1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
|
/* SPDX-License-Identifier: GPL-2.0-only */
#include <console/console.h>
#include <arch/io.h>
#include <device/mmio.h>
#include <device/pci.h>
#include <soc/gpio.h>
#include <soc/pm.h>
#include <soc/smm.h>
#define GPIO_DEBUG
/* gpio map to pad number LUTs */
static const u8 gpncommunity_gpio_to_pad[GP_NORTH_COUNT] = {
0, 1, 2, 3, 4, 5, 6, 7, 8, 15,
16, 17, 18, 19, 20, 21, 22, 23, 24, 25,
26, 27, 30, 31, 32, 33, 34, 35, 36, 37,
38, 39, 40, 41, 45, 46, 47, 48, 49, 50,
51, 52, 53, 54, 55, 56, 60, 61, 62, 63,
64, 65, 66, 67, 68, 69, 70, 71, 72 };
static const u8 gpsecommunity_gpio_to_pad[GP_SOUTHEAST_COUNT] = {
0, 1, 2, 3, 4, 5, 6, 7, 15, 16,
17, 18, 19, 20, 21, 22, 23, 24, 25, 26,
30, 31, 32, 33, 34, 35, 45, 46, 47, 48,
49, 50, 51, 52, 60, 61, 62, 63, 64, 65,
66, 67, 68, 69, 75, 76, 77, 78, 79, 80,
81, 82, 83, 84, 85 };
static const u8 gpswcommunity_gpio_to_pad[GP_SOUTHWEST_COUNT] = {
0, 1, 2, 3, 4, 5, 6, 7, 15, 16,
17, 18, 19, 20, 21, 22, 30, 31, 32, 33,
34, 35, 36, 37, 45, 46, 47, 48, 49, 50,
51, 52, 60, 61, 62, 63, 64, 65, 66, 67,
75, 76, 77, 78, 79, 80, 81, 82, 90, 91,
92, 93, 94, 95, 96, 97 };
static const u8 gpecommunity_gpio_to_pad[GP_EAST_COUNT] = {
0, 1, 2, 3, 4, 5, 6, 7, 8, 9,
10, 11, 15, 16, 17, 18, 19, 20, 21, 22,
23, 24, 25, 26 };
/* GPIO Community descriptions */
static const struct gpio_bank gpnorth_community = {
.gpio_count = GP_NORTH_COUNT,
.gpio_to_pad = gpncommunity_gpio_to_pad,
.pad_base = COMMUNITY_GPNORTH_BASE,
.has_gpe_en = GPE_CAPABLE,
.has_wake_en = 1,
};
static const struct gpio_bank gpsoutheast_community = {
.gpio_count = GP_SOUTHEAST_COUNT,
.gpio_to_pad = gpsecommunity_gpio_to_pad,
.pad_base = COMMUNITY_GPSOUTHEAST_BASE,
.has_gpe_en = GPE_CAPABLE_NONE,
.has_wake_en = 1,
};
static const struct gpio_bank gpsouthwest_community = {
.gpio_count = GP_SOUTHWEST_COUNT,
.gpio_to_pad = gpswcommunity_gpio_to_pad,
.pad_base = COMMUNITY_GPSOUTHWEST_BASE,
.has_gpe_en = GPE_CAPABLE,
.has_wake_en = 1,
};
static const struct gpio_bank gpeast_community = {
.gpio_count = GP_EAST_COUNT,
.gpio_to_pad = gpecommunity_gpio_to_pad,
.pad_base = COMMUNITY_GPEAST_BASE,
.has_gpe_en = GPE_CAPABLE_NONE,
.has_wake_en = 1,
};
static void setup_gpio_route(const struct soc_gpio_map *sw_gpios,
const struct soc_gpio_map *n_gpios)
{
const struct soc_gpio_map *n_config;
const struct soc_gpio_map *sw_config;
uint32_t route_reg = 0;
uint32_t int_selection = 0;
uint32_t alt_gpio_smi = 0;
uint32_t gpe0a_en = 0;
int gpio = 0;
int north_done = 0;
int south_done = 0;
for (sw_config = sw_gpios, n_config = n_gpios;
(!north_done || !south_done); sw_config++, n_config++, gpio++) {
/* When north config is done */
if ((gpio > GP_NORTH_COUNT) || (n_config->pad_conf0 == GPIO_LIST_END))
north_done = 1;
/* When southwest config is done */
if ((gpio > GP_SOUTHWEST_COUNT) || (sw_config->pad_conf0 == GPIO_LIST_END))
south_done = 1;
/* Route north gpios */
if (!north_done) {
/* Int select from 8 to 15 */
int_selection = ((n_config->pad_conf0 >> 28) & 0xf);
if (n_config->gpe == SMI) {
/* Set the corresponding bits (01) as per the interrupt line */
route_reg |= (1 << ((int_selection - 8) * 2));
/* Reset the higher bit */
route_reg &= ~(1 << ((int_selection - 8) * 2 + 1));
alt_gpio_smi |= (1 << (int_selection + 8));
} else if (n_config->gpe == SCI) {
/* Set the corresponding bits as per the interrupt line */
route_reg |= (1 << (((int_selection - 8) * 2) + 1));
/* Reset the bit */
route_reg &= ~(1 << ((int_selection - 8) * 2));
gpe0a_en |= (1 << (int_selection + 8));
}
}
/* Route southwest gpios */
if (!south_done) {
/* Int select from 8 to 15 */
int_selection = ((sw_config->pad_conf0 >> 28) & 0xf);
if (sw_config->gpe == SMI) {
/* Set the corresponding bits (10) as per the interrupt line */
route_reg |= (1 << (int_selection * 2));
