diff options
Diffstat (limited to 'arch/riscv/Kconfig')
| -rw-r--r-- | arch/riscv/Kconfig | 118 |
1 files changed, 97 insertions, 21 deletions
diff --git a/arch/riscv/Kconfig b/arch/riscv/Kconfig index 5b182d1c196c..348c0fa1fc8c 100644 --- a/arch/riscv/Kconfig +++ b/arch/riscv/Kconfig @@ -12,6 +12,7 @@ config 32BIT config RISCV def_bool y + select ARCH_DMA_DEFAULT_COHERENT select ARCH_ENABLE_HUGEPAGE_MIGRATION if HUGETLB_PAGE && MIGRATION select ARCH_ENABLE_SPLIT_PMD_PTLOCK if PGTABLE_LEVELS > 2 select ARCH_ENABLE_THP_MIGRATION if TRANSPARENT_HUGEPAGE @@ -33,6 +34,7 @@ config RISCV select ARCH_HAS_STRICT_MODULE_RWX if MMU && !XIP_KERNEL select ARCH_HAS_TICK_BROADCAST if GENERIC_CLOCKEVENTS_BROADCAST select ARCH_HAS_UBSAN_SANITIZE_ALL + select ARCH_HAS_VDSO_DATA select ARCH_OPTIONAL_KERNEL_RWX if ARCH_HAS_STRICT_KERNEL_RWX select ARCH_OPTIONAL_KERNEL_RWX_DEFAULT select ARCH_STACKWALK @@ -44,25 +46,28 @@ config RISCV select ARCH_USE_QUEUED_RWLOCKS select ARCH_WANT_DEFAULT_TOPDOWN_MMAP_LAYOUT if MMU select ARCH_WANT_FRAME_POINTERS - select ARCH_WANT_GENERAL_HUGETLB - select ARCH_WANT_HUGETLB_PAGE_OPTIMIZE_VMEMMAP + select ARCH_WANT_GENERAL_HUGETLB if !RISCV_ISA_SVNAPOT select ARCH_WANT_HUGE_PMD_SHARE if 64BIT select ARCH_WANT_LD_ORPHAN_WARN if !XIP_KERNEL + select ARCH_WANT_OPTIMIZE_VMEMMAP select ARCH_WANTS_THP_SWAP if HAVE_ARCH_TRANSPARENT_HUGEPAGE select BINFMT_FLAT_NO_DATA_START_OFFSET if !MMU select BUILDTIME_TABLE_SORT if MMU select CLINT_TIMER if !MMU select CLONE_BACKWARDS select COMMON_CLK - select CPU_PM if CPU_IDLE + select CPU_PM if CPU_IDLE || HIBERNATION select EDAC_SUPPORT select GENERIC_ARCH_TOPOLOGY select GENERIC_ATOMIC64 if !64BIT select GENERIC_CLOCKEVENTS_BROADCAST if SMP select GENERIC_EARLY_IOREMAP + select GENERIC_ENTRY select GENERIC_GETTIMEOFDAY if HAVE_GENERIC_VDSO select GENERIC_IDLE_POLL_SETUP select GENERIC_IOREMAP if MMU + select GENERIC_IRQ_IPI if SMP + select GENERIC_IRQ_IPI_MUX if SMP select GENERIC_IRQ_MULTI_HANDLER select GENERIC_IRQ_SHOW select GENERIC_IRQ_SHOW_LEVEL @@ -74,6 +79,7 @@ config RISCV select GENERIC_TIME_VSYSCALL if MMU && 64BIT select GENERIC_VDSO_TIME_NS if HAVE_GENERIC_VDSO select HARDIRQS_SW_RESEND + select HAS_IOPORT if MMU select HAVE_ARCH_AUDITSYSCALL select HAVE_ARCH_HUGE_VMALLOC if HAVE_ARCH_HUGE_VMAP select HAVE_ARCH_HUGE_VMAP if MMU && 64BIT && !XIP_KERNEL @@ -118,14 +124,15 @@ config RISCV select HAVE_SYSCALL_TRACEPOINTS select IRQ_DOMAIN select IRQ_FORCED_THREADING + select KASAN_VMALLOC if KASAN select MODULES_USE_ELF_RELA if MODULES select MODULE_SECTIONS if MODULES select OF - select OF_DMA_DEFAULT_COHERENT select OF_EARLY_FLATTREE select OF_IRQ select PCI_DOMAINS_GENERIC if PCI select PCI_MSI if PCI + select RISCV_ALTERNATIVE if !XIP_KERNEL select RISCV_INTC select RISCV_TIMER if RISCV_SBI select SIFIVE_PLIC @@ -135,12 +142,23 @@ config RISCV select TRACE_IRQFLAGS_SUPPORT select UACCESS_MEMCPY if !MMU select ZONE_DMA32 if 64BIT - select HAVE_DYNAMIC_FTRACE if !XIP_KERNEL && MMU && $(cc-option,-fpatchable-function-entry=8) + select HAVE_DYNAMIC_FTRACE