summaryrefslogtreecommitdiffstats
diff options
context:
space:
mode:
Diffstat
-rw-r--r--Documentation/hwmon/ds162126
-rw-r--r--drivers/hwmon/Kconfig9
-rw-r--r--drivers/hwmon/ds1621.c120
3 files changed, 132 insertions, 23 deletions
diff --git a/Documentation/hwmon/ds1621 b/Documentation/hwmon/ds1621
index 5e97f333c4df..d66f76f9d85d 100644
--- a/Documentation/hwmon/ds1621
+++ b/Documentation/hwmon/ds1621
@@ -2,16 +2,22 @@ Kernel driver ds1621
====================
Supported chips:
- * Dallas Semiconductor DS1621
+ * Dallas Semiconductor / Maxim Integrated DS1621
Prefix: 'ds1621'
Addresses scanned: I2C 0x48 - 0x4f
- Datasheet: Publicly available at the Dallas Semiconductor website
- http://www.dalsemi.com/
+ Datasheet: Publicly available from www.maximintegrated.com
+
* Dallas Semiconductor DS1625
- Prefix: 'ds1621'
+ Prefix:
+ 'ds1621' - if binding via _detect function
+ 'ds1625' - explicit instantiation
+ Addresses scanned: I2C 0x48 - 0x4f
+ Datasheet: Publicly available from www.datasheetarchive.com
+
+ * Maxim Integrated DS1721
+ Prefix: 'ds1721'
Addresses scanned: I2C 0x48 - 0x4f
- Datasheet: Publicly available at the Dallas Semiconductor website
- http://www.dalsemi.com/
+ Datasheet: Publicly available from www.maximintegrated.com
Authors:
Christian W. Zuckschwerdt <zany@triq.net>
@@ -61,3 +67,11 @@ with neither of the alarms set.
Temperature conversion of the DS1621 takes up to 1000ms; internal access to
non-volatile registers may last for 10ms or below.
+
+The DS1625 is pin compatible and functionally equivalent with the DS1621,
+but the DS1621 is meant to replace it.
+
+The DS1721 is pin compatible with the DS1621, has an accuracy of +/- 1.0
+degree Celsius over a -10 to +85 degree range, a minimum/maximum alarm
+default setting of 75 and 80 degrees respectively, and a maximum conversion
+time of 750ms.
diff --git a/drivers/hwmon/Kconfig b/drivers/hwmon/Kconfig
index 0428e8a74b19..0114ed4b3c07 100644
--- a/drivers/hwmon/Kconfig
+++ b/drivers/hwmon/Kconfig
@@ -348,11 +348,14 @@ config SENSORS_DS620
will be called ds620.
config SENSORS_DS1621
- tristate "Dallas Semiconductor DS1621 and DS1625"
+ tristate "Dallas Semiconductor DS1621 and compatibles"
depends on I2C
help
- If you say yes here you get support for Dallas Semiconductor
- DS1621 and DS1625 sensor chips.
+ If you say yes here you get support for Dallas Semiconductor/Maxim
+ Integrated DS1621 sensor chips and compatible models including:
+
+ - Dallas Semiconductor DS1625
+ - Maxim Integrated DS1721
This driver can also be built as a module. If so, the module
will be called ds1621.
diff --git a/drivers/hwmon/ds1621.c b/drivers/hwmon/ds1621.c
index 1c568736baff..6942617666a4 100644
--- a/drivers/hwmon/ds1621.c
+++ b/drivers/hwmon/ds1621.c
@@ -6,6 +6,19 @@
* Ported to Linux 2.6 by Aurelien Jarno <aurelien@aurel32.net> with
* the help of Jean Delvare <khali@linux-fr.org>
*
+ * The DS1621 device is a digital temperature/thermometer with 9-bit
+ * resolution, a thermal alarm output (Tout), and user-defined minimum
+ * and maximum temperature thresholds (TH and TL).
+ *
+ * The DS1625 and DS1721 are pin compatible with the DS1621 and similar
+ * in operation, with slight variations as noted in the device
+ * datasheets (please refer to www.maximintegrated.com for specific
+ * device information).
