diff options
Diffstat (limited to 'include/linux/ti_wilink_st.h')
| -rw-r--r-- | include/linux/ti_wilink_st.h | 27 |
1 files changed, 26 insertions, 1 deletions
diff --git a/include/linux/ti_wilink_st.h b/include/linux/ti_wilink_st.h index b004e557caa9..2ef4385da6bf 100644 --- a/include/linux/ti_wilink_st.h +++ b/include/linux/ti_wilink_st.h @@ -410,7 +410,28 @@ struct gps_event_hdr { u16 plen; } __attribute__ ((packed)); -/* platform data */ +/** + * struct ti_st_plat_data - platform data shared between ST driver and + * platform specific board file which adds the ST device. + * @nshutdown_gpio: Host's GPIO line to which chip's BT_EN is connected. + * @dev_name: The UART/TTY name to which chip is interfaced. (eg: /dev/ttyS1) + * @flow_cntrl: Should always be 1, since UART's CTS/RTS is used for PM + * purposes. + * @baud_rate: The baud rate supported by the Host UART controller, this will + * be shared across with the chip via a HCI VS command from User-Space Init + * Mgr application. + * @suspend: + * @resume: legacy PM routines hooked to platform specific board file, so as + * to take chip-host interface specific action. + * @chip_enable: + * @chip_disable: Platform/Interface specific mux mode setting, GPIO + * configuring, Host side PM disabling etc.. can be done here. + * @chip_asleep: + * @chip_awake: Chip specific deep sleep states is communicated to Host + * specific board-xx.c to take actions such as cut UART clocks when chip + * asleep or run host faster when chip awake etc.. + * + */ struct ti_st_plat_data { long nshutdown_gpio; unsigned char dev_name[UART_DEV_NAME_LEN]; /* uart name */ @@ -418,6 +439,10 @@ struct ti_st_plat_data { unsigned long baud_rate; int (*suspend)(struct platform_device *, pm_message_t); int (*resume)(struct platform_device *); + int (*chip_enable) (struct kim_data_s *); + int (*chip_disable) (struct kim_data_s *); + int (*chip_asleep) (struct kim_data_s *); + int (*chip_awake) (struct kim_data_s *); }; #endif /* TI_WILINK_ST_H */ |