if !XIP_KERNEL && MMU && (CLANG_SUPPORTS_DYNAMIC_FTRACE || GCC_SUPPORTS_DYNAMIC_FTRACE) select HAVE_DYNAMIC_FTRACE_WITH_REGS if HAVE_DYNAMIC_FTRACE select HAVE_FTRACE_MCOUNT_RECORD if !XIP_KERNEL select HAVE_FUNCTION_GRAPH_TRACER select HAVE_FUNCTION_TRACER if !XIP_KERNEL && !PREEMPTION +config CLANG_SUPPORTS_DYNAMIC_FTRACE + def_bool CC_IS_CLANG + # https://github.com/llvm/llvm-project/commit/6ab8927931851bb42b2c93a00801dc499d7d9b1e + depends on CLANG_VERSION >= 130000 + # https://github.com/ClangBuiltLinux/linux/issues/1817 + depends on AS_IS_GNU || (AS_IS_LLVM && (LD_IS_LLD || LD_VERSION >= 23600)) + +config GCC_SUPPORTS_DYNAMIC_FTRACE + def_bool CC_IS_GCC + depends on $(cc-option,-fpatchable-function-entry=8) + config ARCH_MMAP_RND_BITS_MIN default 18 if 64BIT default 8 @@ -177,8 +195,8 @@ config MMU config PAGE_OFFSET hex - default 0xC0000000 if 32BIT - default 0x80000000 if 64BIT && !MMU + default 0xC0000000 if 32BIT && MMU + default 0x80000000 if !MMU default 0xff60000000000000 if 64BIT config KASAN_SHADOW_OFFSET @@ -245,7 +263,7 @@ config AS_HAS_INSN def_bool $(as-instr,.insn r 51$(comma) 0$(comma) 0$(comma) t0$(comma) t0$(comma) zero) source "arch/riscv/Kconfig.socs" -source "arch/riscv/Kconfig.erratas" +source "arch/riscv/Kconfig.errata" menu "Platform type" @@ -279,7 +297,6 @@ config ARCH_RV32I select GENERIC_LIB_ASHRDI3 select GENERIC_LIB_LSHRDI3 select GENERIC_LIB_UCMPDI2 - select MMU config ARCH_RV64I bool "RV64I" @@ -320,6 +337,14 @@ config SMP If you don't know what to do here, say N. +config SCHED_MC + bool "Multi-core scheduler support" + depends on SMP + help + Multi-core scheduler support improves the CPU scheduler's decision + making when dealing with multi-core CPU chips at a cost of slightly + increased overhead in some places. If unsure say N here. + config NR_CPUS int "Maximum number of CPUs (2-512)" depends on SMP @@ -378,9 +403,9 @@ config RISCV_ALTERNATIVE depends on !XIP_KERNEL help This Kconfig allows the kernel to automatically patch the - errata required by the execution platform at run time. The - code patching is performed once in the boot stages. It means - that the overhead from this mechanism is just taken once. + erratum or cpufeature required by the execution platform at run + time. The code patching overhead is minimal, as it's only done + once at boot and once on each module load. config RISCV_ALTERNATIVE_EARLY bool @@ -398,14 +423,32 @@ config RISCV_ISA_C If you don't know what to do here, say Y. +config RISCV_ISA_SVNAPOT + bool "Svnapot extension support for supervisor mode NAPOT pages" + depends on 64BIT && MMU + depends on RISCV_ALTERNATIVE + default y + help + Allow kernel to detect the Svnapot ISA-extension dynamically at boot + time and enable its usage. + + The Svnapot extension is used to mark contiguous PTEs as a range + of contiguous virtual-to-physical translations for a naturally + aligned power-of-2 (NAPOT) granularity larger than the base 4KB page + size. When HUGETLBFS is also selected this option unconditionally + allocates some memory for