1 files changed, 20 insertions, 29 deletions

diff --git a/drivers/mmc/core/sd.c b/drivers/mmc/core/sd.c
index cee4c0b59f43..3662bf5320ce 100644
--- a/drivers/mmc/core/sd.c
+++ b/drivers/mmc/core/sd.c
@@ -870,7 +870,8 @@ try_again:
 	 * the CCS bit is set as well. We deliberately deviate from the spec in
 	 * regards to this, which allows UHS-I to be supported for SDSC cards.
 	 */
-	if (!mmc_host_is_spi(host) && rocr && (*rocr & SD_ROCR_S18A)) {
+	if (!mmc_host_is_spi(host) && (ocr & SD_OCR_S18R) &&
+	    rocr && (*rocr & SD_ROCR_S18A)) {
 		err = mmc_set_uhs_voltage(host, pocr);
 		if (err == -EAGAIN) {
 			retries--;
@@ -949,16 +950,17 @@ int mmc_sd_setup_card(struct mmc_host *host, struct mmc_card *card,
 
 		/* Erase init depends on CSD and SSR */
 		mmc_init_erase(card);
-
-		/*
-		 * Fetch switch information from card.
-		 */
-		err = mmc_read_switch(card);
-		if (err)
-			return err;
 	}
 
 	/*
+	 * Fetch switch information from card. Note, sd3_bus_mode can change if
+	 * voltage switch outcome changes, so do this always.
+	 */
+	err = mmc_read_switch(card);
+	if (err)
+		return err;
+
+	/*
 	 * For SPI, enable CRC as appropriate.
 	 * This CRC enable is located AFTER the reading of the
 	 * card registers because some SDHC cards are not able
@@ -1480,26 +1482,15 @@ retry:
 	if (!v18_fixup_failed && !mmc_host_is_spi(host) && mmc_host_uhs(host) &&
 	    mmc_sd_card_using_v18(card) &&
 	    host->ios.signal_voltage != MMC_SIGNAL_VOLTAGE_180) {
-		/*
-		 * Re-read switch information in case it has changed since
-		 * oldcard was initialized.
-		 */
-		if (oldcard) {
-			err = mmc_read_switch(card);
-			if (err)
-				goto free_card;
-		}
-		if (mmc_sd_card_using_v18(card)) {
-			if (mmc_host_set_uhs_voltage(host) ||
-			    mmc_sd_init_uhs_card(card)) {
-				v18_fixup_failed = true;
-				mmc_power_cycle(host, ocr);
-				if (!oldcard)
-					mmc_remove_card(card);
-				goto retry;
-			}
-			goto done;
+		if (mmc_host_set_uhs_voltage(host) ||
+		    mmc_sd_init_uhs_card(card)) {
+			v18_fixup_failed = true;
+			mmc_power_cycle(host, ocr);
+			if (!oldcard)
+				mmc_remove_card(card);
+			goto retry;
 		}
+		goto cont;
 	}
 
 	/* Initialization sequence for UHS-I cards */
@@ -1534,7 +1525,7 @@ retry:
 			mmc_set_bus_width(host, MMC_BUS_WIDTH_4);
 		}
 	}
-
+cont:
 	if (!oldcard) {
 		/* Read/parse the extension registers. */
 		err = sd_read_ext_regs(card);
@@ -1566,7 +1557,7 @@ retry:
 		err = -EINVAL;
 		goto free_card;
 	}
-done:
+
 	host->card = card;
 	return 0;