diff options
Diffstat (limited to 'drivers/staging')
| -rw-r--r-- | drivers/staging/rtl8192u/ieee80211/ieee80211.h | 61 |
1 files changed, 36 insertions, 25 deletions
diff --git a/drivers/staging/rtl8192u/ieee80211/ieee80211.h b/drivers/staging/rtl8192u/ieee80211/ieee80211.h index 1bba5170e25a..0d247058bce4 100644 --- a/drivers/staging/rtl8192u/ieee80211/ieee80211.h +++ b/drivers/staging/rtl8192u/ieee80211/ieee80211.h @@ -329,12 +329,13 @@ typedef struct ieee_param { // linux under 2.6.9 release may not support it, so modify it for common use #define IEEE80211_DATA_LEN 2304 /* Maximum size for the MA-UNITDATA primitive, 802.11 standard section - 6.2.1.1.2. - - The figure in section 7.1.2 suggests a body size of up to 2312 - bytes is allowed, which is a bit confusing, I suspect this - represents the 2304 bytes of real data, plus a possible 8 bytes of - WEP IV and ICV. (this interpretation suggested by Ramiro Barreiro) */ + * 6.2.1.1.2. + * + * The figure in section 7.1.2 suggests a body size of up to 2312 + * bytes is allowed, which is a bit confusing, I suspect this + * represents the 2304 bytes of real data, plus a possible 8 bytes of + * WEP IV and ICV. (this interpretation suggested by Ramiro Barreiro) + */ #define IEEE80211_1ADDR_LEN 10 #define IEEE80211_2ADDR_LEN 16 #define IEEE80211_3ADDR_LEN 24 @@ -685,7 +686,8 @@ struct ieee_ibss_seq { /* NOTE: This data is for statistical purposes; not all hardware provides this * information for frames received. Not setting these will not cause - * any adverse affects. */ + * any adverse affects. + */ struct ieee80211_rx_stats { u32 mac_time[2]; s8 rssi; @@ -754,7 +756,8 @@ struct ieee80211_rx_stats { /* IEEE 802.11 requires that STA supports concurrent reception of at least * three fragmented frames. This define can be increased to support more * concurrent frames, but it should be noted that each entry can consume about - * 2 kB of RAM and increasing cache size will slow down frame reassembly. */ + * 2 kB of RAM and increasing cache size will slow down frame reassembly. + */ #define IEEE80211_FRAG_CACHE_LEN 4 struct ieee80211_frag_entry { @@ -836,15 +839,15 @@ struct ieee80211_security { /* - 802.11 data frame from AP - ,-------------------------------------------------------------------. -Bytes | 2 | 2 | 6 | 6 | 6 | 2 | 0..2312 | 4 | - |------|------|---------|---------|---------|------|---------|------| -Desc. | ctrl | dura | DA/RA | TA | SA | Sequ | frame | fcs | - | | tion | (BSSID) | | | ence | data | | - `-------------------------------------------------------------------' -Total: 28-2340 bytes -*/ + * 802.11 data frame from AP + * ,-------------------------------------------------------------------. + * Bytes | 2 | 2 | 6 | 6 | 6 | 2 | 0..2312 | 4 | + * |------|------|---------|---------|---------|------|---------|------| + * Desc. | ctrl | dura | DA/RA | TA | SA | Sequ | frame | fcs | + * | | tion | (BSSID) | | | ence | data | | + * `-------------------------------------------------------------------' + * Total: 28-2340 bytes + */ /* Management Frame Information Element Types */ enum ieee80211_mfie { @@ -882,7 +885,8 @@ enum ieee80211_mfie { /* Minimal header; can be used for passing 802.11 frames with sufficient * information to determine what type of underlying data type is actually - * stored in the data. */ + * stored in the data. + */ struct rtl_80211_hdr { __le16 frame_ctl; __le16 duration_id; @@ -980,7 +984,8 @@ struct ieee80211_probe_response { __le16 beacon_interval; __le16 capability; /* SSID, supported rates, FH params, DS params, - * CF params, IBSS params, TIM (if beacon), RSN */ + * CF params, IBSS params, TIM (if beacon), RSN + */ struct ieee80211_info_element info_element[0]; } __packed; @@ -1055,7 +1060,8 @@ typedef union _frameqos { /* MAX_RATES_LENGTH needs to be 12. The spec says 8, and many APs * only use 8, and then use extended rates for the remaining supported * rates. Other APs, however, stick all of their supported rates on the - * main rates information element... */ + * main rates information element... + */ #define MAX_RATES_LENGTH ((u8)12) #define MAX_RATES_EX_LENGTH ((u8)16) #define MAX_NETWORK_COUNT 128 @@ -1677,14 +1683,16 @@ struct ieee80211_device { spinlock_t wpax_suitlist_lock; int tx_headroom; /* Set to size of any additional room needed at front - * of allocated Tx SKBs */ + * of allocated Tx SKBs + */ u32 config; /* WEP and other encryption related settings at the device level */ int open_wep; /* Set to 1 to allow unencrypted frames */ int auth_mode; int reset_on_keychange; /* Set to 1 if the HW needs to be reset on - * WEP key changes */ + * WEP key changes + */ /* If the host performs {en,de}cryption, then set to 1 */ int host_encrypt; @@ -1719,7 +1727,8 @@ struct ieee80211_device { int crypt_quiesced; int bcrx_sta_key; /* use individual keys to override default keys even - * with RX of broad/multicast frames */ + * with RX of broad/multicast frames + */ /* Fragmentation structures */ // each streaming contain a entry @@ -2004,7 +2013,8 @@ struct ieee80211_device { void (*InitialGainHandler)(struct net_device *dev, u8 Operation); /* This must be the last item so that it points to the data - * allocated beyond this structure by alloc_ieee80211 */ + * allocated beyond this structure by alloc_ieee80211 + */ u8 priv[0]; }; @@ -2033,7 +2043,8 @@ struct ieee80211_device { /* The ieee802.11 stack will manages the netif queue * wake/stop for the driver, taking care of 802.11 - * fragmentation. See softmac.c for details. */ + * fragmentation. See softmac.c for details. + */ #define IEEE_SOFTMAC_TX_QUEUE (1<<7) /* Uses only the softmac_data_hard_start_xmit |