From b0ac9564061265dd14e6f8f777622e3401b82b4b Mon Sep 17 00:00:00 2001 From: Florian Fainelli Date: Thu, 5 Dec 2013 14:52:15 -0800 Subject: arc_emac: remove custom "max-speed" parsing code The ARC emac driver was the only in-tree to parse a PHY device 'max-speed' property but yet failed to do it correctly because 'max-speed' is supposed to set a PHY device supported features, not the advertising features as it was done. Now that of_mdiobus_register() takes care of doing that, remove the custom 'max-speed' parsing code. Signed-off-by: Florian Fainelli Signed-off-by: David S. Miller --- drivers/net/ethernet/arc/emac_main.c | 20 +------------------- 1 file changed, 1 insertion(+), 19 deletions(-) (limited to 'drivers/net/ethernet/arc/emac_main.c') diff --git a/drivers/net/ethernet/arc/emac_main.c b/drivers/net/ethernet/arc/emac_main.c index b2ffad1304d2..eedf2a5fc2be 100644 --- a/drivers/net/ethernet/arc/emac_main.c +++ b/drivers/net/ethernet/arc/emac_main.c @@ -381,17 +381,7 @@ static int arc_emac_open(struct net_device *ndev) phy_dev->autoneg = AUTONEG_ENABLE; phy_dev->speed = 0; phy_dev->duplex = 0; - phy_dev->advertising = phy_dev->supported; - - if (priv->max_speed > 100) { - phy_dev->advertising &= PHY_GBIT_FEATURES; - } else if (priv->max_speed <= 100) { - phy_dev->advertising &= PHY_BASIC_FEATURES; - if (priv->max_speed <= 10) { - phy_dev->advertising &= ~SUPPORTED_100baseT_Half; - phy_dev->advertising &= ~SUPPORTED_100baseT_Full; - } - } + phy_dev->advertising &= phy_dev->supported; priv->last_rx_bd = 0; @@ -704,14 +694,6 @@ static int arc_emac_probe(struct platform_device *pdev) /* Set poll rate so that it polls every 1 ms */ arc_reg_set(priv, R_POLLRATE, clock_frequency / 1000000); - /* Get max speed of operation from device tree */ - if (of_property_read_u32(pdev->dev.of_node, "max-speed", - &priv->max_speed)) { - dev_err(&pdev->dev, "failed to retrieve from device tree\n"); - err = -EINVAL; - goto out; - } - ndev->irq = irq; dev_info(&pdev->dev, "IRQ is %d\n", ndev->irq); -- cgit v1.2.3