diff options
Diffstat (limited to 'drivers/tty/serial')
| -rw-r--r-- | drivers/tty/serial/earlycon.c | 6 | ||||
| -rw-r--r-- | drivers/tty/serial/imx.c | 19 | ||||
| -rw-r--r-- | drivers/tty/serial/mvebu-uart.c | 1 | ||||
| -rw-r--r-- | drivers/tty/serial/qcom_geni_serial.c | 10 | ||||
| -rw-r--r-- | drivers/tty/serial/xilinx_uartps.c | 2 |
5 files changed, 29 insertions, 9 deletions
diff --git a/drivers/tty/serial/earlycon.c b/drivers/tty/serial/earlycon.c index a24278380fec..22683393a0f2 100644 --- a/drivers/tty/serial/earlycon.c +++ b/drivers/tty/serial/earlycon.c @@ -169,7 +169,7 @@ static int __init register_earlycon(char *buf, const struct earlycon_id *match) */ int __init setup_earlycon(char *buf) { - const struct earlycon_id *match; + const struct earlycon_id **p_match; if (!buf || !buf[0]) return -EINVAL; @@ -177,7 +177,9 @@ int __init setup_earlycon(char *buf) if (early_con.flags & CON_ENABLED) return -EALREADY; - for (match = __earlycon_table; match < __earlycon_table_end; match++) { + for (p_match = __earlycon_table; p_match < __earlycon_table_end; + p_match++) { + const struct earlycon_id *match = *p_match; size_t len = strlen(match->name); if (strncmp(buf, match->name, len)) diff --git a/drivers/tty/serial/imx.c b/drivers/tty/serial/imx.c index 91f3a1a5cb7f..c2fc6bef7a6f 100644 --- a/drivers/tty/serial/imx.c +++ b/drivers/tty/serial/imx.c @@ -316,7 +316,7 @@ static u32 imx_uart_readl(struct imx_port *sport, u32 offset) * differ from the value that was last written. As it only * clears after being set, reread conditionally. */ - if (sport->ucr2 & UCR2_SRST) + if (!(sport->ucr2 & UCR2_SRST)) sport->ucr2 = readl(sport->port.membase + offset); return sport->ucr2; break; @@ -1833,6 +1833,11 @@ static int imx_uart_rs485_config(struct uart_port *port, rs485conf->flags &= ~SER_RS485_ENABLED; if (rs485conf->flags & SER_RS485_ENABLED) { + /* Enable receiver if low-active RTS signal is requested */ + if (sport->have_rtscts && !sport->have_rtsgpio && + !(rs485conf->flags & SER_RS485_RTS_ON_SEND)) + rs485conf->flags |= SER_RS485_RX_DURING_TX; + /* disable transmitter */ ucr2 = imx_uart_readl(sport, UCR2); if (rs485conf->flags & SER_RS485_RTS_AFTER_SEND) @@ -2265,6 +2270,18 @@ static int imx_uart_probe(struct platform_device *pdev) (!sport->have_rtscts && !sport->have_rtsgpio)) dev_err(&pdev->dev, "no RTS control, disabling rs485\n"); + /* + * If using the i.MX UART RTS/CTS control then the RTS (CTS_B) + * signal cannot be set low during transmission in case the + * receiver is off (limitation of the i.MX UART IP). + */ + if (sport->port.rs485.flags & SER_RS485_ENABLED && + sport->have_rtscts && !sport->have_rtsgpio && + (!(sport->port.rs485.flags & SER_RS485_RTS_ON_SEND) && + !(sport->port.rs485.flags & SER_RS485_RX_DURING_TX))) + dev_err(&pdev->dev, + "low-active RTS not possible when receiver is off, enabling receiver\n"); + imx_uart_rs485_config(&sport->port, &sport->port.rs485); /* Disable interrupts before requesting them */ diff --git a/drivers/tty/serial/mvebu-uart.c b/drivers/tty/serial/mvebu-uart.c index 750e5645dc85..f503fab1e268 100644 --- a/drivers/tty/serial/mvebu-uart.c +++ b/drivers/tty/serial/mvebu-uart.c @@ -495,7 +495,6 @@ static void mvebu_uart_set_termios(struct uart_port *port, termios->c_iflag |= old->c_iflag & ~(INPCK | IGNPAR); termios->c_cflag &= CREAD | CBAUD; termios->c_cflag |= old->c_cflag & ~(CREAD | CBAUD); - termios->c_lflag = old->c_lflag; } spin_unlock_irqrestore(&port->lock, flags); diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c index 65ff669373d4..a1b3eb04cb32 100644 --- a/drivers/tty/serial/qcom_geni_serial.c +++ b/drivers/tty/serial/qcom_geni_serial.c @@ -1022,6 +1022,7 @@ static int qcom_geni_serial_probe(struct platform_device *pdev) struct qcom_geni_serial_port *port; struct uart_port *uport; struct resource *res; + int irq; if (pdev->dev.of_node) line = of_alias_get_id(pdev->dev.of_node, "serial"); @@ -1061,11 +1062,12 @@ static int qcom_geni_serial_probe(struct platform_device *pdev) port->rx_fifo_depth = DEF_FIFO_DEPTH_WORDS; port->tx_fifo_width = DEF_FIFO_WIDTH_BITS; - uport->irq = platform_get_irq(pdev, 0); - if (uport->irq < 0) { - dev_err(&pdev->dev, "Failed to get IRQ %d\n", uport->irq); - return uport->irq; + irq = platform_get_irq(pdev, 0); + if (irq < 0) { + dev_err(&pdev->dev, "Failed to get IRQ %d\n", irq); + return irq; } + uport->irq = irq; uport->private_data = &qcom_geni_console_driver; platform_set_drvdata(pdev, port); diff --git a/drivers/tty/serial/xilinx_uartps.c b/drivers/tty/serial/xilinx_uartps.c index abcb4d09a2d8..bd72dd843338 100644 --- a/drivers/tty/serial/xilinx_uartps.c +++ b/drivers/tty/serial/xilinx_uartps.c @@ -1181,7 +1181,7 @@ static int __init cdns_early_console_setup(struct earlycon_device *device, /* only set baud if specified on command line - otherwise * assume it has been initialized by a boot loader. */ - if (device->baud) { + if (port->uartclk && device->baud) { u32 cd = 0, bdiv = 0; u32 mr; int div8; |