1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
|
/* SPDX-License-Identifier: GPL-2.0-only */
#ifndef AMD_BLOCK_ESPI_H
#define AMD_BLOCK_ESPI_H
#include <stdint.h>
#include <stddef.h>
/* eSPI MMIO base lives at an offset of 0x10000 from the address in SPI BAR. */
#define ESPI_OFFSET_FROM_BAR 0x10000
#define ESPI_DECODE 0x40
#define ESPI_DECODE_MMIO_RANGE_EN(range) (1 << (((range) & 3) + 12))
#define ESPI_DECODE_IO_RANGE_EN(range) (1 << (((range) & 3) + 8))
#define ESPI_DECODE_IO_0x80_EN (1 << 2)
#define ESPI_DECODE_IO_0X60_0X64_EN (1 << 1)
#define ESPI_DECODE_IO_0X2E_0X2F_EN (1 << 0)
#define ESPI_IO_BASE_OFFSET_REG0 0x44
#define ESPI_IO_BASE_OFFSET_REG1 0x48
#define ESPI_IO_RANGE_SIZE_OFFSET 0x4c
#define ESPI_MMIO_BASE_OFFSET_REG0 0x50
#define ESPI_MMIO_BASE_OFFSET_REG1 0x54
#define ESPI_MMIO_BASE_OFFSET_REG2 0x58
#define ESPI_MMIO_BASE_OFFSET_REG3 0x5C
#define ESPI_MMIO_OFFSET_SIZE_REG0 0x60
#define ESPI_MMIO_OFFSET_SIZE_REG1 0x64
#define ESPI_IO_RANGE_BASE(range) (ESPI_IO_BASE_OFFSET_REG0 + ((range) & 3) * 2)
#define ESPI_IO_RANGE_SIZE(range) (ESPI_IO_RANGE_SIZE_OFFSET + ((range) & 3))
#define ESPI_MMIO_RANGE_BASE(range) (ESPI_MMIO_BASE_OFFSET_REG0 + ((range) & 3) * 4)
#define ESPI_MMIO_RANGE_SIZE(range) (ESPI_MMIO_OFFSET_SIZE_REG0 + ((range) & 3) * 2)
#define ESPI_GENERIC_IO_WIN_COUNT 4
#define ESPI_GENERIC_IO_MAX_WIN_SIZE 0x100
#define ESPI_GENERIC_MMIO_WIN_COUNT 4
#define ESPI_GENERIC_MMIO_MAX_WIN_SIZE 0x10000
#define ESPI_SLAVE0_CONFIG 0x68
#define ESPI_CRC_CHECKING_EN (1 << 31)
#define ESPI_ALERT_MODE (1 << 30)
#define ESPI_IO_MODE_SHIFT 28
#define ESPI_IO_MODE_MASK (0x3 << ESPI_IO_MODE_SHIFT)
#define ESPI_IO_MODE_VALUE(x) ((x) << ESPI_IO_MODE_SHIFT)
#define ESPI_OP_FREQ_SHIFT 25
#define ESPI_OP_FREQ_MASK (0x7 << ESPI_OP_FREQ_SHIFT)
#define ESPI_OP_FREQ_VALUE(x) ((x) << ESPI_OP_FREQ_SHIFT)
#define ESPI_PERIPH_CH_EN (1 << 3)
#define ESPI_VW_CH_EN (1 << 2)
#define ESPI_OOB_CH_EN (1 << 1)
#define ESPI_FLASH_CH_EN (1 << 0)
/* Virtual wire interrupt polarity. eSPI interrupts are active level high signals. The
polarity register inverts the incoming signal if the associated bit with the irq is
0. */
#define ESPI_VW_IRQ_LEVEL_HIGH(x) (1 << (x))
#define ESPI_VW_IRQ_LEVEL_LOW(x) (0 << (x))
#define ESPI_VW_IRQ_EDGE_HIGH(x) (1 << (x))
#define ESPI_VW_IRQ_EDGE_LOW(x) (0 << (x))
enum espi_io_mode {
ESPI_IO_MODE_SINGLE = ESPI_IO_MODE_VALUE(0),
ESPI_IO_MODE_DUAL = ESPI_IO_MODE_VALUE(1),
ESPI_IO_MODE_QUAD = ESPI_IO_MODE_VALUE(2),
};
enum espi_op_freq {
ESPI_OP_FREQ_16_MHZ = ESPI_OP_FREQ_VALUE(0),
ESPI_OP_FREQ_33_MHZ = ESPI_OP_FREQ_VALUE(1),
ESPI_OP_FREQ_66_MHZ = ESPI_OP_FREQ_VALUE(2),
};
struct espi_config {
/* Bitmap for standard IO decodes. Use ESPI_DECODE_IO_* above. */
uint32_t std_io_decode_bitmap;
struct {
uint16_t base;
size_t size;
} generic_io_range[ESPI_GENERIC_IO_WIN_COUNT];
/* Slave configuration parameters */
enum espi_io_mode io_mode;
enum espi_op_freq op_freq_mhz;
uint32_t crc_check_enable:1;
uint32_t dedicated_alert_pin:1;
uint32_t periph_ch_en:1;
uint32_t vw_ch_en:1;
uint32_t oob_ch_en:1;
uint32_t flash_ch_en:1;
uint32_t subtractive_decode:1;
/* Use ESPI_VW_IRQ_* above */
uint32_t vw_irq_polarity;
};
/*
* Open I/O window using the provided base and size.
* Return value: 0 = success, -1 = error.
*/
int espi_open_io_window(uint16_t base, size_t size);
/*
* Open MMIO window using the provided base and size.
* Return value: 0 = success, -1 = error.
*/
int espi_open_mmio_window(uint32_t base, size_t size);
/*
* In cases where eSPI BAR is statically provided by SoC, use that BAR instead of reading
* SPIBASE. This is required for cases where verstage runs on PSP.
*/
void espi_update_static_bar(uintptr_t bar);
/*
* Perform eSPI connection setup to the slave. Currently, this supports slave0 only.
* Returns 0 on success and -1 on error.
*/
int espi_setup(void);
#endif /* AMD_BLOCK_ESPI_H */
|
