diff options
Diffstat (limited to 'include/asm-ia64/system.h')
| -rw-r--r-- | include/asm-ia64/system.h | 292 |
1 files changed, 0 insertions, 292 deletions
diff --git a/include/asm-ia64/system.h b/include/asm-ia64/system.h deleted file mode 100644 index 927a381c20ca..000000000000 --- a/include/asm-ia64/system.h +++ /dev/null @@ -1,292 +0,0 @@ -#ifndef _ASM_IA64_SYSTEM_H -#define _ASM_IA64_SYSTEM_H - -/* - * System defines. Note that this is included both from .c and .S - * files, so it does only defines, not any C code. This is based - * on information published in the Processor Abstraction Layer - * and the System Abstraction Layer manual. - * - * Copyright (C) 1998-2003 Hewlett-Packard Co - * David Mosberger-Tang <davidm@hpl.hp.com> - * Copyright (C) 1999 Asit Mallick <asit.k.mallick@intel.com> - * Copyright (C) 1999 Don Dugger <don.dugger@intel.com> - */ - -#include <asm/kregs.h> -#include <asm/page.h> -#include <asm/pal.h> -#include <asm/percpu.h> - -#define GATE_ADDR RGN_BASE(RGN_GATE) - -/* - * 0xa000000000000000+2*PERCPU_PAGE_SIZE - * - 0xa000000000000000+3*PERCPU_PAGE_SIZE remain unmapped (guard page) - */ -#define KERNEL_START (GATE_ADDR+__IA64_UL_CONST(0x100000000)) -#define PERCPU_ADDR (-PERCPU_PAGE_SIZE) -#define LOAD_OFFSET (KERNEL_START - KERNEL_TR_PAGE_SIZE) - -#ifndef __ASSEMBLY__ - -#include <linux/kernel.h> -#include <linux/types.h> - -#define AT_VECTOR_SIZE_ARCH 2 /* entries in ARCH_DLINFO */ - -struct pci_vector_struct { - __u16 segment; /* PCI Segment number */ - __u16 bus; /* PCI Bus number */ - __u32 pci_id; /* ACPI split 16 bits device, 16 bits function (see section 6.1.1) */ - __u8 pin; /* PCI PIN (0 = A, 1 = B, 2 = C, 3 = D) */ - __u32 irq; /* IRQ assigned */ -}; - -extern struct ia64_boot_param { - __u64 command_line; /* physical address of command line arguments */ - __u64 efi_systab; /* physical address of EFI system table */ - __u64 efi_memmap; /* physical address of EFI memory map */ - __u64 efi_memmap_size; /* size of EFI memory map */ - __u64 efi_memdesc_size; /* size of an EFI memory map descriptor */ - __u32 efi_memdesc_version; /* memory descriptor version */ - struct { - __u16 num_cols; /* number of columns on console output device */ - __u16 num_rows; /* number of rows on console output device */ - __u16 orig_x; /* cursor's x position */ - __u16 orig_y; /* cursor's y position */ - } console_info; - __u64 fpswa; /* physical address of the fpswa interface */ - __u64 initrd_start; - __u64 initrd_size; -} *ia64_boot_param; - -/* - * Macros to force memory ordering. In these descriptions, "previous" - * and "subsequent" refer to program order; "visible" means that all - * architecturally visible effects of a memory access have occurred - * (at a minimum, this means the memory has been read or written). - * - * wmb(): Guarantees that all preceding stores to memory- - * like regions are visible before any subsequent - * stores and that all following stores will be - * visible only after all previous stores. - * rmb(): Like wmb(), but for reads. - * mb(): wmb()/rmb() combo, i.e., all previous memory - * accesses are visible before all subsequent - * accesses and vice versa. This is also known as - * a "fence." - * - * Note: "mb()" and its variants cannot be used as a fence to order - * accesses to memory mapped I/O registers. For that, mf.a needs to - * be used. However, we don't want to always use mf.a because (a) - * it's (presumably) much slower than mf and (b) mf.a is supported for - * sequential memory pages only. - */ -#define mb() ia64_mf() -#define rmb() mb() -#define wmb() mb() -#define read_barrier_depends() do { } while(0) - -#ifdef CONFIG_SMP -# define smp_mb() mb() -# define smp_rmb() rmb() -# define smp_wmb() wmb() -# define smp_read_barrier_depends() read_barrier_depends() -#else -# define smp_mb() barrier() -# define smp_rmb() barrier() -# define smp_wmb() barrier() -# define smp_read_barrier_depends() do { } while(0) -#endif - -/* - * XXX check on this ---I suspect what Linus really wants here is - * acquire vs release semantics but we can't discuss this stuff with - * Linus just yet. Grrr... - */ -#define set_mb(var, value) do { (var) = (value); mb(); } while (0) - -#define safe_halt() ia64_pal_halt_light() /* PAL_HALT_LIGHT */ - -/* - * The group barrier in front of the rsm & ssm are necessary to ensure - * that none of the previous instructions in the same group are - * affected by the rsm/ssm. - */ -/* For spinlocks etc */ - -/* - * - clearing psr.i is implicitly serialized (visible by next insn) - * - setting psr.i requires data serialization - * - we need a stop-bit before reading PSR because we sometimes - * write a floating-point register right before reading the PSR - * and that writes to PSR.mfl - */ -#ifdef CONFIG_PARAVIRT -#define __local_save_flags() ia64_get_psr_i() -#else -#define __local_save_flags() ia64_getreg(_IA64_REG_PSR) -#endif - -#define __local_irq_save(x) \ -do { \ - ia64_stop(); \ - (x) = __local_save_flags(); \ - ia64_stop(); \ - ia64_rsm(IA64_PSR_I); \ -} while (0) - -#define __local_irq_disable() \ -do { \ - ia64_stop(); \ - ia64_rsm(IA64_PSR_I); \ -} while (0) - -#define __local_irq_restore(x) ia64_intrin_local_irq_restore((x) & IA64_PSR_I) - -#ifdef CONFIG_IA64_DEBUG_IRQ - - extern unsigned long last_cli_ip; - -# define __save_ip() last_cli_ip = ia64_getreg(_IA64_REG_IP) - -# define local_irq_save(x) \ -do { \ - unsigned long __psr; \ - \ - __local_irq_save(__psr); \ - if (__psr & IA64_PSR_I) \ - __save_ip(); \ - (x) = __psr; \ -} while (0) - -# define local_irq_disable() do { unsigned long __x; local_irq_save(__x); } while (0) - -# define local_irq_restore(x) \ -do { \ - unsigned long __old_psr, __psr = (x); \ - \ - local_save_flags(__old_psr); \ - __local_irq_restore(__psr); \ - if ((__old_psr & IA64_PSR_I) && !(__psr & IA64_PSR_I)) \ - __save_ip(); \ -} while (0) - -#else /* !CONFIG_IA64_DEBUG_IRQ */ -# define local_irq_save(x) __local_irq_save(x) -# define local_irq_disable() __local_irq_disable() -# define local_irq_restore(x) __local_irq_restore(x) -#endif /* !CONFIG_IA64_DEBUG_IRQ */ - -#define local_irq_enable() ({ ia64_stop(); ia64_ssm(IA64_PSR_I); ia64_srlz_d(); }) -#define local_save_flags(flags) ({ ia64_stop(); (flags) = __local_save_flags(); }) - -#define irqs_disabled() \ -({ \ - unsigned long __ia64_id_flags; \ - local_save_flags(__ia64_id_flags); \ - (__ia64_id_flags & IA64_PSR_I) == 0; \ -}) - -#ifdef __KERNEL__ - -#ifdef CONFIG_IA32_SUPPORT -# define IS_IA32_PROCESS(regs) (ia64_psr(regs)->is != 0) -#else -# define IS_IA32_PROCESS(regs) 