route_reg &= ~(1 << (int_selection * 2 + 1));
alt_gpio_smi |= (1 << (int_selection + 16));
} else if (sw_config->gpe == SCI) {
/* Set the corresponding bits as per the interrupt line */
route_reg |= (1 << ((int_selection * 2) + 1));
/* Reset the bit */
route_reg &= ~(1 << (int_selection * 2));
gpe0a_en |= (1 << (int_selection + 16));
}
}
}
/* Enable gpe bits in GPE0A_EN_REG */
outl(gpe0a_en, ACPI_BASE_ADDRESS + GPE0A_EN_REG);
#ifdef GPIO_DEBUG
printk(BIOS_DEBUG, "gpio_rout = %x alt_gpio_smi = %x gpe0a_en = %x\n",
route_reg, alt_gpio_smi, gpe0a_en);
#endif
/* Save as an SMM param */
smm_southcluster_save_param(SMM_SAVE_PARAM_GPIO_ROUTE, route_reg);
}
static void setup_gpios(const struct soc_gpio_map *gpios, const struct gpio_bank *community)
{
const struct soc_gpio_map *config;
int gpio = 0;
u32 reg, family, internal_pad_num;
u32 mmio_addr, int_selection;
u32 gpio_wake0 = 0;
u32 gpio_wake1 = 0;
u32 gpio_int_mask = 0;
if (!gpios)
return;
for (config = gpios; config->pad_conf0 != GPIO_LIST_END; config++, gpio++) {
if (gpio > community->gpio_count)
break;
/* Pad configuration registers */
family = community->gpio_to_pad[gpio] / MAX_FAMILY_PAD_GPIO_NO;
internal_pad_num = community->gpio_to_pad[gpio] % MAX_FAMILY_PAD_GPIO_NO;
/*
* Calculate the MMIO Address for GPIO pin control register pointed by index.
* REG = IOBASE + COMMUNITY_BASE + 0x4400 + (0x400 * FAMILY_NUM) + (8 * PAD_NUM)
*/
mmio_addr = FAMILY_PAD_REGS_OFF + (FAMILY_PAD_REGS_SIZE * family) +
(GPIO_REGS_SIZE * internal_pad_num);
reg = community->pad_base + mmio_addr;
/* Get int selection value */
int_selection = ((config->pad_conf0 >> 28) & 0xf);
/* Get int mask register value */
gpio_int_mask |= (config->int_mask << int_selection);
/* Wake capable programming, some communities have 2 wake regs */
if (gpio > 31)
gpio_wake1 |= config->wake_mask << (gpio % 32);
else
gpio_wake0 |= config->wake_mask << gpio;
if (!config->skip_config) {
#ifdef GPIO_DEBUG
printk(BIOS_DEBUG,
"Write Pad: Base(%x) - conf0 = %x conf1= %x gpio #- %d pad # = %d\n",
reg, config->pad_conf0, config->pad_conf1,
community->gpio_to_pad[gpio], gpio);
#endif
/* Write pad configurations to conf0 and conf1 register */
write32((void *)(reg + PAD_CONF0_REG), config->pad_conf0);
write32((void *)(reg + PAD_CONF1_REG), config->pad_conf1);
}
}
#ifdef GPIO_DEBUG
printk(BIOS_DEBUG, "gpio_wake_mask0 = %x gpio_wake_mask1 = %x gpio_int_mask = %x\n",
gpio_wake0, gpio_wake1, gpio_int_mask);
#endif
/* Wake */
write32((void *)(community->pad_base + GPIO_WAKE_MASK_REG0), gpio_wake0);
/* Wake mask config for communities with 2 regs */
if (community->gpio_count > 32)
write32((void *)(community->pad_base + GPIO_WAKE_MASK_REG1), gpio_wake1);
/* Interrupt */
write32((void *)(community->pad_base + GPIO_INTERRUPT_MASK), gpio_int_mask);
}
void setup_soc_gpios(struct soc_gpio_config *config, u8 enable_xdp_tap)
{
if (config) {
/*
* Write the default value 0xffffff to the SW write_access_policy_interrupt_reg
* to allow the SW interrupt mask register to be set
*/
write32((void *)(COMMUNITY_GPSOUTHWEST_BASE + 0x108), 0xffffffff);
printk(BIOS_DEBUG, "north\n");
setup_gpios(config->north, &gpnorth_community);
printk(BIOS_DEBUG, "southwest\n");
setup_gpios(config->southwest, &gpsouthwest_community);
printk(BIOS_DEBUG, "southeast\n");
setup_gpios(config->southeast, &gpsoutheast_community);
printk(BIOS_DEBUG, "east\n");
setup_gpios(config->east, &gpeast_community);
printk(BIOS_DEBUG, "Routing SW and N gpios\n");
setup_gpio_route(config->southwest, config->north);
}
/*
* Set on die termination feature with pull up value
* and drive the pad high for TAP_TDO and TAP_TMS
*/
if (!enable_xdp_tap)
printk(BIOS_DEBUG, "Tri-state TDO and TMS\n");
}
__weak struct soc_gpio_config *mainboard_get_gpios(void)
{
printk(BIOS_DEBUG, "Default/empty GPIO config\n");
return NULL;
}
|