+ *
+ * Since the DS1621 was the first chipset supported by this driver,
+ * most comments will refer to this chipset, but are actually general
+ * and concern all supported chipsets, unless mentioned otherwise.
+ *
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation; either version 2 of the License, or
@@ -31,27 +44,62 @@
#include <linux/err.h>
#include <linux/mutex.h>
#include <linux/sysfs.h>
-#include "lm75.h"
+#include <linux/kernel.h>
/* Addresses to scan */
static const unsigned short normal_i2c[] = { 0x48, 0x49, 0x4a, 0x4b, 0x4c,
0x4d, 0x4e, 0x4f, I2C_CLIENT_END };
+/* Supported devices */
+enum chips { ds1621, ds1625, ds1721 };
+
/* Insmod parameters */
static int polarity = -1;
module_param(polarity, int, 0);
MODULE_PARM_DESC(polarity, "Output's polarity: 0 = active high, 1 = active low");
-/* Many DS1621 constants specified below */
-/* Config register used for detection */
-/* 7 6 5 4 3 2 1 0 */
-/* |Done|THF |TLF |NVB | X | X |POL |1SHOT| */
+/*
+ * The Configuration/Status register
+ *
+ * - DS1621:
+ * 7 6 5 4 3 2 1 0
+ * |Done|THF |TLF |NVB | X | X |POL |1SHOT|
+ *
+ * - DS1625:
+ * 7 6 5 4 3 2 1 0
+ * |Done|THF |TLF |NVB | 1 | 0 |POL |1SHOT|
+ *
+ * - DS1721:
+ * 7 6 5 4 3 2 1 0
+ * |Done| X | X | U | R1 | R0 |POL |1SHOT|
+ *
+ * Where:
+ * - 'X' is Reserved
+ * - 'U' is Undefined
+ */
#define DS1621_REG_CONFIG_NVB 0x10
+#define DS1621_REG_CONFIG_RESOL 0x0C
#define DS1621_REG_CONFIG_POLARITY 0x02
#define DS1621_REG_CONFIG_1SHOT 0x01
#define DS1621_REG_CONFIG_DONE 0x80
-/* The DS1621 registers */
+#define DS1621_REG_CONFIG_RESOL_SHIFT 2
+
+/* ds1721 conversion rates: {C/LSB, time(ms), resolution bit setting} */
+static const unsigned short ds1721_convrates[] = {
+ 94, /* 9-bits (0.5, 93.75, RES[0..1] = 0 */
+ 188, /* 10-bits (0.25, 187.5, RES[0..1] = 1 */
+ 375, /* 11-bits (0.125, 375, RES[0..1] = 2 */
+ 750, /* 12-bits (0.0625, 750, RES[0..1] = 3 */
+};
+
+#define DS1621_CONVERSION_MAX 750
+#define DS1625_CONVERSION_MAX 500
+
+#define DS1621_TEMP_MAX 125000
+#define DS1621_TEMP_MIN (-55000)
+
+/* The DS1621 temperature registers */
static const u8 DS1621_REG_TEMP[3] = {
0xAA, /* input, word, RO */
0xA2, /* min, word, RW */
@@ -59,6 +107,7 @@ static const u8 DS1621_REG_TEMP[3] = {
};
#define DS1621_REG_CONF 0xAC /* byte, RW */
#define DS1621_COM_START 0xEE /* no data */
+#define DS1721_COM_START 0x51 /* no data */
#define DS1621_COM_STOP 0x22 /* no data */
/* The DS1621 configuration register */
@@ -75,14 +124,37 @@ struct ds1621_data {
struct mutex update_lock;
char valid; /* !=0 if following fields are valid */
unsigned long last_updated; /* In jiffies */
+ enum chips kind; /* device type */
u16 temp[3]; /* Register values, word */
u8 conf; /* Register encoding, combined */
+ u16 update_interval; /* Conversion rate in milliseconds */
};
+static inline int DS1621_TEMP_FROM_REG(u16 reg)
+{
+ return DIV_ROUND_CLOSEST(((s16)reg / 16) * 625, 10);
+}
+
+/*
+ * TEMP: 0.001C/bit (-55C to +125C)
+ * REG:
+ * - 1621, 1625: x = 0.5C
+ * - 1721: x = 0.0625C
+ * Assume highest resolution and let the bits fall where they may..
