1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
|
#ifndef _ASM_X86_PGTABLE_3LEVEL_H
#define _ASM_X86_PGTABLE_3LEVEL_H
/*
* Intel Physical Address Extension (PAE) Mode - three-level page
* tables on PPro+ CPUs.
*
* Copyright (C) 1999 Ingo Molnar <mingo@redhat.com>
*/
#define pte_ERROR(e) \
pr_err("%s:%d: bad pte %p(%08lx%08lx)\n", \
__FILE__, __LINE__, &(e), (e).pte_high, (e).pte_low)
#define pmd_ERROR(e) \
pr_err("%s:%d: bad pmd %p(%016Lx)\n", \
__FILE__, __LINE__, &(e), pmd_val(e))
#define pgd_ERROR(e) \
pr_err("%s:%d: bad pgd %p(%016Lx)\n", \
__FILE__, __LINE__, &(e), pgd_val(e))
/* Rules for using set_pte: the pte being assigned *must* be
* either not present or in a state where the hardware will
* not attempt to update the pte. In places where this is
* not possible, use pte_get_and_clear to obtain the old pte
* value and then use set_pte to update it. -ben
*/
static inline void native_set_pte(pte_t *ptep, pte_t pte)
{
ptep->pte_high = pte.pte_high;
smp_wmb();
ptep->pte_low = pte.pte_low;
}
#define pmd_read_atomic pmd_read_atomic
/*
* pte_offset_map_lock on 32bit PAE kernels was reading the pmd_t with
* a "*pmdp" dereference done by gcc. Problem is, in certain places
* where pte_offset_map_lock is called, concurrent page faults are
* allowed, if the mmap_sem is hold for reading. An example is mincore
* vs page faults vs MADV_DONTNEED. On the page fault side
* pmd_populate rightfully does a set_64bit, but if we're reading the
* pmd_t with a "*pmdp" on the mincore side, a SMP race can happen
* because gcc will not read the 64bit of the pmd atomically. To fix
* this all places running pmd_offset_map_lock() while holding the
* mmap_sem in read mode, shall read the pmdp pointer using this
* function to know if the pmd is null nor not, and in turn to know if
* they can run pmd_offset_map_lock or pmd_trans_huge or other pmd
* operations.
*
* Without THP if the mmap_sem is hold for reading, the pmd can only
* transition from null to not null while pmd_read_atomic runs. So
* we can always return atomic pmd values with this function.
*
* With THP if the mmap_sem is hold for reading, the pmd can become
* trans_huge or none or point to a pte (and in turn become "stable")
* at any time under pmd_read_atomic. We could read it really
* atomically here with a atomic64_read for the THP enabled case (and
* it would be a whole lot simpler), but to avoid using cmpxchg8b we
* only return an atomic pmdval if the low part of the pmdval is later
* found stable (i.e. pointing to a pte). And we're returning a none
* pmdval if the low part of the pmd is none. In some cases the high
* and low part of the pmdval returned may not be consistent if THP is
* enabled (the low part may point to previously mapped hugepage,
* while the high part may point to a more recently mapped hugepage),
* but pmd_none_or_trans_huge_or_clear_bad() only needs the low part
* of the pmd to be read atomically to decide if the pmd is unstable
* or not, with the only exception of when the low part of the pmd is
* zero in which case we return a none pmd.
*/
static inline pmd_t pmd_read_atomic(pmd_t *pmdp)
{
pmdval_t ret;
u32 *tmp = (u32 *)pmdp;
ret = (pmdval_t) (*tmp);
if (ret) {
/*
* If the low part is null, we must not read the high part
* or we can end up with a partial pmd.
*/
smp_rmb();
ret |= ((pmdval_t)*(tmp + 1)) << 32;
}
return (pmd_t) { ret };
}
static inline void native_set_pte_atomic(pte_t *ptep, pte_t pte)
{
set_64bit((unsigned long long *)(ptep), native_pte_val(pte));
}
static inline void native_set_pmd(pmd_t *pmdp, pmd_t pmd)
{
set_64bit((unsigned long long *)(pmdp), native_pmd_val(pmd));
}
static inline void native_set_pud(pud_t *pudp, pud_t pud)
{
set_64bit((unsigned long long *)(pudp), native_pud_val(pud));
}
/*
* For PTEs and PDEs, we must clear the P-bit first when clearing a page table
* entry, so clear the bottom half first and enforce ordering with a compiler
* barrier.
