diff options
Diffstat (limited to 'arch/x86/boot/compressed/efi_mixed.S')
| -rw-r--r-- | arch/x86/boot/compressed/efi_mixed.S | 341 |
1 files changed, 0 insertions, 341 deletions
diff --git a/arch/x86/boot/compressed/efi_mixed.S b/arch/x86/boot/compressed/efi_mixed.S deleted file mode 100644 index 876fc6d46a13..000000000000 --- a/arch/x86/boot/compressed/efi_mixed.S +++ /dev/null @@ -1,341 +0,0 @@ -/* SPDX-License-Identifier: GPL-2.0 */ -/* - * Copyright (C) 2014, 2015 Intel Corporation; author Matt Fleming - * - * Early support for invoking 32-bit EFI services from a 64-bit kernel. - * - * Because this thunking occurs before ExitBootServices() we have to - * restore the firmware's 32-bit GDT and IDT before we make EFI service - * calls. - * - * On the plus side, we don't have to worry about mangling 64-bit - * addresses into 32-bits because we're executing with an identity - * mapped pagetable and haven't transitioned to 64-bit virtual addresses - * yet. - */ - -#include <linux/linkage.h> -#include <asm/asm-offsets.h> -#include <asm/msr.h> -#include <asm/page_types.h> -#include <asm/processor-flags.h> -#include <asm/segment.h> -#include <asm/setup.h> - - .code64 - .text -/* - * When booting in 64-bit mode on 32-bit EFI firmware, startup_64_mixed_mode() - * is the first thing that runs after switching to long mode. Depending on - * whether the EFI handover protocol or the compat entry point was used to - * enter the kernel, it will either branch to the common 64-bit EFI stub - * entrypoint efi_stub_entry() directly, or via the 64-bit EFI PE/COFF - * entrypoint efi_pe_entry(). In the former case, the bootloader must provide a - * struct bootparams pointer as the third argument, so the presence of such a - * pointer is used to disambiguate. - * - * +--------------+ - * +------------------+ +------------+ +------>| efi_pe_entry | - * | efi32_pe_entry |---->| | | +-----------+--+ - * +------------------+ | | +------+----------------+ | - * | startup_32 |---->| startup_64_mixed_mode | | - * +------------------+ | | +------+----------------+ | - * | efi32_stub_entry |---->| | | | - * +------------------+ +------------+ | | - * V | - * +------------+ +----------------+ | - * | startup_64 |<----| efi_stub_entry |<--------+ - * +------------+ +----------------+ - */ -SYM_FUNC_START(startup_64_mixed_mode) - lea efi32_boot_args(%rip), %rdx - mov 0(%rdx), %edi - mov 4(%rdx), %esi - - /* Switch to the firmware's stack */ - movl efi32_boot_sp(%rip), %esp - andl $~7, %esp - -#ifdef CONFIG_EFI_HANDOVER_PROTOCOL - mov 8(%rdx), %edx // saved bootparams pointer - test %edx, %edx - jnz efi_stub_entry -#endif - /* - * efi_pe_entry uses MS calling convention, which requires 32 bytes of - * shadow space on the stack even if all arguments are passed in - * registers. We also need an additional 8 bytes for the space that - * would be occupied by the return address, and this also results in - * the correct stack alignment for entry. - */ - sub $40, %rsp - mov %rdi, %rcx // MS calling convention - mov %rsi, %rdx - jmp efi_pe_entry -SYM_FUNC_END(startup_64_mixed_mode) - -SYM_FUNC_START(__efi64_thunk) - push %rbp - push %rbx - - movl %ds, %eax - push %rax - movl %es, %eax - push %rax - movl %ss, %eax - push %rax - - /* Copy args passed on stack */ - movq 0x30(%rsp), %rbp - movq 0x38(%rsp), %rbx - movq 0x40(%rsp), %rax - - /* - * Convert x86-64 ABI params to i386 ABI - */ - subq $64, %rsp - movl %esi, 0x0(%rsp) - movl %edx, 0x4(%rsp) - movl %ecx, 0x8(%rsp) - movl %r8d, 0xc(%rsp) - movl %r9d, 0x10(%rsp) - movl %ebp, 0x14(%rsp) - movl %ebx, 0x18(%rsp) - movl %eax, 0x1c(%rsp) - - leaq 0x20(%rsp), %rbx - sgdt (%rbx) - sidt 16(%rbx) - - leaq 1f(%rip), %rbp - - /* - * Switch to IDT and GDT with 32-bit segments. These are the firmware - * GDT and IDT that were installed when the kernel started executing. - * The pointers were saved by the efi32_entry() routine below. - * - * Pass the saved DS selector to the 32-bit code, and use far return to - * restore the saved CS selector. - */ - lidt efi32_boot_idt(%rip) - lgdt efi32_boot_gdt(%rip) - - movzwl efi32_boot_ds(%rip), %edx - movzwq efi32_boot_cs(%rip), %rax - pushq %rax - leaq efi_enter32(%rip), %rax - pushq %rax - lretq - -1: addq $64, %rsp - movq %rdi, %rax - - pop %rbx - movl %ebx, %ss - pop %rbx - movl %ebx, %es - pop %rbx - movl %ebx, %ds - /* Clear out 32-bit selector from FS and GS */ - xorl %ebx, %ebx - movl %ebx, %fs - movl %ebx, %gs - - pop %rbx - pop %rbp - RET -SYM_FUNC_END(__efi64_thunk) - - .code32 -#ifdef CONFIG_EFI_HANDOVER_PROTOCOL -SYM_FUNC_START(efi32_stub_entry) - call 1f -1: popl %ecx - leal (efi32_boot_args - 1b)(%ecx), %ebx - - /* Clear BSS */ - xorl %eax, %eax - leal (_bss - 1b)(%ecx), %edi - leal (_ebss - 1b)(%ecx), %ecx - subl %edi, %ecx - shrl $2, %ecx - cld - rep stosl - - add $0x4, %esp /* Discard return address */ - popl %ecx - popl %edx - popl %esi - movl %esi, 8(%ebx) - jmp efi32_entry -SYM_FUNC_END(efi32_stub_entry) -#endif - -/* - * EFI service pointer must be in %edi. - * - * The stack should represent the 32-bit calling convention. - */ -SYM_FUNC_START_LOCAL(efi_enter32) - /* Load firmware selector into data and stack segment registers */ - movl %edx, %ds - movl %edx, %es - movl %edx, %fs - movl %edx, %gs - movl %edx, %ss - - /* Reload pgtables */ - movl %cr3, %eax - movl %eax, %cr3 - - /* Disable paging */ - movl %cr0, %eax - btrl $X86_CR0_PG_BIT, %eax - movl %eax, %cr0 - - /* Disable long mode via EFER */ - movl $MSR_EFER, %ecx - rdmsr - btrl $_EFER_LME, %eax - wrmsr - - call *%edi - - /* We must preserve return value */ - movl %eax, %edi - - /* - * Some firmware will return with interrupts enabled. Be sure to - * disable them before we switch GDTs and IDTs. - */ - cli - - lidtl 16(%ebx) - lgdtl (%ebx) - - movl %cr4, %eax - btsl $(X86_CR4_PAE_BIT), %eax - movl %eax, %cr4 - - movl %cr3, %eax - movl %eax, %cr3 - - movl $MSR_EFER, %ecx - rdmsr - btsl $_EFER_LME, %eax - wrmsr - - xorl %eax, %eax - lldt %ax - - pushl $__KERNEL_CS - pushl %ebp - - /* Enable paging */ - movl %cr0, %eax - btsl $X86_CR0_PG_BIT, %eax - movl %eax, %cr0 - lret -SYM_FUNC_END(efi_enter32) - -/* - * This is the common EFI stub entry point for mixed mode. - * - * Arguments: %ecx image handle - * %edx EFI system table pointer - * - * Since this is the point of no return for ordinary execution, no registers - * are considered live except for the function parameters. [Note that the EFI - * stub may still exit and return to the firmware using the Exit() EFI boot - * service.] - */ -SYM_FUNC_START_LOCAL(efi32_entry) - call 1f -1: pop %ebx - - /* Save firmware GDTR and code/data selectors */ - sgdtl (efi32_boot_gdt - 1b)(%ebx) - movw %cs, (efi32_boot_cs - 1b)(%ebx) - movw %ds, (efi32_boot_ds - 1b)(%ebx) - - /* Store firmware IDT descriptor */ - sidtl (efi32_boot_idt - 1b)(%ebx) - - /* Store firmware stack pointer */ - movl %esp, (efi32_boot_sp - 1b)(%ebx) - - /* Store boot arguments */ - leal (efi32_boot_args - 1b)(%ebx), %ebx - movl %ecx, 0(%ebx) - movl %edx, 4(%ebx) - movb $0x0, 12(%ebx) // efi_is64 - - /* - * Allocate some memory for a temporary struct boot_params, which only - * needs the minimal pieces that startup_32() relies on. - */ - subl $PARAM_SIZE, %esp - movl %esp, %esi - movl $PAGE_SIZE, BP_kernel_alignment(%esi) - movl $_end - 1b, BP_init_size(%esi) - subl $startup_32 - 1b, BP_init_size(%esi) - - /* Disable paging */ - movl %cr0, %eax - btrl $X86_CR0_PG_BIT, %eax - movl %eax, %cr0 - - jmp startup_32 -SYM_FUNC_END(efi32_entry) - -/* - * efi_status_t efi32_pe_entry(efi_handle_t image_handle, - * efi_system_table_32_t *sys_table) - */ -SYM_FUNC_START(efi32_pe_entry) - pushl %ebp - movl %esp, %ebp - pushl %ebx // save callee-save registers - pushl %edi - - call verify_cpu // check for long mode support - testl %eax, %eax - movl $0x80000003, %eax // EFI_UNSUPPORTED - jnz 2f - - movl 8(%ebp), %ecx // image_handle - movl 12(%ebp), %edx // sys_table - jmp efi32_entry // pass %ecx, %edx - // no other registers remain live - -2: popl %edi // restore callee-save registers - popl %ebx - leave - RET -SYM_FUNC_END(efi32_pe_entry) - -#ifdef CONFIG_EFI_HANDOVER_PROTOCOL - .org efi32_stub_entry + 0x200 - .code64 -SYM_FUNC_START_NOALIGN(efi64_stub_entry) - jmp efi_handover_entry -SYM_FUNC_END(efi64_stub_entry) -#endif - - .data - .balign 8 -SYM_DATA_START_LOCAL(efi32_boot_gdt) - .word 0 - .quad 0 -SYM_DATA_END(efi32_boot_gdt) - -SYM_DATA_START_LOCAL(efi32_boot_idt) - .word 0 - .quad 0 -SYM_DATA_END(efi32_boot_idt) - -SYM_DATA_LOCAL(efi32_boot_cs, .word 0) -SYM_DATA_LOCAL(efi32_boot_ds, .word 0) -SYM_DATA_LOCAL(efi32_boot_sp, .long 0) -SYM_DATA_LOCAL(efi32_boot_args, .long 0, 0, 0) -SYM_DATA(efi_is64, .byte 1) |