA 42 #define BDB_LVDS_BACKLIGHT 43 #define BDB_LVDS_POWER 44 -#define BDB_MIPI 50 +#define BDB_MIPI_CONFIG 52 +#define BDB_MIPI_SEQUENCE 53 #define BDB_SKIP 254 /* VBIOS private block, ignore */ struct bdb_general_features { @@ -711,44 +712,159 @@ int intel_parse_bios(struct drm_device *dev); #define DVO_PORT_DPD 9 #define DVO_PORT_DPA 10 -/* MIPI DSI panel info */ -struct bdb_mipi { - u16 panel_id; - u16 bridge_revision; - - /* General params */ - u32 dithering:1; - u32 bpp_pixel_format:1; - u32 rsvd1:1; - u32 dphy_valid:1; - u32 resvd2:28; +/* Block 52 contains MIPI Panel info + * 6 such enteries will there. Index into correct + * entery is based on the panel_index in #40 LFP + */ +#define MAX_MIPI_CONFIGURATIONS 6 - u16 port_info; - u16 rsvd3:2; - u16 num_lanes:2; - u16 rsvd4:12; +#define MIPI_DSI_UNDEFINED_PANEL_ID 0 +#define MIPI_DSI_GENERIC_PANEL_ID 1 - /* DSI config */ - u16 virt_ch_num:2; - u16 vtm:2; - u16 rsvd5:12; +struct mipi_config { + u16 panel_id; - u32 dsi_clock; + /* General Params */ + u32 enable_dithering:1; + u32 rsvd1:1; + u32 is_bridge:1; + + u32 panel_arch_type:2; + u32 is_cmd_mode:1; + +#define NON_BURST_SYNC_PULSE 0x1 +#define NON_BURST_SYNC_EVENTS 0x2 +#define BURST_MODE 0x3 + u32 video_transfer_mode:2; + + u32 cabc_supported:1; + u32 pwm_blc:1; + + /* Bit 13:10 */ +#define PIXEL_FORMAT_RGB565 0x1 +#define PIXEL_FORMAT_RGB666 0x2 +#define PIXEL_FORMAT_RGB666_LOOSELY_PACKED 0x3 +#define PIXEL_FORMAT_RGB888 0x4 + u32 videomode_color_format:4; + + /* Bit 15:14 */ +#define ENABLE_ROTATION_0 0x0 +#define ENABLE_ROTATION_90 0x1 +#define ENABLE_ROTATION_180 0x2 +#define ENABLE_ROTATION_270 0x3 + u32 rotation:2; + u32 bta_enabled:1; + u32 rsvd2:15; + + /* 2 byte Port Description */ +#define DUAL_LINK_NOT_SUPPORTED 0 +#define DUAL_LINK_FRONT_BACK 1 +#define DUAL_LINK_PIXEL_ALT 2 + u16 dual_link:2; + u16 lane_cnt:2; + u16 rsvd3:12; + + u16 rsvd4; + + u8 rsvd5[5]; + u32 dsi_ddr_clk; u32 bridge_ref_clk; - u16 rsvd_pwr; - /* Dphy Params */ - u32 prepare_cnt:5; - u32 rsvd6:3; +#define BYTE_CLK_SEL_20MHZ 0 +#define BYTE_CLK_SEL_10MHZ 1 +#define BYTE_CLK_SEL_5MHZ 2 + u8 byte_clk_sel:2; + + u8 rsvd6:6; + + /* DPHY Flags */ + u16 dphy_param_valid:1; + u16 eot_pkt_disabled:1; + u16 enable_clk_stop:1; + u16 rsvd7:13; + + u32 hs_tx_timeout; + u32 lp_rx_timeout; + u32 turn_around_timeout; + u32 device_reset_timer; + u32 master_init_timer; + u32 dbi_bw_timer; + u32 lp_byte_clk_val; + + /* 4 byte Dphy Params */ + u32 prepare_cnt:6; + u32 rsvd8:2; u32 clk_zero_cnt:8; u32 trail_cnt:5; - u32 rsvd7:3; + u32 rsvd9:3; u32 exit_zero_cnt:6; - u32 rsvd8:2; + u32 rsvd10:2; - u32 hl_switch_cnt; - u32 lp_byte_clk; u32 clk_lane_switch_cnt; + u32 hl_switch_cnt; + + u32 rsvd11[6]; + + /* timings based on dphy spec */ + u8 tclk_miss; + u8 tclk_post; + u8 rsvd12; + u8 tclk_pre; + u8 tclk_prepare; + u8 tclk_settle; + u8 tclk_term_enable; + u8 tclk_trail; + u16 tclk_prepare_clkzero; + u8 rsvd13; + u8 td_term_enable; + u8 teot; + u8 ths_exit; + u8 ths_prepare; + u16 ths_prepare_hszero; + u8 rsvd14; + u8 ths_settle; + u8 ths_skip; + u8 ths_trail; + u8 tinit; + u8 tlpx; + u8 rsvd15[3]; + + /* GPIOs */ + u8 panel_enable; + u8 bl_enable; + u8 pwm_enable; + u8 reset_r_n; + u8 pwr_down_r; + u8 stdby_r_n; + } __packed; +/* Block 52 contains MIPI configuration block + * 6 * bdb_mipi_config, followed by 6 pps data + * block below + * + * all delays has a unit of 100us + */ +struct mipi_pps_data { + u16 panel_on_delay; + u16 bl_enable_delay; + u16 bl_disable_delay; + u16 panel_off_delay; + u16 panel_power_cycle_delay; +}; + +struct bdb_mipi_config { + struct mipi_config config[MAX_MIPI_CONFIGURATIONS]; + struct mipi_pps_data pps[MAX_MIPI_CONFIGURATIONS]; +}; + +/* Block 53 contains MIPI sequences as needed by the panel + * for enabling it. This block can be variable in size and + * can be maximum of 6 blocks + */ +struct bdb_mipi_sequence { + u8 version; + u8 data[0]; +}; + #endif /* _I830_BIOS_H_ */ |