diff options
Diffstat (limited to 'drivers/net/wireless/ralink/rt2x00/rt2x00config.c')
| -rw-r--r-- | drivers/net/wireless/ralink/rt2x00/rt2x00config.c | 285 |
1 files changed, 285 insertions, 0 deletions
diff --git a/drivers/net/wireless/ralink/rt2x00/rt2x00config.c b/drivers/net/wireless/ralink/rt2x00/rt2x00config.c new file mode 100644 index 000000000000..7e8bb1198ae9 --- /dev/null +++ b/drivers/net/wireless/ralink/rt2x00/rt2x00config.c @@ -0,0 +1,285 @@ +/* + Copyright (C) 2004 - 2009 Ivo van Doorn <IvDoorn@gmail.com> + <http://rt2x00.serialmonkey.com> + + This program is free software; you can redistribute it and/or modify + it under the terms of the GNU General Public License as published by + the Free Software Foundation; either version 2 of the License, or + (at your option) any later version. + + This program is distributed in the hope that it will be useful, + but WITHOUT ANY WARRANTY; without even the implied warranty of + MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the + GNU General Public License for more details. + + You should have received a copy of the GNU General Public License + along with this program; if not, see <http://www.gnu.org/licenses/>. + */ + +/* + Module: rt2x00lib + Abstract: rt2x00 generic configuration routines. + */ + +#include <linux/kernel.h> +#include <linux/module.h> + +#include "rt2x00.h" +#include "rt2x00lib.h" + +void rt2x00lib_config_intf(struct rt2x00_dev *rt2x00dev, + struct rt2x00_intf *intf, + enum nl80211_iftype type, + const u8 *mac, const u8 *bssid) +{ + struct rt2x00intf_conf conf; + unsigned int flags = 0; + + conf.type = type; + + switch (type) { + case NL80211_IFTYPE_ADHOC: + conf.sync = TSF_SYNC_ADHOC; + break; + case NL80211_IFTYPE_AP: + case NL80211_IFTYPE_MESH_POINT: + case NL80211_IFTYPE_WDS: + conf.sync = TSF_SYNC_AP_NONE; + break; + case NL80211_IFTYPE_STATION: + conf.sync = TSF_SYNC_INFRA; + break; + default: + conf.sync = TSF_SYNC_NONE; + break; + } + + /* + * Note that when NULL is passed as address we will send + * 00:00:00:00:00 to the device to clear the address. + * This will prevent the device being confused when it wants + * to ACK frames or considers itself associated. + */ + memset(conf.mac, 0, sizeof(conf.mac)); + if (mac) + memcpy(conf.mac, mac, ETH_ALEN); + + memset(conf.bssid, 0, sizeof(conf.bssid)); + if (bssid) + memcpy(conf.bssid, bssid, ETH_ALEN); + + flags |= CONFIG_UPDATE_TYPE; + if (mac || (!rt2x00dev->intf_ap_count && !rt2x00dev->intf_sta_count)) + flags |= CONFIG_UPDATE_MAC; + if (bssid || (!rt2x00dev->intf_ap_count && !rt2x00dev->intf_sta_count)) + flags |= CONFIG_UPDATE_BSSID; + + rt2x00dev->ops->lib->config_intf(rt2x00dev, intf, &conf, flags); +} + +void rt2x00lib_config_erp(struct rt2x00_dev *rt2x00dev, + struct rt2x00_intf *intf, + struct ieee80211_bss_conf *bss_conf, + u32 changed) +{ + struct rt2x00lib_erp erp; + + memset(&erp, 0, sizeof(erp)); + + erp.short_preamble = bss_conf->use_short_preamble; + erp.cts_protection = bss_conf->use_cts_prot; + + erp.slot_time = bss_conf->use_short_slot ? SHORT_SLOT_TIME : SLOT_TIME; + erp.sifs = SIFS; + erp.pifs = bss_conf->use_short_slot ? SHORT_PIFS : PIFS; + erp.difs = bss_conf->use_short_slot ? SHORT_DIFS : DIFS; + erp.eifs = bss_conf->use_short_slot ? SHORT_EIFS : EIFS; + + erp.basic_rates = bss_conf->basic_rates; + erp.beacon_int = bss_conf->beacon_int; + + /* Update the AID, this is needed for dynamic PS support */ + rt2x00dev->aid = bss_conf->assoc ? bss_conf->aid : 0; + rt2x00dev->last_beacon = bss_conf->sync_tsf; + + /* Update global beacon interval time, this is needed for PS support */ + rt2x00dev->beacon_int = bss_conf->beacon_int; + + if (changed & BSS_CHANGED_HT) + erp.ht_opmode = bss_conf->ht_operation_mode; + + rt2x00dev->ops->lib->config_erp(rt2x00dev, &erp, changed); +} + +void rt2x00lib_config_antenna(struct rt2x00_dev *rt2x00dev, + struct antenna_setup config) +{ + struct link_ant *ant = &rt2x00dev->link.ant; + struct antenna_setup *def = &rt2x00dev->default_ant; + struct antenna_setup *active = &rt2x00dev->link.ant.active; + + /* + * When the caller tries to send the SW diversity, + * we must update the ANTENNA_RX_DIVERSITY flag to + * enable the antenna diversity in the link tuner. + * + * Secondly, we must guarentee we never send the + * software antenna diversity command to the driver. + */ + if (!