+ */
+static inline u16 DS1621_TEMP_TO_REG(long temp)
+{
+ int ntemp = clamp_val(temp, DS1621_TEMP_MIN, DS1621_TEMP_MAX);
+ ntemp += (ntemp < 0 ? -31 : 31);
+ ntemp = DIV_ROUND_CLOSEST(ntemp * 10, 625) << 4;
+ return (u16)ntemp;
+}
+
static void ds1621_init_client(struct i2c_client *client)
{
- u8 conf, new_conf;
+ u8 conf, new_conf, sreg, resol;
+ struct ds1621_data *data = i2c_get_clientdata(client);
new_conf = conf = i2c_smbus_read_byte_data(client, DS1621_REG_CONF);
/* switch to continuous conversion mode */
@@ -97,8 +169,25 @@ static void ds1621_init_client(struct i2c_client *client)
if (conf != new_conf)
i2c_smbus_write_byte_data(client, DS1621_REG_CONF, new_conf);
+ switch (data->kind) {
+ case ds1625:
+ data->update_interval = DS1625_CONVERSION_MAX;
+ sreg = DS1621_COM_START;
+ break;
+ case ds1721:
+ resol = (new_conf & DS1621_REG_CONFIG_RESOL) >>
+ DS1621_REG_CONFIG_RESOL_SHIFT;
+ data->update_interval = ds1721_convrates[resol];
+ sreg = DS1721_COM_START;
+ break;
+ default:
+ data->update_interval = DS1621_CONVERSION_MAX;
+ sreg = DS1621_COM_START;
+ break;
+ }
+
/* start conversion */
- i2c_smbus_write_byte(client, DS1621_COM_START);
+ i2c_smbus_write_byte(client, sreg);
}
static struct ds1621_data *ds1621_update_client(struct device *dev)
@@ -109,8 +198,8 @@ static struct ds1621_data *ds1621_update_client(struct device *dev)
mutex_lock(&data->update_lock);
- if (time_after(jiffies, data->last_updated + HZ + HZ / 2)
- || !data->valid) {
+ if (time_after(jiffies, data->last_updated + data->update_interval) ||
+ !data->valid) {
int i;
dev_dbg(&client->dev, "Starting ds1621 update\n");
@@ -146,7 +235,7 @@ static ssize_t show_temp(struct device *dev, struct device_attribute *da,
struct sensor_device_attribute *attr = to_sensor_dev_attr(da);
struct ds1621_data *data = ds1621_update_client(dev);
return sprintf(buf, "%d\n",
- LM75_TEMP_FROM_REG(data->temp[attr->index]));
+ DS1621_TEMP_FROM_REG(data->temp[attr->index]));
}
static ssize_t set_temp(struct device *dev, struct device_attribute *da,
@@ -163,7 +252,7 @@ static ssize_t set_temp(struct device *dev, struct device_attribute *da,
return err;
mutex_lock(&data->update_lock);
- data->temp[attr->index] = LM75_TEMP_TO_REG(val);
+ data->temp[attr->index] = DS1621_TEMP_TO_REG(val);
i2c_smbus_write_word_swapped(client, DS1621_REG_TEMP[attr->index],
data->temp[attr->index]);
mutex_unlock(&data->update_lock);
@@ -257,6 +346,8 @@ static int ds1621_probe(struct i2c_client *client,
i2c_set_clientdata(client, data);
mutex_init(&data->update_lock);
+ data->kind = id->driver_data;
+
/* Initialize the DS1621 chip */
ds1621_init_client(client);
@@ -289,8 +380,9 @@ static int ds1621_remove(struct i2c_client *client)
}
static const struct i2c_device_id ds1621_id[] = {
- { "ds1621", 0 },
- { "ds1625", 0 },
+ { "ds1621", ds1621 },
+ { "ds1625", ds1625 },
+ { "ds1721", ds1721 },
{ }
};
MODULE_DEVICE_TABLE(i2c, ds1621_id);
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-16 20:44:06 +0000