each NAPOT page size supported by the kernel. + When optimizing for low memory consumption and for platforms without + the Svnapot extension, it may be better to say N here. + + If you don't know what to do here, say Y. + config RISCV_ISA_SVPBMT - bool "SVPBMT extension support" + bool "Svpbmt extension support for supervisor mode page-based memory types" depends on 64BIT && MMU - depends on !XIP_KERNEL + depends on RISCV_ALTERNATIVE default y - select RISCV_ALTERNATIVE help - Adds support to dynamically detect the presence of the SVPBMT + Adds support to dynamically detect the presence of the Svpbmt ISA-extension (Supervisor-mode: page-based memory types) and enable its usage. @@ -413,7 +456,7 @@ config RISCV_ISA_SVPBMT that indicate the cacheability, idempotency, and ordering properties for access to that page. - The SVPBMT extension is only available on 64Bit cpus. + The Svpbmt extension is only available on 64-bit cpus. If you don't know what to do here, say Y. @@ -428,8 +471,8 @@ config TOOLCHAIN_HAS_ZBB config RISCV_ISA_ZBB bool "Zbb extension support for bit manipulation instructions" depends on TOOLCHAIN_HAS_ZBB - depends on !XIP_KERNEL && MMU - select RISCV_ALTERNATIVE + depends on MMU + depends on RISCV_ALTERNATIVE default y help Adds support to dynamically detect the presence of the ZBB @@ -443,9 +486,9 @@ config RISCV_ISA_ZBB config RISCV_ISA_ZICBOM bool "Zicbom extension support for non-coherent DMA operation" - depends on !XIP_KERNEL && MMU + depends on MMU + depends on RISCV_ALTERNATIVE default y - select RISCV_ALTERNATIVE select RISCV_DMA_NONCOHERENT help Adds support to dynamically detect the presence of the ZICBOM @@ -457,6 +500,19 @@ config RISCV_ISA_ZICBOM If you don't know what to do here, say Y. +config RISCV_ISA_ZICBOZ + bool "Zicboz extension support for faster zeroing of memory" + depends on MMU + depends on RISCV_ALTERNATIVE + default y + help + Enable the use of the Zicboz extension (cbo.zero instruction) + when available. + + The Zicboz extension is used for faster zeroing of memory. + + If you don't know what to do here, say Y. + config TOOLCHAIN_HAS_ZIHINTPAUSE bool default y @@ -583,6 +639,20 @@ config COMPAT If you want to execute 32-bit userspace applications, say Y. +config RELOCATABLE + bool "Build a relocatable kernel" + depends on MMU && 64BIT && !XIP_KERNEL + help + This builds a kernel as a Position Independent Executable (PIE), + which retains all relocation metadata required to relocate the + kernel binary at runtime to a different virtual address than the + address it was linked at. + Since RISCV uses the RELA relocation format, this requires a + relocation pass at runtime even if the kernel is loaded at the + same address it was linked at. + + If unsure, say N. + endmenu # "Kernel features" menu "Boot options" @@ -729,6 +799,12 @@ menu "Power management options" source "kernel/power/Kconfig" +config ARCH_HIBERNATION_POSSIBLE + def_bool y + +config ARCH_HIBERNATION_HEADER + def_bool HIBERNATION + endmenu # "Power management options" menu "CPU Power Management" |