diff options
Diffstat (limited to 'drivers/scsi/hpsa_cmd.h')
| -rw-r--r-- | drivers/scsi/hpsa_cmd.h | 326 |
1 files changed, 326 insertions, 0 deletions
diff --git a/drivers/scsi/hpsa_cmd.h b/drivers/scsi/hpsa_cmd.h new file mode 100644 index 000000000000..12d71387ed9a --- /dev/null +++ b/drivers/scsi/hpsa_cmd.h @@ -0,0 +1,326 @@ +/* + * Disk Array driver for HP Smart Array SAS controllers + * Copyright 2000, 2009 Hewlett-Packard Development Company, L.P. + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License as published by + * the Free Software Foundation; version 2 of the License. + * + * This program is distributed in the hope that it will be useful, + * but WITHOUT ANY WARRANTY; without even the implied warranty of + * MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, GOOD TITLE or + * NON INFRINGEMENT. See the GNU General Public License for more details. + * + * You should have received a copy of the GNU General Public License + * along with this program; if not, write to the Free Software + * Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA. + * + * Questions/Comments/Bugfixes to iss_storagedev@hp.com + * + */ +#ifndef HPSA_CMD_H +#define HPSA_CMD_H + +/* general boundary defintions */ +#define SENSEINFOBYTES 32 /* may vary between hbas */ +#define MAXSGENTRIES 31 +#define MAXREPLYQS 256 + +/* Command Status value */ +#define CMD_SUCCESS 0x0000 +#define CMD_TARGET_STATUS 0x0001 +#define CMD_DATA_UNDERRUN 0x0002 +#define CMD_DATA_OVERRUN 0x0003 +#define CMD_INVALID 0x0004 +#define CMD_PROTOCOL_ERR 0x0005 +#define CMD_HARDWARE_ERR 0x0006 +#define CMD_CONNECTION_LOST 0x0007 +#define CMD_ABORTED 0x0008 +#define CMD_ABORT_FAILED 0x0009 +#define CMD_UNSOLICITED_ABORT 0x000A +#define CMD_TIMEOUT 0x000B +#define CMD_UNABORTABLE 0x000C + +/* Unit Attentions ASC's as defined for the MSA2012sa */ +#define POWER_OR_RESET 0x29 +#define STATE_CHANGED 0x2a +#define UNIT_ATTENTION_CLEARED 0x2f +#define LUN_FAILED 0x3e +#define REPORT_LUNS_CHANGED 0x3f + +/* Unit Attentions ASCQ's as defined for the MSA2012sa */ + + /* These ASCQ's defined for ASC = POWER_OR_RESET */ +#define POWER_ON_RESET 0x00 +#define POWER_ON_REBOOT 0x01 +#define SCSI_BUS_RESET 0x02 +#define MSA_TARGET_RESET 0x03 +#define CONTROLLER_FAILOVER 0x04 +#define TRANSCEIVER_SE 0x05 +#define TRANSCEIVER_LVD 0x06 + + /* These ASCQ's defined for ASC = STATE_CHANGED */ +#define RESERVATION_PREEMPTED 0x03 +#define ASYM_ACCESS_CHANGED 0x06 +#define LUN_CAPACITY_CHANGED 0x09 + +/* transfer direction */ +#define XFER_NONE 0x00 +#define XFER_WRITE 0x01 +#define XFER_READ 0x02 +#define XFER_RSVD 0x03 + +/* task attribute */ +#define ATTR_UNTAGGED 0x00 +#define ATTR_SIMPLE 0x04 +#define ATTR_HEADOFQUEUE 0x05 +#define ATTR_ORDERED 0x06 +#define ATTR_ACA 0x07 + +/* cdb type */ +#define TYPE_CMD 0x00 +#define TYPE_MSG 0x01 + +/* config space register offsets */ +#define CFG_VENDORID 0x00 +#define CFG_DEVICEID 0x02 +#define CFG_I2OBAR 0x10 +#define CFG_MEM1BAR 0x14 + +/* i2o space register offsets */ +#define I2O_IBDB_SET 0x20 +#define I2O_IBDB_CLEAR 0x70 +#define I2O_INT_STATUS 0x30 +#define I2O_INT_MASK 0x34 +#define I2O_IBPOST_Q 0x40 +#define I2O_OBPOST_Q 0x44 +#define I2O_DMA1_CFG 0x214 + +/* Configuration Table */ +#define CFGTBL_ChangeReq 0x00000001l +#define CFGTBL_AccCmds 0x00000001l + +#define CFGTBL_Trans_Simple 0x00000002l + +#define CFGTBL_BusType_Ultra2 0x00000001l +#define CFGTBL_BusType_Ultra3 0x00000002l +#define CFGTBL_BusType_Fibre1G 0x00000100l +#define CFGTBL_BusType_Fibre2G 0x00000200l +struct vals32 { + __u32 lower; + __u32 upper; +}; + +union u64bit { + struct vals32 val32; + __u64 val; +}; + +/* FIXME this is a per controller value (barf!) */ +#define HPSA_MAX_TARGETS_PER_CTLR 16 +#define HPSA_MAX_LUN 256 +#define HPSA_MAX_PHYS_LUN 1024 + +/* SCSI-3 Commands */ +#pragma pack(1) + +#define HPSA_INQUIRY 0x12 +struct InquiryData { + __u8 data_byte[36]; +}; + +#define HPSA_REPORT_LOG 0xc2 /* Report Logical LUNs */ +#define HPSA_REPORT_PHYS 0xc3 /* Report Physical LUNs */ +struct ReportLUNdata { + __u8 LUNListLength[4]; + __u32 reserved; + __u8 LUN[HPSA_MAX_LUN][8]; +}; + +struct ReportExtendedLUNdata { + __u8 LUNListLength[4]; + __u8 extended_response_flag; + __u8 reserved[3]; + __u8 LUN[HPSA_MAX_LUN][24]; +}; + +struct SenseSubsystem_info { + __u8 reserved[36]; + __u8 portname[8]; + __u8 reserved1[1108]; +}; + +#define HPSA_READ_CAPACITY 0x25 /* Read Capacity */ +struct ReadCapdata { + __u8 total_size[4]; /* Total size in blocks */ + __u8 block_size[4]; /* Size of blocks in bytes */ +}; + +#if 0 +/* 12 byte commands not implemented in firmware yet. */ +#define HPSA_READ 0xa8 +#define HPSA_WRITE 0xaa +#endif + +#define HPSA_READ 0x28 /* Read(10) */ +#define HPSA_WRITE 0x2a /* Write(10) */ + +/* BMIC commands */ +#define BMIC_READ 0x26 +#define BMIC_WRITE 0x27 +#define BMIC_CACHE_FLUSH 0xc2 +#define HPSA_CACHE_FLUSH 0x01 /* C2 was already being used by HPSA */ + +/* Command List Structure */ +union SCSI3Addr { + struct { + __u8 Dev; + __u8 Bus:6; + __u8 Mode:2; /* b00 */ + } PeripDev; + struct { + __u8 DevLSB; + __u8 DevMSB:6; + __u8 Mode:2; /* b01 */ + } LogDev; + struct { + __u8 Dev:5; + __u8 Bus:3; + __u8 Targ:6; + __u8 Mode:2; /* b10 */ + } LogUnit; +}; + +struct PhysDevAddr { + __u32 TargetId:24; + __u32 Bus:6; + __u32 Mode:2; + /* 2 level target device addr */ + union SCSI3Addr Target[2]; +}; + +struct LogDevAddr { + __u32 VolId:30; + __u32 Mode:2; + __u8 reserved[4]; +}; + +union LUNAddr { + __u8 LunAddrBytes[8]; + union SCSI3Addr SCSI3Lun[4]; + struct PhysDevAddr PhysDev; + struct LogDevAddr LogDev; +}; + +struct CommandListHeader { + __u8 ReplyQueue; + __u8 SGList; + __u16 SGTotal; + struct vals32 Tag; + union LUNAddr LUN; +}; + +struct RequestBlock { + __u8 CDBLen; + struct { + __u8 Type:3; + __u8 Attribute:3; + __u8 Direction:2; + } Type; + __u16 Timeout; + __u8 CDB[16]; +}; + +struct ErrDescriptor { + struct vals32 Addr; + __u32 Len; +}; + +struct SGDescriptor { + struct vals32 Addr; + __u32 Len; + __u32 Ext; +}; + +union MoreErrInfo { + struct { + __u8 Reserved[3]; + __u8 Type; + __u32 ErrorInfo; + } Common_Info; + struct { + __u8 Reserved[2]; + __u8 offense_size; /* size of offending entry */ + __u8 offense_num; /* byte # of offense 0-base */ + __u32 offense_value; + } Invalid_Cmd; +}; +struct ErrorInfo { + __u8 ScsiStatus; + __u8 SenseLen; + __u16 CommandStatus; + __u32 ResidualCnt; + union MoreErrInfo MoreErrInfo; + __u8 SenseInfo[SENSEINFOBYTES]; +}; +/* Command types */ +#define CMD_IOCTL_PEND 0x01 +#define CMD_SCSI 0x03 + +struct ctlr_info; /* defined in hpsa.h */ +/* The size of this structure needs to be divisible by 8 + * od on all architectures, because the controller uses 2 + * lower bits of the address, and the driver uses 1 lower + * bit (3 bits total.) + */ +struct CommandList { + struct CommandListHeader Header; + struct RequestBlock Request; + struct ErrDescriptor ErrDesc; + struct SGDescriptor SG[MAXSGENTRIES]; + /* information associated with the command */ + __u32 busaddr; /* physical addr of this record */ + struct ErrorInfo *err_info; /* pointer to the allocated mem */ + struct ctlr_info *h; + int cmd_type; + long cmdindex; + struct hlist_node list; + struct CommandList *prev; + struct CommandList *next; + struct request *rq; + struct completion *waiting; + int retry_count; + void *scsi_cmd; +}; + +/* Configuration Table Structure */ +struct HostWrite { + __u32 TransportRequest; + __u32 Reserved; + __u32 CoalIntDelay; + __u32 CoalIntCount; +}; + +struct CfgTable { + __u8 Signature[4]; + __u32 SpecValence; + __u32 TransportSupport; + __u32 TransportActive; + struct HostWrite HostWrite; + __u32 CmdsOutMax; + __u32 BusTypes; + __u32 Reserved; + __u8 ServerName[16]; + __u32 HeartBeat; + __u32 SCSI_Prefetch; +}; + +struct hpsa_pci_info { + unsigned char bus; + unsigned char dev_fn; + unsigned short domain; + __u32 board_id; +}; + +#pragma pack() +#endif /* HPSA_CMD_H */ |