diff options
| -rw-r--r-- | EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118Dxe.c | 5 | ||||
| -rw-r--r-- | EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118DxeUtil.c | 16 |
2 files changed, 0 insertions, 21 deletions
diff --git a/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118Dxe.c b/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118Dxe.c index bef34c2e9c..8af23df394 100644 --- a/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118Dxe.c +++ b/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118Dxe.c @@ -307,8 +307,6 @@ SnpInitialize ( // Write the current configuration to the register
Lan9118MmioWrite32 (LAN9118_PMT_CTRL, PmConf);
- gBS->Stall (LAN9118_STALL);
- gBS->Stall (LAN9118_STALL);
// Configure GPIO and HW
Status = ConfigureHardware (HW_CONF_USE_LEDS, Snp);
@@ -431,7 +429,6 @@ SnpReset ( // Write the current configuration to the register
Lan9118MmioWrite32 (LAN9118_PMT_CTRL, PmConf);
- gBS->Stall (LAN9118_STALL);
// Reactivate the LEDs
Status = ConfigureHardware (HW_CONF_USE_LEDS, Snp);
@@ -446,7 +443,6 @@ SnpReset ( HwConf |= HW_CFG_TX_FIFO_SIZE(gTxBuffer); // assign size chosen in SnpInitialize
Lan9118MmioWrite32 (LAN9118_HW_CFG, HwConf); // Write the conf
- gBS->Stall (LAN9118_STALL);
}
// Enable the receiver and transmitter and clear their contents
@@ -701,7 +697,6 @@ SnpReceiveFilters ( // Write the options to the MAC_CSR
//
IndirectMACWrite32 (INDIRECT_MAC_INDEX_CR, MacCSRValue);
- gBS->Stall (LAN9118_STALL);
//
// If we have to retrieve something, start packet reception.
diff --git a/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118DxeUtil.c b/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118DxeUtil.c index 61f11b6e27..50c004d728 100644 --- a/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118DxeUtil.c +++ b/EmbeddedPkg/Drivers/Lan9118Dxe/Lan9118DxeUtil.c @@ -284,7 +284,6 @@ IndirectEEPROMRead32 ( // Write to Eeprom command register
Lan9118MmioWrite32 (LAN9118_E2P_CMD, EepromCmd);
- gBS->Stall (LAN9118_STALL);
// Wait until operation has completed
while (Lan9118MmioRead32 (LAN9118_E2P_CMD) & E2P_EPC_BUSY);
@@ -332,7 +331,6 @@ IndirectEEPROMWrite32 ( // Write to Eeprom command register
Lan9118MmioWrite32 (LAN9118_E2P_CMD, EepromCmd);
- gBS->Stall (LAN9118_STALL);
// Wait until operation has completed
while (Lan9118MmioRead32 (LAN9118_E2P_CMD) & E2P_EPC_BUSY);
@@ -410,7 +408,6 @@ Lan9118Initialize ( if (((Lan9118MmioRead32 (LAN9118_PMT_CTRL) & MPTCTRL_PM_MODE_MASK) >> 12) != 0) {
DEBUG ((DEBUG_NET, "Waking from reduced power state.\n"));
Lan9118MmioWrite32 (LAN9118_BYTE_TEST, 0xFFFFFFFF);
- gBS->Stall (LAN9118_STALL);
}
// Check that device is active
@@ -495,7 +492,6 @@ SoftReset ( // Write the configuration
Lan9118MmioWrite32 (LAN9118_HW_CFG, HwConf);
- gBS->Stall (LAN9118_STALL);
// Wait for reset to complete
while (Lan9118MmioRead32 (LAN9118_HW_CFG) & HWCFG_SRST) {
@@ -590,7 +586,6 @@ ConfigureHardware ( // Write the configuration
Lan9118MmioWrite32 (LAN9118_GPIO_CFG, GpioConf);
- gBS->Stall (LAN9118_STALL);
}
return EFI_SUCCESS;
@@ -719,7 +714,6 @@ StopTx ( TxCfg = Lan9118MmioRead32 (LAN9118_TX_CFG);
TxCfg |= TXCFG_TXS_DUMP | TXCFG_TXD_DUMP;
Lan9118MmioWrite32 (LAN9118_TX_CFG, TxCfg);
- gBS->Stall (LAN9118_STALL);
}
// Check if already stopped
@@ -738,7 +732,6 @@ StopTx ( if (TxCfg & TXCFG_TX_ON) {
TxCfg |= TXCFG_STOP_TX;
Lan9118MmioWrite32 (LAN9118_TX_CFG, TxCfg);
- gBS->Stall (LAN9118_STALL);
// Wait for Tx to finish transmitting
while (Lan9118MmioRead32 (LAN9118_TX_CFG) & TXCFG_STOP_TX);
@@ -773,7 +766,6 @@ StopRx ( RxCfg = Lan9118MmioRead32 (LAN9118_RX_CFG);
RxCfg |= RXCFG_RX_DUMP;
Lan9118MmioWrite32 (LAN9118_RX_CFG, RxCfg);
- gBS->Stall (LAN9118_STALL);
while (Lan9118MmioRead32 (LAN9118_RX_CFG) & RXCFG_RX_DUMP);
}
@@ -799,28 +791,23 @@ StartTx ( TxCfg = Lan9118MmioRead32 (LAN9118_TX_CFG);
TxCfg |= TXCFG_TXS_DUMP | TXCFG_TXD_DUMP;
Lan9118MmioWrite32 (LAN9118_TX_CFG, TxCfg);
- gBS->Stall (LAN9118_STALL);
}
// Check if tx was started from MAC and enable if not
if (Flags & START_TX_MAC) {
MacCsr = IndirectMACRead32 (INDIRECT_MAC_INDEX_CR);
- gBS->Stall (LAN9118_STALL);
if ((MacCsr & MACCR_TX_EN) == 0) {
MacCsr |= MACCR_TX_EN;
IndirectMACWrite32 (INDIRECT_MAC_INDEX_CR, MacCsr);
- gBS->Stall (LAN9118_STALL);
}
}
// Check if tx was started from TX_CFG and enable if not
if (Flags & START_TX_CFG) {
TxCfg = Lan9118MmioRead32 (LAN9118_TX_CFG);
- gBS->Stall (LAN9118_STALL);
if ((TxCfg & TXCFG_TX_ON) == 0) {
TxCfg |= TXCFG_TX_ON;
Lan9118MmioWrite32 (LAN9118_TX_CFG, TxCfg);
- gBS->Stall (LAN9118_STALL);
}
}
@@ -850,14 +837,12 @@ StartRx ( RxCfg = Lan9118MmioRead32 (LAN9118_RX_CFG);
RxCfg |= RXCFG_RX_DUMP;
Lan9118MmioWrite32 (LAN9118_RX_CFG, RxCfg);
- gBS->Stall (LAN9118_STALL);
while (Lan9118MmioRead32 (LAN9118_RX_CFG) & RXCFG_RX_DUMP);
}
MacCsr |= MACCR_RX_EN;
IndirectMACWrite32 (INDIRECT_MAC_INDEX_CR, MacCsr);
- gBS->Stall (LAN9118_STALL);
}
return EFI_SUCCESS;
@@ -1047,7 +1032,6 @@ ChangeFifoAllocation ( HwConf &= ~(0xF0000);
HwConf |= ((TxFifoOption & 0xF) << 16);
Lan9118MmioWrite32 (LAN9118_HW_CFG, HwConf);
- gBS->Stall (LAN9118_STALL);
return EFI_SUCCESS;
}
|