1 files changed, 0 insertions, 78 deletions
diff --git a/Documentation/devicetree/bindings/sound/rt5677.txt b/Documentation/devicetree/bindings/sound/rt5677.txt
deleted file mode 100644
index da2430099181..000000000000
--- a/Documentation/devicetree/bindings/sound/rt5677.txt
+++ /dev/null
@@ -1,78 +0,0 @@
-RT5677 audio CODEC
-
-This device supports I2C only.
-
-Required properties:
-
-- compatible : "realtek,rt5677".
-
-- reg : The I2C address of the device.
-
-- interrupts : The CODEC's interrupt output.
-
-- gpio-controller : Indicates this device is a GPIO controller.
-
-- #gpio-cells : Should be two. The first cell is the pin number and the
-  second cell is used to specify optional parameters (currently unused).
-
-Optional properties:
-
-- realtek,pow-ldo2-gpio : The GPIO that controls the CODEC's POW_LDO2 pin.
-- realtek,reset-gpio : The GPIO that controls the CODEC's RESET pin. Active low.
-
-- realtek,in1-differential
-- realtek,in2-differential
-- realtek,lout1-differential
-- realtek,lout2-differential
-- realtek,lout3-differential
-  Boolean. Indicate MIC1/2 input and LOUT1/2/3 outputs are differential,
-  rather than single-ended.
-
-- realtek,gpio-config
-  Array of six 8bit elements that configures GPIO.
-    0 - floating (reset value)
-    1 - pull down
-    2 - pull up
-
-- realtek,jd1-gpio
-  Configures GPIO Mic Jack detection 1.
-  Select 0 ~ 3 as OFF, GPIO1, GPIO2 and GPIO3 respectively.
-
-- realtek,jd2-gpio
-- realtek,jd3-gpio
-  Configures GPIO Mic Jack detection 2 and 3.
-  Select 0 ~ 3 as OFF, GPIO4, GPIO5 and GPIO6 respectively.
-
-Pins on the device (for linking into audio routes):
-
-  * IN1P
-  * IN1N
-  * IN2P
-  * IN2N
-  * MICBIAS1
-  * DMIC1
-  * DMIC2
-  * DMIC3
-  * DMIC4
-  * LOUT1
-  * LOUT2
-  * LOUT3
-
-Example:
-
-rt5677 {
-	compatible = "realtek,rt5677";
-	reg = <0x2c>;
-	interrupt-parent = <&gpio>;
-	interrupts = <TEGRA_GPIO(W, 3) IRQ_TYPE_LEVEL_HIGH>;
-
-	gpio-controller;
-	#gpio-cells = <2>;
-
-	realtek,pow-ldo2-gpio =
-		<&gpio TEGRA_GPIO(V, 3) GPIO_ACTIVE_HIGH>;
-	realtek,reset-gpio = <&gpio TEGRA_GPIO(BB, 3) GPIO_ACTIVE_LOW>;
-	realtek,in1-differential = "true";
-	realtek,gpio-config = /bits/ 8  <0 0 0 0 0 2>;   /* pull up GPIO6 */
-	realtek,jd2-gpio = <3>;  /* Enables Jack detection for GPIO6 */
-};