summaryrefslogtreecommitdiffstats
path: root/Documentation/devicetree/bindings/display/bridge/thine,thc63lvd1024.txt
blob: d17d1e5820d7a3994c029eb7d372cee47588bfc1 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
Thine Electronics THC63LVD1024 LVDS decoder
-------------------------------------------

The THC63LVD1024 is a dual link LVDS receiver designed to convert LVDS streams
to parallel data outputs. The chip supports single/dual input/output modes,
handling up to two LVDS input streams and up to two digital CMOS/TTL outputs.

Single or dual operation mode, output data mapping and DDR output modes are
configured through input signals and the chip does not expose any control bus.

Required properties:
- compatible: Shall be "thine,thc63lvd1024"
- vcc-supply: Power supply for TTL output, TTL CLOCKOUT signal, LVDS input,
  PPL and digital circuitry

Optional properties:
- powerdown-gpios: Power down GPIO signal, pin name "/PDWN". Active low
- oe-gpios: Output enable GPIO signal, pin name "OE". Active high

The THC63LVD1024 video port connections are modeled according
to OF graph bindings specified by Documentation/devicetree/bindings/graph.txt

Required video port nodes:
- port@0: First LVDS input port
- port@2: First digital CMOS/TTL parallel output

Optional video port nodes:
- port@1: Second LVDS input port
- port@3: Second digital CMOS/TTL parallel output

The device can operate in single-link mode or dual-link mode. In single-link
mode, all pixels are received on port@0, and port@1 shall not contain any
endpoint. In dual-link mode, even-numbered pixels are received on port@0 and
odd-numbered pixels on port@1, and both port@0 and port@1 shall contain
endpoints.

Example:
--------

	thc63lvd1024: lvds-decoder {
		compatible = "thine,thc63lvd1024";

		vcc-supply = <&reg_lvds_vcc>;
		powerdown-gpios = <&gpio4 15 GPIO_ACTIVE_LOW>;

		ports {
			#address-cells = <1>;
			#size-cells = <0>;

			port@0 {
				reg = <0>;

				lvds_dec_in_0: endpoint {
					remote-endpoint = <&lvds_out>;
				};
			};

			port@2{
				reg = <2>;

				lvds_dec_out_2: endpoint {
					remote-endpoint = <&adv7511_in>;
				};
			};
		};
	};