From 636752bcb5177a301d0266270661581de8624828 Mon Sep 17 00:00:00 2001 From: Daniel Kurtz Date: Tue, 24 Jul 2012 14:13:58 +0200 Subject: i2c-i801: Enable IRQ for SMBus transactions Add a new 'feature' to i2c-i801 to enable using PCI interrupts. When the feature is enabled, then an isr is installed for the device's PCI IRQ. An I2C/SMBus transaction is always terminated by one of the following interrupt sources: FAILED, BUS_ERR, DEV_ERR, or on success: INTR. When the isr fires for one of these cases, it sets the ->status variable and wakes up the waitq. The waitq then saves off the status code, and clears ->status (in preparation for some future transaction). The SMBus controller generates an INTR irq at the end of each transaction where INTREN was set in the HST_CNT register. No locking is needed around accesses to priv->status since all writes to it are serialized: it is only ever set once in the isr at the end of a transaction, and cleared while no interrupts can occur. In addition, the I2C adapter lock guarantees that entire I2C transactions for a single adapter are always serialized. For this patch, the INTREN bit is set only for SMBus block, byte and word transactions, but not for I2C reads or writes. The use of the DS (BYTE_DONE) interrupt with byte-by-byte I2C transactions is implemented in a subsequent patch. The interrupt feature has only been enabled for COUGARPOINT hardware. In addition, it is disabled if SMBus is using the SMI# interrupt. Signed-off-by: Daniel Kurtz Signed-off-by: Jean Delvare --- Documentation/i2c/busses/i2c-i801 | 13 ++++++++++--- 1 file changed, 10 insertions(+), 3 deletions(-) (limited to 'Documentation/i2c') diff --git a/Documentation/i2c/busses/i2c-i801 b/Documentation/i2c/busses/i2c-i801 index 71f55bbcefc8..615142da4ef6 100644 --- a/Documentation/i2c/busses/i2c-i801 +++ b/Documentation/i2c/busses/i2c-i801 @@ -38,9 +38,10 @@ Module Parameters Disable selected features normally supported by the device. This makes it possible to work around possible driver or hardware bugs if the feature in question doesn't work as intended for whatever reason. Bit values: - 1 disable SMBus PEC - 2 disable the block buffer - 8 disable the I2C block read functionality + 0x01 disable SMBus PEC + 0x02 disable the block buffer + 0x08 disable the I2C block read functionality + 0x10 don't use interrupts Description @@ -86,6 +87,12 @@ SMBus 2.0 Support The 82801DB (ICH4) and later chips support several SMBus 2.0 features. +Interrupt Support +----------------- + +PCI interrupt support is supported on the 82801EB (ICH5) and later chips. + + Hidden ICH SMBus ---------------- -- cgit v1.2.3