From 9e0e9e85e74e4893dc5a2c5a6da54f64cf45290e Mon Sep 17 00:00:00 2001 From: Jarkko Nikula Date: Thu, 9 Nov 2023 15:37:05 +0200 Subject: i3c: mipi-i3c-hci: Report NACK response from CCC command to core Currently probe of mipi-i3c-hci will fail if bus doesn't have any I3C devices connected. This happens when CCC commands that are sent during i3c_master_bus_init() are not ACKed by any device and controller responds with an error status set. The controller can detect NACK both during I3C address header transmission (broadcast address 0x7e is not ACKed) and when target device address or dynamic address assignment is NACKed. Former as error status 0x4: Address Header Error and latter as 0x5: NACK. Difference between those two NACK statuses were not described explicitly until MIPI I3C HCI Specification v1.1. Earlier versions share the same error status code though. Report both of those as I3C_ERROR_M2 to I3C core code. Signed-off-by: Jarkko Nikula Link: https://lore.kernel.org/r/20231109133708.653950-2-jarkko.nikula@linux.intel.com Signed-off-by: Alexandre Belloni --- drivers/i3c/master/mipi-i3c-hci/core.c | 9 ++++++++- 1 file changed, 8 insertions(+), 1 deletion(-) (limited to 'drivers/i3c') diff --git a/drivers/i3c/master/mipi-i3c-hci/core.c b/drivers/i3c/master/mipi-i3c-hci/core.c index 1ae56a5699c6..8471a1fe1dad 100644 --- a/drivers/i3c/master/mipi-i3c-hci/core.c +++ b/drivers/i3c/master/mipi-i3c-hci/core.c @@ -245,7 +245,14 @@ static int i3c_hci_send_ccc_cmd(struct i3c_master_controller *m, if (ccc->rnw) ccc->dests[i - prefixed].payload.len = RESP_DATA_LENGTH(xfer[i].response); - if (RESP_STATUS(xfer[i].response) != RESP_SUCCESS) { + switch (RESP_STATUS(xfer[i].response)) { + case RESP_SUCCESS: + continue; + case RESP_ERR_ADDR_HEADER: + case RESP_ERR_NACK: + ccc->err = I3C_ERROR_M2; + fallthrough; + default: ret = -EIO; goto out; } -- cgit v1.2.3