diff options
Diffstat (limited to 'drivers/gpu/drm/amd/include/atomfirmware.h')
| -rw-r--r-- | drivers/gpu/drm/amd/include/atomfirmware.h | 86 |
1 files changed, 86 insertions, 0 deletions
diff --git a/drivers/gpu/drm/amd/include/atomfirmware.h b/drivers/gpu/drm/amd/include/atomfirmware.h index 24cfe84d7322..e88541d67aa0 100644 --- a/drivers/gpu/drm/amd/include/atomfirmware.h +++ b/drivers/gpu/drm/amd/include/atomfirmware.h @@ -1789,6 +1789,92 @@ struct atom_smc_dpm_info_v4_5 }; +struct atom_smc_dpm_info_v4_6 +{ + struct atom_common_table_header table_header; + // section: board parameters + uint32_t i2c_padding[3]; // old i2c control are moved to new area + + uint16_t maxvoltagestepgfx; // in mv(q2) max voltage step that smu will request. multiple steps are taken if voltage change exceeds this value. + uint16_t maxvoltagestepsoc; // in mv(q2) max voltage step that smu will request. multiple steps are taken if voltage change exceeds this value. + + uint8_t vddgfxvrmapping; // use vr_mapping* bitfields + uint8_t vddsocvrmapping; // use vr_mapping* bitfields + uint8_t vddmemvrmapping; // use vr_mapping* bitfields + uint8_t boardvrmapping; // use vr_mapping* bitfields + + uint8_t gfxulvphasesheddingmask; // set this to 1 to set psi0/1 to 1 in ulv mode + uint8_t externalsensorpresent; // external rdi connected to tmon (aka temp in) + uint8_t padding8_v[2]; + + // telemetry settings + uint16_t gfxmaxcurrent; // in amps + uint8_t gfxoffset; // in amps + uint8_t padding_telemetrygfx; + + uint16_t socmaxcurrent; // in amps + uint8_t socoffset; // in amps + uint8_t padding_telemetrysoc; + + uint16_t memmaxcurrent; // in amps + uint8_t memoffset; // in amps + uint8_t padding_telemetrymem; + + uint16_t boardmaxcurrent; // in amps + uint8_t boardoffset; // in amps + uint8_t padding_telemetryboardinput; + + // gpio settings + uint8_t vr0hotgpio; // gpio pin configured for vr0 hot event + uint8_t vr0hotpolarity; // gpio polarity for vr0 hot event + uint8_t vr1hotgpio; // gpio pin configured for vr1 hot event + uint8_t vr1hotpolarity; // gpio polarity for vr1 hot event + + // gfxclk pll spread spectrum + uint8_t pllgfxclkspreadenabled; // on or off + uint8_t pllgfxclkspreadpercent; // q4.4 + uint16_t pllgfxclkspreadfreq; // khz + + // uclk spread spectrum + uint8_t uclkspreadenabled; // on or off + uint8_t uclkspreadpercent; // q4.4 + uint16_t uclkspreadfreq; // khz + + // fclk spread spectrum + uint8_t fclkspreadenabled; // on or off + uint8_t fclkspreadpercent; // q4.4 + uint16_t fclkspreadfreq; // khz + + + // gfxclk fll spread spectrum + uint8_t fllgfxclkspreadenabled; // on or off + uint8_t fllgfxclkspreadpercent; // q4.4 + uint16_t fllgfxclkspreadfreq; // khz + + // i2c controller structure + struct smudpm_i2c_controller_config_v2 i2ccontrollers[8]; + + // memory section + uint32_t memorychannelenabled; // for dram use only, max 32 channels enabled bit mask. + + uint8_t drambitwidth; // for dram use only. see dram bit width type defines + uint8_t paddingmem[3]; + + // total board power + uint16_t totalboardpower; //only needed for tcp estimated case, where tcp = tgp+total board power + uint16_t boardpadding; + + // section: xgmi training + uint8_t xgmilinkspeed[4]; + uint8_t xgmilinkwidth[4]; + + uint16_t xgmifclkfreq[4]; + uint16_t xgmisocvoltage[4]; + + // reserved + uint32_t boardreserved[10]; +}; + /* *************************************************************************** Data Table asic_profiling_info structure |