diff options
Diffstat (limited to 'Documentation/devicetree/bindings/spmi/qcom,spmi-pmic-arb.txt')
-rw-r--r-- | Documentation/devicetree/bindings/spmi/qcom,spmi-pmic-arb.txt | 65 |
1 files changed, 0 insertions, 65 deletions
diff --git a/Documentation/devicetree/bindings/spmi/qcom,spmi-pmic-arb.txt b/Documentation/devicetree/bindings/spmi/qcom,spmi-pmic-arb.txt deleted file mode 100644 index ca645e21fe47..000000000000 --- a/Documentation/devicetree/bindings/spmi/qcom,spmi-pmic-arb.txt +++ /dev/null @@ -1,65 +0,0 @@ -Qualcomm SPMI Controller (PMIC Arbiter) - -The SPMI PMIC Arbiter is found on Snapdragon chipsets. It is an SPMI -controller with wrapping arbitration logic to allow for multiple on-chip -devices to control a single SPMI master. - -The PMIC Arbiter can also act as an interrupt controller, providing interrupts -to slave devices. - -See Documentation/devicetree/bindings/spmi/spmi.yaml for the generic SPMI -controller binding requirements for child nodes. - -See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt for -generic interrupt controller binding documentation. - -Required properties: -- compatible : should be "qcom,spmi-pmic-arb". -- reg-names : must contain: - "core" - core registers - "intr" - interrupt controller registers - "cnfg" - configuration registers - Registers used only for V2 PMIC Arbiter: - "chnls" - tx-channel per virtual slave registers. - "obsrvr" - rx-channel (called observer) per virtual slave registers. - -- reg : address + size pairs describing the PMIC arb register sets; order must - correspond with the order of entries in reg-names -- #address-cells : must be set to 2 -- #size-cells : must be set to 0 -- qcom,ee : indicates the active Execution Environment identifier (0-5) -- qcom,channel : which of the PMIC Arb provided channels to use for accesses (0-5) -- interrupts : interrupt list for the PMIC Arb controller, must contain a - single interrupt entry for the peripheral interrupt -- interrupt-names : corresponding interrupt names for the interrupts - listed in the 'interrupts' property, must contain: - "periph_irq" - summary interrupt for PMIC peripherals -- interrupt-controller : boolean indicator that the PMIC arbiter is an interrupt controller -- #interrupt-cells : must be set to 4. Interrupts are specified as a 4-tuple: - cell 1: slave ID for the requested interrupt (0-15) - cell 2: peripheral ID for requested interrupt (0-255) - cell 3: the requested peripheral interrupt (0-7) - cell 4: interrupt flags indicating level-sense information, as defined in - dt-bindings/interrupt-controller/irq.h - -Example: - - spmi { - compatible = "qcom,spmi-pmic-arb"; - reg-names = "core", "intr", "cnfg"; - reg = <0xfc4cf000 0x1000>, - <0xfc4cb000 0x1000>, - <0xfc4ca000 0x1000>; - - interrupt-names = "periph_irq"; - interrupts = <0 190 0>; - - qcom,ee = <0>; - qcom,channel = <0>; - - #address-cells = <2>; - #size-cells = <0>; - - interrupt-controller; - #interrupt-cells = <4>; - }; |