diff options
Diffstat (limited to 'drivers/mmc')
-rw-r--r-- | drivers/mmc/host/at91_mci.c | 2 | ||||
-rw-r--r-- | drivers/mmc/host/atmel-mci.c | 18 | ||||
-rw-r--r-- | drivers/mmc/host/mmci.c | 19 | ||||
-rw-r--r-- | drivers/mmc/host/mmci.h | 6 | ||||
-rw-r--r-- | drivers/mmc/host/omap_hsmmc.c | 9 | ||||
-rw-r--r-- | drivers/mmc/host/pxamci.c | 2 |
6 files changed, 34 insertions, 22 deletions
diff --git a/drivers/mmc/host/at91_mci.c b/drivers/mmc/host/at91_mci.c index a6dd7da37357..336d9f553f3e 100644 --- a/drivers/mmc/host/at91_mci.c +++ b/drivers/mmc/host/at91_mci.c @@ -314,8 +314,8 @@ static void at91_mci_post_dma_read(struct at91mci_host *host) dmabuf = (unsigned *)tmpv; } + flush_kernel_dcache_page(sg_page(sg)); kunmap_atomic(sgbuffer, KM_BIO_SRC_IRQ); - dmac_flush_range((void *)sgbuffer, ((void *)sgbuffer) + amount); data->bytes_xfered += amount; if (size == 0) break; diff --git a/drivers/mmc/host/atmel-mci.c b/drivers/mmc/host/atmel-mci.c index 88be37d9e9a5..fb279f4ed8b3 100644 --- a/drivers/mmc/host/atmel-mci.c +++ b/drivers/mmc/host/atmel-mci.c @@ -266,7 +266,7 @@ static int atmci_req_show(struct seq_file *s, void *v) "CMD%u(0x%x) flg %x rsp %x %x %x %x err %d\n", cmd->opcode, cmd->arg, cmd->flags, cmd->resp[0], cmd->resp[1], cmd->resp[2], - cmd->resp[2], cmd->error); + cmd->resp[3], cmd->error); if (data) seq_printf(s, "DATA %u / %u * %u flg %x err %d\n", data->bytes_xfered, data->blocks, @@ -276,7 +276,7 @@ static int atmci_req_show(struct seq_file *s, void *v) "CMD%u(0x%x) flg %x rsp %x %x %x %x err %d\n", stop->opcode, stop->arg, stop->flags, stop->resp[0], stop->resp[1], stop->resp[2], - stop->resp[2], stop->error); + stop->resp[3], stop->error); } spin_unlock_bh(&slot->host->lock); @@ -569,9 +569,10 @@ static void atmci_dma_cleanup(struct atmel_mci *host) { struct mmc_data *data = host->data; - dma_unmap_sg(&host->pdev->dev, data->sg, data->sg_len, - ((data->flags & MMC_DATA_WRITE) - ? DMA_TO_DEVICE : DMA_FROM_DEVICE)); + if (data) + dma_unmap_sg(&host->pdev->dev, data->sg, data->sg_len, + ((data->flags & MMC_DATA_WRITE) + ? DMA_TO_DEVICE : DMA_FROM_DEVICE)); } static void atmci_stop_dma(struct atmel_mci *host) @@ -1099,8 +1100,8 @@ static void atmci_command_complete(struct atmel_mci *host, "command error: status=0x%08x\n", status); if (cmd->data) { - host->data = NULL; atmci_stop_dma(host); + host->data = NULL; mci_writel(host, IDR, MCI_NOTBUSY | MCI_TXRDY | MCI_RXRDY | ATMCI_DATA_ERROR_FLAGS); @@ -1293,6 +1294,7 @@ static void atmci_tasklet_func(unsigned long priv) } else { data->bytes_xfered = data->blocks * data->blksz; data->error = 0; + mci_writel(host, IDR, ATMCI_DATA_ERROR_FLAGS); } if (!data->stop) { @@ -1751,13 +1753,13 @@ static int __init atmci_probe(struct platform_device *pdev) ret = -ENODEV; if (pdata->slot[0].bus_width) { ret = atmci_init_slot(host, &pdata->slot[0], - MCI_SDCSEL_SLOT_A, 0); + 0, MCI_SDCSEL_SLOT_A); if (!ret) nr_slots++; } if (pdata->slot[1].bus_width) { ret = atmci_init_slot(host, &pdata->slot[1], - MCI_SDCSEL_SLOT_B, 1); + 1, MCI_SDCSEL_SLOT_B); if (!ret) nr_slots++; } diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c index 84c103a7ee13..ff115d920888 100644 --- a/drivers/mmc/host/mmci.c +++ b/drivers/mmc/host/mmci.c @@ -55,14 +55,16 @@ static void mmci_set_clkreg(struct mmci_host *host, unsigned int desired) host->cclk = host->mclk / (2 * (clk + 1)); } if (host->hw_designer == AMBA_VENDOR_ST) - clk |= MCI_FCEN; /* Bug fix in ST IP block */ + clk |= MCI_ST_FCEN; /* Bug fix in ST IP block */ clk |= MCI_CLK_ENABLE; /* This hasn't proven to be worthwhile */ /* clk |= MCI_CLK_PWRSAVE; */ } if (host->mmc->ios.bus_width == MMC_BUS_WIDTH_4) - clk |= MCI_WIDE_BUS; + clk |= MCI_4BIT_BUS; + if (host->mmc->ios.bus_width == MMC_BUS_WIDTH_8) + clk |= MCI_ST_8BIT_BUS; writel(clk, host->base + MMCICLOCK); } @@ -629,7 +631,18 @@ static int __devinit mmci_probe(struct amba_device *dev, struct amba_id *id) mmc->ops = &mmci_ops; mmc->f_min = (host->mclk + 511) / 512; - mmc->f_max = min(host->mclk, fmax); + /* + * If the platform data supplies a maximum operating + * frequency, this takes precedence. Else, we fall back + * to using the module parameter, which has a (low) + * default value in case it is not specified. Either + * value must not exceed the clock rate into the block, + * of course. + */ + if (plat->f_max) + mmc->f_max = min(host->mclk, plat->f_max); + else + mmc->f_max = min(host->mclk, fmax); dev_dbg(mmc_dev(mmc), "clocking block at %u Hz\n", mmc->f_max); #ifdef CONFIG_REGULATOR diff --git a/drivers/mmc/host/mmci.h b/drivers/mmc/host/mmci.h index 1ceb9a90f59b..d77062e5e3af 100644 --- a/drivers/mmc/host/mmci.h +++ b/drivers/mmc/host/mmci.h @@ -25,9 +25,11 @@ #define MCI_CLK_ENABLE (1 << 8) #define MCI_CLK_PWRSAVE (1 << 9) #define MCI_CLK_BYPASS (1 << 10) -#define MCI_WIDE_BUS (1 << 11) +#define MCI_4BIT_BUS (1 << 11) +/* 8bit wide buses supported in ST Micro versions */ +#define MCI_ST_8BIT_BUS (1 << 12) /* HW flow control on the ST Micro version */ -#define MCI_FCEN (1 << 13) +#define MCI_ST_FCEN (1 << 13) #define MMCIARGUMENT 0x008 #define MMCICOMMAND 0x00c diff --git a/drivers/mmc/host/omap_hsmmc.c b/drivers/mmc/host/omap_hsmmc.c index 83f0affadcae..e9caf694c59e 100644 --- a/drivers/mmc/host/omap_hsmmc.c +++ b/drivers/mmc/host/omap_hsmmc.c @@ -1179,15 +1179,10 @@ static void omap_hsmmc_detect(struct work_struct *work) carddetect = -ENOSYS; } - if (carddetect) { + if (carddetect) mmc_detect_change(host->mmc, (HZ * 200) / 1000); - } else { - mmc_host_enable(host->mmc); - omap_hsmmc_reset_controller_fsm(host, SRD); - mmc_host_lazy_disable(host->mmc); - + else mmc_detect_change(host->mmc, (HZ * 50) / 1000); - } } /* diff --git a/drivers/mmc/host/pxamci.c b/drivers/mmc/host/pxamci.c index 0ed48959b590..e4f00e70a749 100644 --- a/drivers/mmc/host/pxamci.c +++ b/drivers/mmc/host/pxamci.c @@ -544,7 +544,7 @@ static irqreturn_t pxamci_detect_irq(int irq, void *devid) { struct pxamci_host *host = mmc_priv(devid); - mmc_detect_change(devid, host->pdata->detect_delay); + mmc_detect_change(devid, msecs_to_jiffies(host->pdata->detect_delay_ms)); return IRQ_HANDLED; } |