net/fsl_pq_mdio: Allow explicit speficition of TBIPA address

This introduces a simpler and generic method for for finding (and mapping)
the TBIPA register.

Instead of relying of complicated logic for finding the TBIPA register
address based on the MDIO or MII register block base
address, which even in some cases relies on undocumented shadow registers,
a second "reg" entry for the mdio bus devicetree node specifies the TBIPA
register.

Backwards compatibility is kept, as the existing logic is applied when
only a single "reg" mapping is specified.

Signed-off-by: Esben Haabendal <eha@deif.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

1 files changed, 5 insertions, 1 deletions

diff --git a/Documentation/devicetree/bindings/net/fsl-tsec-phy.txt b/Documentation/devicetree/bindings/net/fsl-tsec-phy.txt
index 594982c6b9f9..79bf352e659c 100644
--- a/Documentation/devicetree/bindings/net/fsl-tsec-phy.txt
+++ b/Documentation/devicetree/bindings/net/fsl-tsec-phy.txt
@@ -6,7 +6,11 @@ the definition of the PHY node in booting-without-of.txt for an example
 of how to define a PHY.
 
 Required properties:
-  - reg : Offset and length of the register set for the device
+  - reg : Offset and length of the register set for the device, and optionally
+          the offset and length of the TBIPA register (TBI PHY address
+	  register).  If TBIPA register is not specified, the driver will
+	  attempt to infer it from the register set specified (your mileage may
+	  vary).
   - compatible : Should define the compatible device type for the
     mdio. Currently supported strings/devices are:
 	- "fsl,gianfar-tbi"