0 -struct task_struct; -static inline void ia32_save_state(struct task_struct *t __attribute__((unused))){} -static inline void ia32_load_state(struct task_struct *t __attribute__((unused))){} -#endif - -/* - * Context switch from one thread to another. If the two threads have - * different address spaces, schedule() has already taken care of - * switching to the new address space by calling switch_mm(). - * - * Disabling access to the fph partition and the debug-register - * context switch MUST be done before calling ia64_switch_to() since a - * newly created thread returns directly to - * ia64_ret_from_syscall_clear_r8. - */ -extern struct task_struct *ia64_switch_to (void *next_task); - -struct task_struct; - -extern void ia64_save_extra (struct task_struct *task); -extern void ia64_load_extra (struct task_struct *task); - -#ifdef CONFIG_VIRT_CPU_ACCOUNTING -extern void ia64_account_on_switch (struct task_struct *prev, struct task_struct *next); -# define IA64_ACCOUNT_ON_SWITCH(p,n) ia64_account_on_switch(p,n) -#else -# define IA64_ACCOUNT_ON_SWITCH(p,n) -#endif - -#ifdef CONFIG_PERFMON - DECLARE_PER_CPU(unsigned long, pfm_syst_info); -# define PERFMON_IS_SYSWIDE() (__get_cpu_var(pfm_syst_info) & 0x1) -#else -# define PERFMON_IS_SYSWIDE() (0) -#endif - -#define IA64_HAS_EXTRA_STATE(t) \ - ((t)->thread.flags & (IA64_THREAD_DBG_VALID|IA64_THREAD_PM_VALID) \ - || IS_IA32_PROCESS(task_pt_regs(t)) || PERFMON_IS_SYSWIDE()) - -#define __switch_to(prev,next,last) do { \ - IA64_ACCOUNT_ON_SWITCH(prev, next); \ - if (IA64_HAS_EXTRA_STATE(prev)) \ - ia64_save_extra(prev); \ - if (IA64_HAS_EXTRA_STATE(next)) \ - ia64_load_extra(next); \ - ia64_psr(task_pt_regs(next))->dfh = !ia64_is_local_fpu_owner(next); \ - (last) = ia64_switch_to((next)); \ -} while (0) - -#ifdef CONFIG_SMP -/* - * In the SMP case, we save the fph state when context-switching away from a thread that - * modified fph. This way, when the thread gets scheduled on another CPU, the CPU can - * pick up the state from task->thread.fph, avoiding the complication of having to fetch - * the latest fph state from another CPU. In other words: eager save, lazy restore. - */ -# define switch_to(prev,next,last) do { \ - if (ia64_psr(task_pt_regs(prev))->mfh && ia64_is_local_fpu_owner(prev)) { \ - ia64_psr(task_pt_regs(prev))->mfh = 0; \ - (prev)->thread.flags |= IA64_THREAD_FPH_VALID; \ - __ia64_save_fpu((prev)->thread.fph); \ - } \ - __switch_to(prev, next, last); \ - /* "next" in old context is "current" in new context */ \ - if (unlikely((current->thread.flags & IA64_THREAD_MIGRATION) && \ - (task_cpu(current) != \ - task_thread_info(current)->last_cpu))) { \ - platform_migrate(current); \ - task_thread_info(current)->last_cpu = task_cpu(current); \ - } \ -} while (0) -#else -# define switch_to(prev,next,last) __switch_to(prev, next, last) -#endif - -#define __ARCH_WANT_UNLOCKED_CTXSW -#define ARCH_HAS_PREFETCH_SWITCH_STACK -#define ia64_platform_is(x) (strcmp(x, platform_name) == 0) - -void cpu_idle_wait(void); - -#define arch_align_stack(x) (x) - -void default_idle(void); - -#ifdef CONFIG_VIRT_CPU_ACCOUNTING -extern void account_system_vtime(struct task_struct *); -#endif - -#endif /* __KERNEL__ */ - -#endif /* __ASSEMBLY__ */ - -#endif /* _ASM_IA64_SYSTEM_H */ |