From 3969eb48ad7f3f3bef61f5474b7214e601fd2d75 Mon Sep 17 00:00:00 2001 From: Boris BREZILLON Date: Tue, 23 Sep 2014 13:16:05 +0200 Subject: rtc: at91sam9: rework the Kconfig description Remove all references to AT91CAP9 SoC which has been removed. Rework help message to remove any specific references to AT91SAM9 SoCs. State that RTC_DRV_AT91SAM9_RTT and RTC_DRV_AT91SAM9_GPBR options are only used when booting non DT boards. Signed-off-by: Boris BREZILLON Acked-by: Johan Hovold Acked-by: Arnd Bergmann Signed-off-by: Nicolas Ferre --- drivers/rtc/Kconfig | 23 +++++++++++++++-------- 1 file changed, 15 insertions(+), 8 deletions(-) (limited to 'drivers/rtc') diff --git a/drivers/rtc/Kconfig b/drivers/rtc/Kconfig index 7b1f59258062..5bdd6524f91b 100644 --- a/drivers/rtc/Kconfig +++ b/drivers/rtc/Kconfig @@ -1109,17 +1109,18 @@ config RTC_DRV_AT91RM9200 this is powered by the backup power supply. config RTC_DRV_AT91SAM9 - tristate "AT91SAM9x/AT91CAP9 RTT as RTC" + tristate "AT91SAM9 RTT as RTC" depends on ARCH_AT91 && !(ARCH_AT91RM9200 || ARCH_AT91X40) select MFD_SYSCON help - RTC driver for the Atmel AT91SAM9x and AT91CAP9 internal RTT - (Real Time Timer). These timers are powered by the backup power - supply (such as a small coin cell battery), but do not need to - be used as RTCs. - - (On AT91SAM9rl and AT91SAM9G45 chips you probably want to use the - dedicated RTC module and leave the RTT available for other uses.) + Some AT91SAM9 SoCs provide an RTT (Real Time Timer) block which + can be used as an RTC thanks to the backup power supply (e.g. a + small coin cell battery) which keeps this block and the GPBR + (General Purpose Backup Registers) block powered when the device + is shutdown. + Some AT91SAM9 SoCs provide a real RTC block, on those ones you'd + probably want to use the real RTC block instead of the "RTT as an + RTC" driver. config RTC_DRV_AT91SAM9_RTT int @@ -1128,6 +1129,9 @@ config RTC_DRV_AT91SAM9_RTT prompt "RTT module Number" if ARCH_AT91SAM9263 depends on RTC_DRV_AT91SAM9 help + This option is only relevant for legacy board support and + won't be used when booting a DT board. + More than one RTT module is available. You can choose which one will be used as an RTC. The default of zero is normally OK to use, though some systems use that for non-RTC purposes. @@ -1140,6 +1144,9 @@ config RTC_DRV_AT91SAM9_GPBR prompt "Backup Register Number" depends on RTC_DRV_AT91SAM9 help + This option is only relevant for legacy board support and + won't be used when booting a DT board. + The RTC driver needs to use one of the General Purpose Backup Registers (GPBRs) as well as the RTT. You can choose which one will be used. The default of zero is normally OK to use, but -- cgit v1.2.3