From 2a500afe1e0e84c7a126df693dbd01353756dcfa Mon Sep 17 00:00:00 2001 From: =?UTF-8?q?Lothar=20Wa=C3=9Fmann?= Date: Fri, 28 Mar 2014 11:35:06 +0100 Subject: mtd: gpmi: make blockmark swapping optional MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit With a flash-based BBT there is no reason to move the Factory Bad Block Marker from the data area buffer (to where it is mapped by the GPMI NAND controller) to the OOB buffer. Thus, make this feature configurable via DT. This is required for the Ka-Ro electronics platforms. In the original code 'this->swap_block_mark' was synonymous with '!GPMI_IS_MX23()', so use the latter at the relevant places. Signed-off-by: Lothar Waßmann Acked-by: Huang Shijie Signed-off-by: Brian Norris --- Documentation/devicetree/bindings/mtd/gpmi-nand.txt | 10 ++++++++++ 1 file changed, 10 insertions(+) (limited to 'Documentation') diff --git a/Documentation/devicetree/bindings/mtd/gpmi-nand.txt b/Documentation/devicetree/bindings/mtd/gpmi-nand.txt index 458d59634688..a011fdf61dbf 100644 --- a/Documentation/devicetree/bindings/mtd/gpmi-nand.txt +++ b/Documentation/devicetree/bindings/mtd/gpmi-nand.txt @@ -25,6 +25,16 @@ Optional properties: discoverable or this property is not enabled, the software may chooses an implementation-defined ECC scheme. + - fsl,no-blockmark-swap: Don't swap the bad block marker from the OOB + area with the byte in the data area but rely on the + flash based BBT for identifying bad blocks. + NOTE: this is only valid in conjunction with + 'nand-on-flash-bbt'. + WARNING: on i.MX28 blockmark swapping cannot be + disabled for the BootROM in the FCB. Thus, + partitions written from Linux with this feature + turned on may not be accessible by the BootROM + code. The device tree may optionally contain sub-nodes describing partitions of the address space. See partition.txt for more detail. -- cgit v1.2.3