soc/amd/common/block/gpio_banks: Use configure_scimap()

There is no need to stash the SCI trigger register configuration and
apply it at the end. Remove this to make SCI and SMI programming more
symmetrical and to use available configure_scimap function instead of
implementing it again, but without the additional checks. Using this
function also allows removing soc_route_sci.

Change-Id: Ie23da79546858282910db65182a6315ade506279
Signed-off-by: Kyösti Mälkki <kyosti.malkki@gmail.com>
Signed-off-by: Felix Held <felix-coreboot@felixheld.de>
Reviewed-on: https://review.coreboot.org/c/coreboot/+/43012
Tested-by: build bot (Jenkins) <no-reply@coreboot.org>
Reviewed-by: Marshall Dawson <marshalldawson3rd@gmail.com>

1 files changed, 12 insertions, 40 deletions

diff --git a/src/soc/amd/common/block/gpio_banks/gpio.c b/src/soc/amd/common/block/gpio_banks/gpio.c
index 1d664cb54a3e..711b779e5160 100644
--- a/src/soc/amd/common/block/gpio_banks/gpio.c
+++ b/src/soc/amd/common/block/gpio_banks/gpio.c
@@ -45,12 +45,6 @@ static void program_smi(uint32_t flags, int gevent_num)
 	configure_gevent_smi(gevent_num, SMI_MODE_SMI, level);
 }
 
-struct sci_trigger_regs {
-	uint32_t mask;
-	uint32_t polarity;
-	uint32_t level;
-};
-
 /*
  * For each general purpose event, GPE, the choice of edge/level triggered
  * event is represented as a single bit in SMI_SCI_LEVEL register.
@@ -58,37 +52,24 @@ struct sci_trigger_regs {
  * In a similar fashion, polarity (rising/falling, hi/lo) of each GPE is
  * represented as a single bit in SMI_SCI_TRIG register.
  */
-static void fill_sci_trigger(uint32_t flags, int gpe, struct sci_trigger_regs *regs)
+static void program_sci(uint32_t flags, int gevent_num)
 {
-	uint32_t mask = 1 << gpe;
+	struct sci_source sci;
 
-	regs->mask |= mask;
+	sci.scimap = gevent_num;
+	sci.gpe = gevent_num;
 
 	if (is_gpio_event_level_triggered(flags))
-		regs->level |= mask;
+		sci.level = SMI_SCI_LVL;
 	else
-		regs->level &= ~mask;
+		sci.level = SMI_SCI_EDG;
 
 	if (is_gpio_event_active_high(flags))
-		regs->polarity |= mask;
+		sci.direction = SMI_SCI_LVL_HIGH;
 	else
-		regs->polarity &= ~mask;
-}
-
-/* TODO: See configure_scimap() implementations. */
-static void set_sci_trigger(const struct sci_trigger_regs *regs)
-{
-	uint32_t value;
+		sci.direction = SMI_SCI_LVL_LOW;
 
-	value = smi_read32(SMI_SCI_TRIG);
-	value &= ~regs->mask;
-	value |= regs->polarity;
-	smi_write32(SMI_SCI_TRIG, value);
-
-	value = smi_read32(SMI_SCI_LEVEL);
-	value &= ~regs->mask;
-	value |= regs->level;
-	smi_write32(SMI_SCI_LEVEL, value);
+	configure_scimap(&sci);
 }
 
 uintptr_t gpio_get_address(gpio_t gpio_num)
@@ -179,8 +160,7 @@ uint16_t gpio_acpi_pin(gpio_t gpio)
 	return gpio;
 }
 
-static void set_single_gpio(const struct soc_amd_gpio *g,
-			    struct sci_trigger_regs *sci_trigger_cfg)
+static void set_single_gpio(const struct soc_amd_gpio *g)
 {
 	static const struct soc_amd_event *gev_tbl;
 	static size_t gev_items;
@@ -214,16 +194,12 @@ static void set_single_gpio(const struct soc_amd_gpio *g,
 	if (g->flags & GPIO_FLAG_SMI) {
 		program_smi(g->flags, gevent_num);
 	} else if (g->flags & GPIO_FLAG_SCI) {
-		fill_sci_trigger(g->flags, gevent_num, sci_trigger_cfg);
-		soc_route_sci(gevent_num);
+		program_sci(g->flags, gevent_num);
 	}
 }
 
 void program_gpios(const struct soc_amd_gpio *gpio_list_ptr, size_t size)
 {
-	struct sci_trigger_regs sci_trigger_cfg = { 0 };
-	const bool can_set_smi_flags = !(CONFIG(VBOOT_STARTS_BEFORE_BOOTBLOCK) &&
-			ENV_SEPARATE_VERSTAGE);
 	size_t i;
 
 	if (!gpio_list_ptr || !size)
@@ -242,7 +218,7 @@ void program_gpios(const struct soc_amd_gpio *gpio_list_ptr, size_t size)
 	master_switch_clr(GPIO_MASK_STS_EN | GPIO_INTERRUPT_EN);
 
 	for (i = 0; i < size; i++)
-		set_single_gpio(&gpio_list_ptr[i], &sci_trigger_cfg);
+		set_single_gpio(&gpio_list_ptr[i]);
 
 	/*
 	 * Re-enable interrupt status generation.
@@ -252,10 +228,6 @@ void program_gpios(const struct soc_amd_gpio *gpio_list_ptr, size_t size)
 	 * to be missed during boot.
 	 */
 	master_switch_set(GPIO_INTERRUPT_EN);
-
-	/* Set all SCI trigger polarity (high/low) and level (edge/level). */
-	if (can_set_smi_flags)
-		set_sci_trigger(&sci_trigger_cfg);
 }
 
 int gpio_interrupt_status(gpio_t gpio)