summaryrefslogtreecommitdiffstats
path: root/drivers/net/fec.h
Commit message (Collapse)AuthorAgeFilesLines
* freescale: Move the Freescale driversJeff Kirsher2011-08-121-148/+0
| | | | | | | | | | | | | | | Move the Freescale drivers into drivers/net/ethernet/freescale/ and make the necessary Kconfig and Makefile changes. CC: Sandeep Gopalpet <sandeep.kumar@freescale.com> CC: Andy Fleming <afleming@freescale.com> CC: Shlomi Gridish <gridish@freescale.com> CC: Li Yang <leoli@freescale.com> CC: Pantelis Antoniou <pantelis.antoniou@gmail.com> CC: Vitaly Bordug <vbordug@ru.mvista.com> CC: Dan Malek <dmalek@jlc.net> CC: Sylvain Munaut <tnt@246tNt.com> Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
* Fix common misspellingsLucas De Marchi2011-03-311-2/+2
| | | | | | Fixes generated by 'codespell' and manually reviewed. Signed-off-by: Lucas De Marchi <lucas.demarchi@profusion.mobi>
* net/fec: add dual fec support for mx28Shawn Guo2011-01-091-2/+3
| | | | | | | | | | | | | | | | | | | | | | This patch is to add mx28 dual fec support. Here are some key notes for mx28 fec controller. - The mx28 fec controller naming ENET-MAC is a different IP from FEC used on other i.mx variants. But they are basically compatible on software interface, so it's possible to share the same driver. - ENET-MAC design on mx28 made an improper assumption that it runs on a big-endian system. As the result, driver has to swap every frame going to and coming from the controller. - The external phys can only be configured by fec0, which means fec1 can not work independently and both phys need to be configured by mii_bus attached on fec0. - ENET-MAC reset will get mac address registers reset too. - ENET-MAC MII/RMII mode and 10M/100M speed are configured differently FEC. - ETHER_EN bit must be set to get ENET-MAC interrupt work. Signed-off-by: Shawn Guo <shawn.guo@freescale.com> Signed-off-by: David S. Miller <davem@davemloft.net>
* fec: add support for PHY interface platform dataBaruch Siach2010-05-241-0/+2
| | | | | | | | | The i.MX25 PDK uses RMII to communicate with its PHY. This patch adds the ability to configure RMII, based on platform data. Signed-off-by: Baruch Siach <baruch@tkos.co.il> Acked-by: Greg Ungerer <gerg@uclinux.org> Signed-off-by: David S. Miller <davem@davemloft.net>
* fec: fix definition of 5272 version of FEC_X_DES_ACTIVE registerGreg Ungerer2009-07-061-1/+1
| | | | | | | | | | | | | fec: fix definition of 5272 version of FEC_X_DES_ACTIVE register The ColdFire 5272 FEC driver has a different register address map than other users of the FEC driver. And its definition of the FEC_X_DES_ACTIVE register is incorrect, it should be 0x14. The fec interface cannot transmit data with the old value. Signed-off-by: Greg Ungerer <gerg@uclinux.org> ---- Signed-off-by: David S. Miller <davem@davemloft.net>
* fec: remove extra ";" from definition namesGreg Ungerer2009-07-061-6/+6
| | | | | Signed-off-by: Greg Ungerer <gerg@uclinux.org> Signed-off-by: David S. Miller <davem@davemloft.net>
* fec: do not typedef struct typesSascha Hauer2009-04-161-4/+4
| | | | | Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de> Signed-off-by: David S. Miller <davem@davemloft.net>
* fec: switch to writel/readlSascha Hauer2009-04-161-73/+46
| | | | | Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de> Signed-off-by: David S. Miller <davem@davemloft.net>
* fec: Add support for Freescale MX27Sascha Hauer2009-02-011-2/+9
| | | | | | Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de> Acked-by: Greg Ungerer <gerg@uclinux.org> Signed-off-by: David S. Miller <davem@davemloft.net>
* m68knommu: fix ColdFire 5272 fec driver hash registersGreg Ungerer2008-05-011-2/+2
| | | | | | | | | Renamed the 5272 hash_table registers to match the "grp" hash_table registers of the other ColdFire parts. They are actually a group hash. The makes for consistent setup across all ColdFire parts. Signed-off-by: Greg Ungerer <gerg@uclinux.org> Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
* [PATCH] m68knommu: 532x FEC eth struct mapGreg Ungerer2006-06-251-1/+1
| | | | | | | | | | Specify the struct mapping used on the new Freescale 532x CPU family's FEC ethernet core. Patch submitted by Matt Waddel <Matt.Waddel@freescale.com>. Signed-off-by: Greg Ungerer <gerg@uclinux.org> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] m68knommu: FEC ethernet header support for the ColdFire 5208Greg Ungerer2005-11-071-5/+5
| | | | | | | | | Add support for the new 5208 ColdFire in the FEC ethernet header. Patch originally from Matt Waddel (from code originally written by Mike Lavender). Signed-off-by: Greg Ungerer <gerg@uclinux.com> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* [PATCH] m68knommu: FEC eth definitions support for the 523x Coldfire ↵Greg Ungerer2005-09-111-3/+4
| | | | | | | | | | processor family Add support for the FEC ethernet driver of the Freescale 523x processor family to the FEC header definitions. Signed-off-by: Greg Ungerer <gerg@uclinux.com> Signed-off-by: Linus Torvalds <torvalds@osdl.org>
* Linux-2.6.12-rc2v2.6.12-rc2Linus Torvalds2005-04-161-0/+164
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
generated by cgit v1.2.3 (git 2.25.1) at 2024-11-08 14:33:05 +0000