*/
static inline void native_pte_clear(struct mm_struct *mm, unsigned long addr,
pte_t *ptep)
{
ptep->pte_low = 0;
smp_wmb();
ptep->pte_high = 0;
}
static inline void native_pmd_clear(pmd_t *pmd)
{
u32 *tmp = (u32 *)pmd;
*tmp = 0;
smp_wmb();
*(tmp + 1) = 0;
}
#if !defined(CONFIG_SMP) || (defined(CONFIG_HIGHMEM64G) && \
defined(CONFIG_PARAVIRT))
static inline void native_pud_clear(pud_t *pudp)
{
}
#endif
static inline void pud_clear(pud_t *pudp)
{
set_pud(pudp, __pud(0));
/*
* According to Intel App note "TLBs, Paging-Structure Caches,
* and Their Invalidation", April 2007, document 317080-001,
* section 8.1: in PAE mode we explicitly have to flush the
* TLB via cr3 if the top-level pgd is changed...
*
* Currently all places where pud_clear() is called either have
* flush_tlb_mm() followed or don't need TLB flush (x86_64 code or
* pud_clear_bad()), so we don't need TLB flush here.
*/
}
#ifdef CONFIG_SMP
static inline pte_t native_ptep_get_and_clear(pte_t *ptep)
{
pte_t res;
/* xchg acts as a barrier before the setting of the high bits */
res.pte_low = xchg(&ptep->pte_low, 0);
res.pte_high = ptep->pte_high;
ptep->pte_high = 0;
return res;
}
#else
#define native_ptep_get_and_clear(xp) native_local_ptep_get_and_clear(xp)
#endif
#ifdef CONFIG_SMP
union split_pmd {
struct {
u32 pmd_low;
u32 pmd_high;
};
pmd_t pmd;
};
static inline pmd_t native_pmdp_get_and_clear(pmd_t *pmdp)
{
union split_pmd res, *orig = (union split_pmd *)pmdp;
/* xchg acts as a barrier before setting of the high bits */
res.pmd_low = xchg(&orig->pmd_low, 0);
res.pmd_high = orig->pmd_high;
orig->pmd_high = 0;
return res.pmd;
}
#else
#define native_pmdp_get_and_clear(xp) native_local_pmdp_get_and_clear(xp)
#endif
#ifdef CONFIG_SMP
union split_pud {
struct {
u32 pud_low;
u32 pud_high;
};
pud_t pud;
};
static inline pud_t native_pudp_get_and_clear(pud_t *pudp)
{
union split_pud res, *orig = (union split_pud *)pudp;
/* xchg acts as a barrier before setting of the high bits */
res.pud_low = xchg(&orig->pud_low, 0);
res.pud_high = orig->pud_high;
orig->pud_high = 0;
return res.pud;
}
#else
#define native_pudp_get_and_clear(xp) native_local_pudp_get_and_clear(xp)
#endif
/* Encode and de-code a swap entry */
#define MAX_SWAPFILES_CHECK() BUILD_BUG_ON(MAX_SWAPFILES_SHIFT > 5)
#define __swp_type(x) (((x).val) & 0x1f)
#define __swp_offset(x) ((x).val >> 5)
#define __swp_entry(type, offset) ((swp_entry_t){(type) | (offset) << 5})
#define __pte_to_swp_entry(pte) ((swp_entry_t){ (pte).pte_high })
#define __swp_entry_to_pte(x) ((pte_t){ { .pte_high = (x).val } })
#define gup_get_pte gup_get_pte
/*
* WARNING: only to be used in the get_user_pages_fast() implementation.
*
* With get_user_pages_fast(), we walk down the pagetables without taking
* any locks. For this we would like to load the pointers atomically,
* but that is not possible (without expensive cmpxchg8b) on PAE. What
* we do have is the guarantee that a PTE will only either go from not
* present to present, or present to not present or both -- it will not
* switch to a completely different present page without a TLB flush in
* between; something that we are blocking by holding interrupts off.
*
* Setting ptes from not present to present goes:
*
* ptep->pte_high = h;
* smp_wmb();
* ptep->pte_low = l;
*
* And present to not present goes:
*
* ptep->pte_low = 0;
* smp_wmb();
* ptep->pte_high = 0;
*
* We must ensure here that the load of pte_low sees 'l' iff pte_high
* sees 'h'. We load pte_high *after* loading pte_low, which ensures we
* don't see an older value of pte_high. *Then* we recheck pte_low,
* which ensures that we haven't picked up a changed pte high. We might
* have gotten rubbish values from pte_low and pte_high, but we are
* guaranteed that pte_low will not have the present bit set *unless*
* it is 'l'. Because get_user_pages_fast() only operates on present ptes
* we're safe.
*/
static inline pte_t gup_get_pte(pte_t *ptep)
{
pte_t pte;
do {
pte.pte_low = ptep->pte_low;
smp_rmb();
pte.pte_high = ptep->pte_high;
smp_rmb();
} while (unlikely(pte.pte_low != ptep->pte_low));
return pte;
}
#endif /* _ASM_X86_PGTABLE_3LEVEL_H */
|