From 8d4ef88b5df1afe097e38aef8cab2ed35ca141ea Mon Sep 17 00:00:00 2001 From: Satyam Sharma Date: Fri, 10 Aug 2007 15:31:19 -0700 Subject: [NET] netconsole: Add some useful tips to documentation Based upon initial work by Keiichi Kii . Add some useful general-purpose tips. Also suggest solution for the frequent problem of console loglevel set too low numerically (i.e. for high priority messages only) on the sender. Signed-off-by: Satyam Sharma Acked-by: Keiichi Kii Acked-by: Matt Mackall Signed-off-by: Andrew Morton Signed-off-by: David S. Miller --- Documentation/networking/netconsole.txt | 25 +++++++++++++++++++++++++ 1 file changed, 25 insertions(+) (limited to 'Documentation/networking') diff --git a/Documentation/networking/netconsole.txt b/Documentation/networking/netconsole.txt index 1caa6c734691..5962f45815a2 100644 --- a/Documentation/networking/netconsole.txt +++ b/Documentation/networking/netconsole.txt @@ -44,11 +44,36 @@ WARNING: the default target ethernet setting uses the broadcast ethernet address to send packets, which can cause increased load on other systems on the same ethernet segment. +TIP: some LAN switches may be configured to suppress ethernet broadcasts +so it is advised to explicitly specify the remote agents' MAC addresses +from the config parameters passed to netconsole. + +TIP: to find out the MAC address of, say, 10.0.0.2, you may try using: + + ping -c 1 10.0.0.2 ; /sbin/arp -n | grep 10.0.0.2 + +TIP: in case the remote logging agent is on a separate LAN subnet than +the sender, it is suggested to try specifying the MAC address of the +default gateway (you may use /sbin/route -n to find it out) as the +remote MAC address instead. + NOTE: the network device (eth1 in the above case) can run any kind of other network traffic, netconsole is not intrusive. Netconsole might cause slight delays in other traffic if the volume of kernel messages is high, but should have no other impact. +NOTE: if you find that the remote logging agent is not receiving or +printing all messages from the sender, it is likely that you have set +the "console_loglevel" parameter (on the sender) to only send high +priority messages to the console. You can change this at runtime using: + + dmesg -n 8 + +or by specifying "debug" on the kernel command line at boot, to send +all kernel messages to the console. A specific value for this parameter +can also be set using the "loglevel" kernel boot option. See the +dmesg(8) man page and Documentation/kernel-parameters.txt for details. + Netconsole was designed to be as instantaneous as possible, to enable the logging of even the most critical kernel bugs. It works from IRQ contexts as well, and does not enable interrupts while -- cgit v1.2.3