[PATCH] powerpc: trivial: modify comments to refer to new location of files

This patch removes all self references and fixes references to files
in the now defunct arch/ppc64 tree.  I think this accomplises
everything wanted, though there might be a few references I missed.

Signed-off-by: Jon Mason <jdmason@us.ibm.com>
Signed-off-by: Paul Mackerras <paulus@samba.org>

1 files changed, 8 insertions, 7 deletions

diff --git a/Documentation/powerpc/eeh-pci-error-recovery.txt b/Documentation/powerpc/eeh-pci-error-recovery.txt
index 67a11a36270c..3764dd4b12cb 100644
--- a/Documentation/powerpc/eeh-pci-error-recovery.txt
+++ b/Documentation/powerpc/eeh-pci-error-recovery.txt
@@ -121,7 +121,7 @@ accomplished.
 
 EEH must be enabled in the PHB's very early during the boot process,
 and if a PCI slot is hot-plugged. The former is performed by
-eeh_init() in arch/ppc64/kernel/eeh.c, and the later by
+eeh_init() in arch/powerpc/platforms/pseries/eeh.c, and the later by
 drivers/pci/hotplug/pSeries_pci.c calling in to the eeh.c code.
 EEH must be enabled before a PCI scan of the device can proceed.
 Current Power5 hardware will not work unless EEH is enabled;
@@ -133,7 +133,7 @@ error.  Given an arbitrary address, the routine
 pci_get_device_by_addr() will find the pci device associated
 with that address (if any).
 
-The default include/asm-ppc64/io.h macros readb(), inb(), insb(),
+The default include/asm-powerpc/io.h macros readb(), inb(), insb(),
 etc. include a check to see if the i/o read returned all-0xff's.
 If so, these make a call to eeh_dn_check_failure(), which in turn
 asks the firmware if the all-ff's value is the sign of a true EEH
@@ -143,11 +143,12 @@ seen in /proc/ppc64/eeh (subject to change).  Normally, almost
 all of these occur during boot, when the PCI bus is scanned, where
 a large number of 0xff reads are part of the bus scan procedure.
 
-If a frozen slot is detected, code in arch/ppc64/kernel/eeh.c will
-print a stack trace to syslog (/var/log/messages).  This stack trace
-has proven to be very useful to device-driver authors for finding
-out at what point the EEH error was detected, as the error itself
-usually occurs slightly beforehand.
+If a frozen slot is detected, code in 
+arch/powerpc/platforms/pseries/eeh.c will print a stack trace to 
+syslog (/var/log/messages).  This stack trace has proven to be very 
+useful to device-driver authors for finding out at what point the EEH 
+error was detected, as the error itself usually occurs slightly 
+beforehand.
 
 Next, it uses the Linux kernel notifier chain/work queue mechanism to
 allow any interested parties to find out about the failure.  Device