(ant->flags & ANTENNA_RX_DIVERSITY)) { + if (config.rx == ANTENNA_SW_DIVERSITY) { + ant->flags |= ANTENNA_RX_DIVERSITY; + + if (def->rx == ANTENNA_SW_DIVERSITY) + config.rx = ANTENNA_B; + else + config.rx = def->rx; + } + } else if (config.rx == ANTENNA_SW_DIVERSITY) + config.rx = active->rx; + + if (!(ant->flags & ANTENNA_TX_DIVERSITY)) { + if (config.tx == ANTENNA_SW_DIVERSITY) { + ant->flags |= ANTENNA_TX_DIVERSITY; + + if (def->tx == ANTENNA_SW_DIVERSITY) + config.tx = ANTENNA_B; + else + config.tx = def->tx; + } + } else if (config.tx == ANTENNA_SW_DIVERSITY) + config.tx = active->tx; + + /* + * Antenna setup changes require the RX to be disabled, + * else the changes will be ignored by the device. + */ + if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags)) + rt2x00queue_stop_queue(rt2x00dev->rx); + + /* + * Write new antenna setup to device and reset the link tuner. + * The latter is required since we need to recalibrate the + * noise-sensitivity ratio for the new setup. + */ + rt2x00dev->ops->lib->config_ant(rt2x00dev, &config); + + rt2x00link_reset_tuner(rt2x00dev, true); + + memcpy(active, &config, sizeof(config)); + + if (test_bit(DEVICE_STATE_ENABLED_RADIO, &rt2x00dev->flags)) + rt2x00queue_start_queue(rt2x00dev->rx); +} + +static u16 rt2x00ht_center_channel(struct rt2x00_dev *rt2x00dev, + struct ieee80211_conf *conf) +{ + struct hw_mode_spec *spec = &rt2x00dev->spec; + int center_channel; + u16 i; + + /* + * Initialize center channel to current channel. + */ + center_channel = spec->channels[conf->chandef.chan->hw_value].channel; + + /* + * Adjust center channel to HT40+ and HT40- operation. + */ + if (conf_is_ht40_plus(conf)) + center_channel += 2; + else if (conf_is_ht40_minus(conf)) + center_channel -= (center_channel == 14) ? 1 : 2; + + for (i = 0; i < spec->num_channels; i++) + if (spec->channels[i].channel == center_channel) + return i; + + WARN_ON(1); + return conf->chandef.chan->hw_value; +} + +void rt2x00lib_config(struct rt2x00_dev *rt2x00dev, + struct ieee80211_conf *conf, + unsigned int ieee80211_flags) +{ + struct rt2x00lib_conf libconf; + u16 hw_value; + u16 autowake_timeout; + u16 beacon_int; + u16 beacon_diff; + + memset(&libconf, 0, sizeof(libconf)); + + libconf.conf = conf; + + if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL) { + if (!conf_is_ht(conf)) + set_bit(CONFIG_HT_DISABLED, &rt2x00dev->flags); + else + clear_bit(CONFIG_HT_DISABLED, &rt2x00dev->flags); + + if (conf_is_ht40(conf)) { + set_bit(CONFIG_CHANNEL_HT40, &rt2x00dev->flags); + hw_value = rt2x00ht_center_channel(rt2x00dev, conf); + } else { + clear_bit(CONFIG_CHANNEL_HT40, &rt2x00dev->flags); + hw_value = conf->chandef.chan->hw_value; + } + + memcpy(&libconf.rf, + &rt2x00dev->spec.channels[hw_value], + sizeof(libconf.rf)); + + memcpy(&libconf.channel, + &rt2x00dev->spec.channels_info[hw_value], + sizeof(libconf.channel)); + + /* Used for VCO periodic calibration */ + rt2x00dev->rf_channel = libconf.rf.channel; + } + + if (rt2x00_has_cap_flag(rt2x00dev, REQUIRE_PS_AUTOWAKE) && + (ieee80211_flags & IEEE80211_CONF_CHANGE_PS)) + cancel_delayed_work_sync(&rt2x00dev->autowakeup_work); + + /* + * Start configuration. + */ + rt2x00dev->ops->lib->config(rt2x00dev, &libconf, ieee80211_flags); + + /* + * Some configuration changes affect the link quality + * which means we need to reset the link tuner. + */ + if (ieee80211_flags & IEEE80211_CONF_CHANGE_CHANNEL) + rt2x00link_reset_tuner(rt2x00dev, false); + + if (test_bit(DEVICE_STATE_PRESENT, &rt2x00dev->flags) && + rt2x00_has_cap_flag(rt2x00dev, REQUIRE_PS_AUTOWAKE) && + (ieee80211_flags & IEEE80211_CONF_CHANGE_PS) && + (conf->flags & IEEE80211_CONF_PS)) { + beacon_diff = (long)jiffies - (long)rt2x00dev->last_beacon; + beacon_int = msecs_to_jiffies(rt2x00dev->beacon_int); + + if (beacon_diff > beacon_int) + beacon_diff = 0; + + autowake_timeout = (conf->ps_dtim_period * beacon_int) - beacon_diff; + queue_delayed_work(rt2x00dev->workqueue, + &rt2x00dev->autowakeup_work, + autowake_timeout - 15); + } + + if (conf->flags & IEEE80211_CONF_PS) + set_bit(CONFIG_POWERSAVING, &rt2x00dev->flags); + else + clear_bit(CONFIG_POWERSAVING, &rt2x00dev->flags); + + rt2x00dev->curr_band = conf->chandef.chan->band; + rt2x00dev->curr_freq = conf->chandef.chan->center_freq; + rt2x00dev->tx_power = conf->power_level; + rt2x00dev->short_retry = conf->short_frame_max_tx_count; + rt2x00dev->long_retry = conf->long_frame_max_tx_count; +} |