1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
|
* Rockchip rk3399 DMC(Dynamic Memory Controller) device
Required properties:
- compatible: Must be "rockchip,rk3399-dmc".
- devfreq-events: Node to get DDR loading, Refer to
Documentation/devicetree/bindings/devfreq/
rockchip-dfi.txt
- interrupts: The interrupt number to the CPU. The interrupt
specifier format depends on the interrupt controller.
It should be DCF interrupts, when DDR dvfs finish,
it will happen.
- clocks: Phandles for clock specified in "clock-names" property
- clock-names : The name of clock used by the DFI, must be
"pclk_ddr_mon";
- operating-points-v2: Refer to Documentation/devicetree/bindings/opp/opp.txt
for details.
- center-supply: DMC supply node.
- status: Marks the node enabled/disabled.
Following properties are ddr timing:
- rockchip,dram_speed_bin : Value reference include/dt-bindings/clock/ddr.h,
it select ddr3 cl-trp-trcd type, default value
"DDR3_DEFAULT".it must selected according to
"Speed Bin" in ddr3 datasheet, DO NOT use
smaller "Speed Bin" than ddr3 exactly is.
- rockchip,pd_idle : Config the PD_IDLE value, defined the power-down
idle period, memories are places into power-down
mode if bus is idle for PD_IDLE DFI clocks.
- rockchip,sr_idle : Configure the SR_IDLE value, defined the
selfrefresh idle period, memories are places
into self-refresh mode if bus is idle for
SR_IDLE*1024 DFI clocks (DFI clocks freq is
half of dram's clocks), defaule value is "0".
- rockchip,sr_mc_gate_idle : Defined the self-refresh with memory and
controller clock gating idle period, memories
are places into self-refresh mode and memory
controller clock arg gating if bus is idle for
sr_mc_gate_idle*1024 DFI clocks.
- rockchip,srpd_lite_idle : Defined the self-refresh power down idle
period, memories are places into self-refresh
power down mode if bus is idle for
srpd_lite_idle*1024 DFI clocks. This parameter
is for LPDDR4 only.
- rockchip,standby_idle : Defined the standby idle period, memories are
places into self-refresh than controller, pi,
phy and dram clock will gating if bus is idle
for standby_idle * DFI clocks.
- rockchip,dram_dll_disb_freq : It's defined the DDR3 dll bypass frequency in
MHz, when ddr freq less than DRAM_DLL_DISB_FREQ,
ddr3 dll will bypssed note: if dll was bypassed,
the odt also stop working.
- rockchip,phy_dll_disb_freq : Defined the PHY dll bypass frequency in
MHz (Mega Hz), when ddr freq less than
DRAM_DLL_DISB_FREQ, phy dll will bypssed.
note: phy dll and phy odt are independent.
- rockchip,ddr3_odt_disb_freq : When dram type is DDR3, this parameter defined
the odt disable frequency in MHz (Mega Hz),
when ddr frequency less then ddr3_odt_disb_freq,
the odt on dram side and controller side are
both disabled.
- rockchip,ddr3_drv : When dram type is DDR3, this parameter define
the dram side driver stength in ohm, default
value is DDR3_DS_40ohm.
- rockchip,ddr3_odt : When dram type is DDR3, this parameter define
the dram side ODT stength in ohm, default value
is DDR3_ODT_120ohm.
- rockchip,phy_ddr3_ca_drv : When dram type is DDR3, this parameter define
the phy side CA line(incluing command line,
address line and clock line) driver strength.
Default value is PHY_DRV_ODT_40.
- rockchip,phy_ddr3_dq_drv : When dram type is DDR3, this parameter define
the phy side DQ line(incluing DQS/DQ/DM line)
driver strength. default value is PHY_DRV_ODT_40.
- rockchip,phy_ddr3_odt : When dram type is DDR3, this parameter define the
phy side odt strength, default value is
PHY_DRV_ODT_240.
- rockchip,lpddr3_odt_disb_freq : When dram type is LPDDR3, this parameter defined
then odt disable frequency in MHz (Mega Hz),
when ddr frequency less then ddr3_odt_disb_freq,
the odt on dram side and controller side are
both disabled.
- rockchip,lpddr3_drv : When dram type is LPDDR3, this parameter define
the dram side driver stength in ohm, default
value is LP3_DS_34ohm.
- rockchip,lpddr3_odt : When dram type is LPDDR3, this parameter define
the dram side ODT stength in ohm, default value
is LP3_ODT_240ohm.
- rockchip,phy_lpddr3_ca_drv : When dram type is LPDDR3, this parameter define
the phy side CA line(incluing command line,
address line and clock line) driver strength.
default value is PHY_DRV_ODT_40.
- rockchip,phy_lpddr3_dq_drv : When dram type is LPDDR3, this parameter define
the phy side DQ line(incluing DQS/DQ/DM line)
driver strength. default value is
PHY_DRV_ODT_40.
- rockchip,phy_lpddr3_odt : When dram type is LPDDR3, this parameter define
the phy side odt strength, default value is
PHY_DRV_ODT_240.
- rockchip,lpddr4_odt_disb_freq : When dram type is LPDDR4, this parameter
defined the odt disable frequency in
MHz (Mega Hz), when ddr frequency less then
ddr3_odt_disb_freq, the odt on dram side and
controller side are both disabled.
- rockchip,lpddr4_drv : When dram type is LPDDR4, this parameter define
the dram side driver stength in ohm, default
value is LP4_PDDS_60ohm.
- rockchip,lpddr4_dq_odt : When dram type is LPDDR4, this parameter define
the dram side ODT on dqs/dq line stength in ohm,
default value is LP4_DQ_ODT_40ohm.
- rockchip,lpddr4_ca_odt : When dram type is LPDDR4, this parameter define
the dram side ODT on ca line stength in ohm,
default value is LP4_CA_ODT_40ohm.
- rockchip,phy_lpddr4_ca_drv : When dram type is LPDDR4, this parameter define
the phy side CA line(incluing command address
line) driver strength. default value is
PHY_DRV_ODT_40.
- rockchip,phy_lpddr4_ck_cs_drv : When dram type is LPDDR4, this parameter define
the phy side clock line and cs line driver
strength. default value is PHY_DRV_ODT_80.
- rockchip,phy_lpddr4_dq_drv : When dram type is LPDDR4, this parameter define
the phy side DQ line(incluing DQS/DQ/DM line)
driver strength. default value is PHY_DRV_ODT_80.
- rockchip,phy_lpddr4_odt : When dram type is LPDDR4, this parameter define
the phy side odt strength, default value is
PHY_DRV_ODT_60.
Example:
dmc_opp_table: dmc_opp_table {
compatible = "operating-points-v2";
opp00 {
opp-hz = /bits/ 64 <300000000>;
opp-microvolt = <900000>;
};
opp01 {
opp-hz = /bits/ 64 <666000000>;
opp-microvolt = <900000>;
};
};
dmc: dmc {
compatible = "rockchip,rk3399-dmc";
devfreq-events = <&dfi>;
interrupts = <GIC_SPI 1 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&cru SCLK_DDRCLK>;
clock-names = "dmc_clk";
operating-points-v2 = <&dmc_opp_table>;
center-supply = <&ppvar_centerlogic>;
upthreshold = <15>;
downdifferential = <10>;
rockchip,ddr3_speed_bin = <21>;
rockchip,pd_idle = <0x40>;
rockchip,sr_idle = <0x2>;
rockchip,sr_mc_gate_idle = <0x3>;
rockchip,srpd_lite_idle = <0x4>;
rockchip,standby_idle = <0x2000>;
rockchip,dram_dll_dis_freq = <300>;
rockchip,phy_dll_dis_freq = <125>;
rockchip,auto_pd_dis_freq = <666>;
rockchip,ddr3_odt_dis_freq = <333>;
rockchip,ddr3_drv = <DDR3_DS_40ohm>;
rockchip,ddr3_odt = <DDR3_ODT_120ohm>;
rockchip,phy_ddr3_ca_drv = <PHY_DRV_ODT_40>;
rockchip,phy_ddr3_dq_drv = <PHY_DRV_ODT_40>;
rockchip,phy_ddr3_odt = <PHY_DRV_ODT_240>;
rockchip,lpddr3_odt_dis_freq = <333>;
rockchip,lpddr3_drv = <LP3_DS_34ohm>;
rockchip,lpddr3_odt = <LP3_ODT_240ohm>;
rockchip,phy_lpddr3_ca_drv = <PHY_DRV_ODT_40>;
rockchip,phy_lpddr3_dq_drv = <PHY_DRV_ODT_40>;
rockchip,phy_lpddr3_odt = <PHY_DRV_ODT_240>;
rockchip,lpddr4_odt_dis_freq = <333>;
rockchip,lpddr4_drv = <LP4_PDDS_60ohm>;
rockchip,lpddr4_dq_odt = <LP4_DQ_ODT_40ohm>;
rockchip,lpddr4_ca_odt = <LP4_CA_ODT_40ohm>;
rockchip,phy_lpddr4_ca_drv = <PHY_DRV_ODT_40>;
rockchip,phy_lpddr4_ck_cs_drv = <PHY_DRV_ODT_80>;
rockchip,phy_lpddr4_dq_drv = <PHY_DRV_ODT_80>;
rockchip,phy_lpddr4_odt = <PHY_DRV_ODT_60>;
};
|
